Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


Bigwormgraphix


Showing results 1 to 30 of 500
Search took 0.08 seconds.
Search: Posts Made By: KingLT1
Forum: ZL1 Discussions Today, 10:22 AM
Replies: 15
Views: 329
Posted By KingLT1
If you had to ask this question, then No leave it...

If you had to ask this question, then No leave it stock.
Forum: Forced Induction Discussions Yesterday, 08:40 AM
Replies: 2
Views: 247
Posted By KingLT1
If planning anything more than a 150 shot you...

If planning anything more than a 150 shot you really should consider a progressive controller so it doesn't hit so hard when activated. You are going to need colder plugs, Non projected tip BR7 NGK,...
Forum: ZL1 Discussions Yesterday, 08:32 AM
Replies: 99
Views: 19,052
Posted By KingLT1
You should have stated that in your prior post...

You should have stated that in your prior post because it reads like you are implying the GESI Gen 2 4.5" cats are the culprit....which had me scratching my head. The ones that came with your AR...
Forum: ZL1 Discussions 03-26-2024, 08:43 AM
Replies: 4
Views: 226
Posted By KingLT1
100% agree...:happy0180:

100% agree...:happy0180:
Forum: ZL1 Discussions 03-21-2024, 02:13 PM
Replies: 9
Views: 549
Posted By KingLT1
Yup...agreed!

Yup...agreed!
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 03-21-2024, 08:28 AM
Replies: 58
Views: 3,327
Posted By KingLT1
Do you think you might be hearing the HPFP?

Do you think you might be hearing the HPFP?
Forum: ZL1 Discussions 03-21-2024, 08:05 AM
Replies: 68
Views: 1,996
Posted By KingLT1
roughly 80whp...

roughly 80whp...
Forum: ZL1 Discussions 03-21-2024, 08:00 AM
Replies: 9
Views: 549
Posted By KingLT1
Agree.... E85 LOVES Heat!! As you mention it...

Agree.... E85 LOVES Heat!! As you mention it needs the heat to properly vaporize. Honestly in the cooler months you are better off to dial back the Ethanol content. I have found my vehicles run...
Forum: ZL1 Discussions 03-20-2024, 09:18 AM
Replies: 10
Views: 435
Posted By KingLT1
It says no tune required so that would be stock...

It says no tune required so that would be stock diameter because anytime the size changes you have to rescale the MAF in the tune.
Forum: ZL1 Discussions 03-20-2024, 09:06 AM
Replies: 68
Views: 1,996
Posted By KingLT1
About 700-720whp. Just to clarify, 850whp is...

About 700-720whp.

Just to clarify, 850whp is what the high side falls off on 93 pump gas, Not E85. Full E85 it's falling off in the 700whp range even with a bigger cam lobe. This is why we blend,...
Forum: ZL1 Discussions 03-20-2024, 08:24 AM
Replies: 10
Views: 435
Posted By KingLT1
If you have the 103mm tb then yes Big Gulp is...

If you have the 103mm tb then yes Big Gulp is definitely worth it over the Corsa.
Forum: ZL1 Discussions 03-20-2024, 08:07 AM
Replies: 68
Views: 1,996
Posted By KingLT1
LMR uses a cam with a bigger fuel lobe as...

LMR uses a cam with a bigger fuel lobe as Nimair.ZL1 mentioned.

A bone stock LT4 with stock fuel system will tolerate about E70.

With a low side upgrade, you can do bolt-ons(Headers, CAI, TB),...
Forum: ZL1 Discussions 03-19-2024, 01:31 PM
Replies: 68
Views: 1,996
Posted By KingLT1
It's very easy. I haven't had anybody run into...

It's very easy. I haven't had anybody run into issues. I have literally been running it on a SBE LT1 since 2017. Not a single issue.
Forum: ZL1 Discussions 03-18-2024, 04:02 PM
Replies: 68
Views: 1,996
Posted By KingLT1
Low side - 70psi high side- 2900psi IPW < 6.0...

Low side - 70psi
high side- 2900psi
IPW < 6.0 ms

On LT4 fueling with low side upgrade, I will sometimes up the rail pressure to 3200psi if the injector pulse widths are on edge (6.0ms).

One...
Forum: ZL1 Discussions 03-18-2024, 03:08 PM
Replies: 68
Views: 1,996
Posted By KingLT1
Regardless of needing to blend down or being able...

Regardless of needing to blend down or being able to run full E85, you are going to get different percents of Ethanol content at different filling stations anyway. Some stations can be almost 90% E,...
Forum: ZL1 Discussions 03-17-2024, 05:01 PM
Replies: 68
Views: 1,996
Posted By KingLT1
Agree!

Agree!
Forum: ZL1 Discussions 03-17-2024, 10:06 AM
Replies: 68
Views: 1,996
Posted By KingLT1
That setup should make 750 easy on 93. The larger...

That setup should make 750 easy on 93. The larger cam bleeding off dynamic compression should allow 93 to go a little further. I would say you can get close to 800 on good pump 93.

What issue...
Forum: Forced Induction Discussions 03-16-2024, 10:18 AM
Replies: 24
Views: 630
Posted By KingLT1
I would think the weight of the supercharger will...

I would think the weight of the supercharger will offset that. When I bolted my 2.9 on(no spacers needed) it lowered the front slightly.
Forum: ZL1 Discussions 03-16-2024, 10:11 AM
Replies: 10
Views: 467
Posted By KingLT1
That will do it...if left open it will cause a...

That will do it...if left open it will cause a vacuum leak and you will get the lean codes on both banks.
Forum: Forced Induction Discussions 03-15-2024, 11:18 AM
Replies: 24
Views: 630
Posted By KingLT1
I wonder if the LT stuff will get the Gen 6...

I wonder if the LT stuff will get the Gen 6 Whipple 3.0 option. I seen they released it last fall for the Ford stuff. They claim it's worth 30-35whp over the gen 5 all else equal.
Forum: ZL1 Discussions 03-14-2024, 01:28 PM
Replies: 10
Views: 467
Posted By KingLT1
Check all your connections from the throttle body...

Check all your connections from the throttle body to the cai. Also check your catch can connections/pet cock if you have one.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 03-14-2024, 08:05 AM
Replies: 4
Views: 399
Posted By KingLT1
Is it misfiring enough to trigger a CEL or you...

Is it misfiring enough to trigger a CEL or you are just seeing some misfires in the log? Because it's pretty normal to get some cold start misfires on E85. Part of the reason why they drop the E...
Forum: ZL1 Discussions 03-12-2024, 04:57 PM
Replies: 10
Views: 460
Posted By KingLT1
The 10l90 is robust enough you can command full...

The 10l90 is robust enough you can command full torque shifts at stock power and not phase it. The TM is in place to make the car shift like a European sports car and help keep the driver on the...
Forum: Forced Induction Discussions 03-12-2024, 08:29 AM
Replies: 24
Views: 630
Posted By KingLT1
PD superchargers typically whine under hard...

PD superchargers typically whine under hard acceleration, but the 3.0 will be almost silent at low boost. Which is all you will likely be running until the motor is built. Woosh is from external...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 03-09-2024, 09:03 AM
Replies: 3
Views: 448
Posted By KingLT1
Those headers are not Stainless Steel so I would...

Those headers are not Stainless Steel so I would pass on them. The ceramic coating will chip and then they will start to rust. Even on a car that doesn't see rain. Years ago I bought a 4th gen Z28...
Forum: Camaro Price | Ordering | Tracking | Dealers 03-08-2024, 08:33 AM
Replies: 17
Views: 789
Posted By KingLT1
45k

45k
Forum: ZL1 Discussions 03-07-2024, 04:19 PM
Replies: 115
Views: 8,634
Posted By KingLT1
That 1400hp is likely at the crank. At least that...

That 1400hp is likely at the crank. At least that is how most companies rate engines. You are likely close to that now. At 17% drivetrain loss, 1400hp = 1162whp.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 03-07-2024, 09:32 AM
Replies: 16
Views: 1,403
Posted By KingLT1
Put the muffler back on it.

Put the muffler back on it.
Forum: ZL1 Discussions 03-07-2024, 09:09 AM
Replies: 115
Views: 8,634
Posted By KingLT1
Nice results! Fwiw, Folks get way to worried...

Nice results!

Fwiw, Folks get way to worried about timing...my brother is the same way. 22 degrees is probably close for a setup like that. 24 would be absolute max imo. This isn't your average...
Forum: ZL1 Discussions 03-04-2024, 08:52 AM
Replies: 6
Views: 578
Posted By KingLT1
The 21 is a better deal. 4 years newer and a 1/3...

The 21 is a better deal. 4 years newer and a 1/3 of the mileage for another 13k. And it's within driving distance to go see. I bet you could negotiate down to 59-60k for it.
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 10:56 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.