View Single Post
Old 06-21-2018, 08:56 PM   #1
Chris V
 
Chris V's Avatar
 
Drives: 2017 1SS 1LE
Join Date: Aug 2017
Location: New Jersey
Posts: 391
GM releases eLSD calibration for 2017+ SS1LE

GM has released the eLSD Calibration that Shaun Bailey and Alex Doss had in the winning car in CAMC at the 2017 SCCA Solo Nationals.

Part number 84506758 is for 2017 and 2018 SS 1LEs.

Cliffs: you pay, maintains warranty, only works with all nannies off, faster locking and unlocking. Car stays the same for all PTM modes as it was prior.

Quote:
Note to Dealers:
When reprogramming the Chassis Control Module, please call Techline Customer Support Center (TCSC)
at (1-800-828-6860). The TCSC will provide programming requirements and instructions. When calling
TCSC, please insure the specific vehicle VIN is on hand.
Dealer Piece Cost for Calibration will be billed to the BARS/Open Account monthly via Techline. Dealer
Statement will include the 17- digit VIN, Part Number Reference “eLSD" and Dealer Piece Cost. The
labor for download and re-flash of the module is to be charged to labor OP 0602518 at an allowable 0.3
hours.
Warranty Information:
Reflashing the eLSD Control Module with this calibration maintains the vehicle’s warranty.
Calibration Details:
Continuous on-track and street development combined with the pursuit of perfection have pushed our
Camaro engineers to develop an eLSD calibration that will enable faster turn in and faster power
application on turn exit. This eLSD calibration will decouple the differential at a faster rate based on
accelerator pedal position and steering wheel angle to enable faster yaw rotation at corner entry and
upon corner exit the eLSD will couple faster than normal rates to enable power to be delivered sooner
to both rear wheels.
Note: The change of eLSD calibration will only be enabled when Traction Control and Electronic Stability
Control (ESC) is disabled. When traction control and ESC is enabled, there is no change to the
production calibration in any mode (Tour, Sport or Track). To disable traction control and turn
ESC off, hold down the Traction Control button for 5 seconds. The traction control and ESC
telltale lights will illuminate in the dashboard.
Installation
Note: This upgraded eLSD calibration is a customer pay transaction and should not be submitted as a
warranty claim. The only submission to General Motors is for 0.3 hr Labor.
1. Drive the vehicle to your dealer and have the calibration updated to the applicable calibration listed in
Calibration Reference Table below.
Calibration Reference Table
Model Year Calibration Part Number
2017-2018 84506758
2019-2021 84506759
2. Clear any DTC that set during the flashing.
©
__________________
www.facebook.com/1lap1le

2017 1SS 1LE - 663 whp/623 wtq
Rotofab/Whipple/Kooks 2"/LT5 TB/LT4 Fueling/E85/MCS Coilovers/Ground Control/GOODAero/Apex Wheels/Race Louvers
Chris V is offline   Reply With Quote