Quote:
Originally Posted by oldman
Is the stage II blower cam bigger than the cam I have? I gotta like that 7000 RPM pull. I don't know where my cam stops as I got a hard time keeping it straight. I think I'm going to have to setup a camera to record what is going on, as the shifts are way too quick for the Oldman to keep track of. I want you all to note that on an M6 shifting at 6500 in 1st gear, the engine is at 4250 in 2nd. This cam brings the sift to at least 7000 and that would put it at around 4600 RPM RPM, that is 580 ft lbs of torque, from a centri… Hehe.
Vegnence has said their piston is the stock CR. Did you use the ARP bolts on the rods? You are correct that the stock rod bolts are torque to yield. Crazy..
|
Your cam is a little bit smaller and has a wider lobe sep. I think your cam has 0* OL. This cam has 5* OL. If I clean up the fuel a little up top and add a degree or two of timing it will pull cleanly to 7K.