CAMARO6 - View Single Post - Question about pulley size/ boost amount on a Magnuson 2300

laynlo15 · 11-04-2018, 01:47 PM

We are going to have the 2650 out in a couple months, we had one on a 2017 Z06 at Sema. With all your mods you could easily run that, the vet we had there was pretty modded out and the new 2650 fits under the hood, just have to take out the inner linner. The 2300 or the 2300r will work also. I think you'll have to work from the stock pulley, each 5mm lower in pulley size is about 2 lbs of boost, just don't know what yours will be till you get it on the dyno the first time with the stock pulley.

11-04-2018, 01:47 PM	#4
laynlo15 Drives: 2022 Lt1 A10 Join Date: Nov 2015 Location: clark, mo Posts: 8,882	We are going to have the 2650 out in a couple months, we had one on a 2017 Z06 at Sema. With all your mods you could easily run that, the vet we had there was pretty modded out and the new 2650 fits under the hood, just have to take out the inner linner. The 2300 or the 2300r will work also. I think you'll have to work from the stock pulley, each 5mm lower in pulley size is about 2 lbs of boost, just don't know what yours will be till you get it on the dyno the first time with the stock pulley.