Thread: Texas Speed Headers 2" or 1 7/8"
View Single Post
Old 05-12-2018, 03:50 PM   #7
SSLandon
 
SSLandon's Avatar
 
Drives: 2017 M6 2ss, Sunroof, Silver Ice
Join Date: Apr 2018
Location: Portland Oregon
Posts: 47
Quote:
Originally Posted by KingLT1 View Post
1 7/8 is more then enough for a bolt-on car. 2" would be good for a aggressive H/C/I car or forced induction setup. You will need a different bolt for the steering shaft which is supplied in the TSP kit. You will also need to check clearance on the engine harness that runs down the inner fender well and some spark plug heat shields from DEI would be a good idea.

Thanks for this input, I was definitely looking into the Shield for the wires, are you referring to the "Boots" for the wires? or Pipe shield?
SSLandon is offline   Reply With Quote