Quote:
Originally Posted by JeromeS13
I was able to get -2.5 degrees in the front, and had about 6mm of clearance between the wheel and the strut.
|
Quote:
Originally Posted by Alpha1BC
Right, sorry I meant needing to grind out the bolt-hole on the strut. I could only get -2 because that's all the holes on the struts would allow. No issues with tires or rims clearing anything.
|
There is some variance to the tolerance stack up. I was able to get -2.5 also, but my buddy maxed out at ~ -2.3 IIRC. Usually one side has slightly less than the other so that is your limiting factor.
That being said a little grinding to the bolt slots and you can get even more.