CAMARO6 - View Single Post

oldman · 11-05-2018, 11:53 AM

I did not have any specs when I put the stage 1 supercharge TSP / Pray cam in. I think my limiter is 20 degrees... which is the only one I could find on the TSP site. My cam is small though. As long as the tuner knows, there should be no issues.

Same goes for the lobe, is it 32% or 36%, there is .35mm more lift (.014"). The only real problem is to make sure your lash cap is installed via measurements. Your friends dealership, better know what they are doing or read up on it. You can't just put the lash cap on and hope. If the mechanic has not ground a lash cap to fit, take it to a real shop.

11-05-2018, 11:53 AM	#5
oldman Drives: SS 6 speed of course Join Date: Jan 2016 Location: Hilo, HI Posts: 4,346	I did not have any specs when I put the stage 1 supercharge TSP / Pray cam in. I think my limiter is 20 degrees... which is the only one I could find on the TSP site. My cam is small though. As long as the tuner knows, there should be no issues. Same goes for the lobe, is it 32% or 36%, there is .35mm more lift (.014"). The only real problem is to make sure your lash cap is installed via measurements. Your friends dealership, better know what they are doing or read up on it. You can't just put the lash cap on and hope. If the mechanic has not ground a lash cap to fit, take it to a real shop. __________________ Forged short block, large duration sub .600 lift Cam Motion cam, 7200 RPM fuel cut, Pray Ported Heads, 3.85 pulley D1X, stage II intercooler, DSX secondary low side, DSX E85 sensor, Lingenfelter big bore 2.0 pump, ported front cats, 60608 Borla, LT4 injectors, ZL1 1LE driveshaft and Katech ported TB, ported MSD intake, BTR valvetrain, ARP studs, ProFlow valves, PS4 tires.