Quote:
Originally Posted by waterman
I installed a CC on a friends Z06. The blower is easy to lift. Just make sure that all TB plumbing, vacuum and electrical lines are clear, including the strain reliefs for your injector/coil lines. Slack the tensioner and remove drive belt from the supercharger pulley and use the SC pulley to lift.
If everything is clear, it's an easy lift. Remember that you are only angling the SC enough to access PCV.
|
You can grab it by the supercharger pulley and not damage it? That s great to know ! Thanks ! Did you have to grind down the new PCV like the feller in the Install video did?
Quote:
Originally Posted by kwav8r
I used a rubber mallet and bumped the bottom of the S/C snout. It didn't take much.
|
This was going to be my plan, thank you.
Did you have to grind down the new PCV like the feller in the Install video?