Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


AWE Tuning


Page 1 of 2 1 2
Showing results 1 to 30 of 31
Search took 0.01 seconds. Search: Posts Made By: Herold Motorsports
Forum: Tuning / Diagnostics 03-31-2021, 01:17 AM
Replies: 4
Views: 820
Posted By Herold Motorsports
Which aem did you install? Usually if an aem...

Which aem did you install?

Usually if an aem unit gets stuck on test or heat up mode the power source for the gauge isn’t a strong enough or reliable source. Where are you getting 12v from?
Forum: Tuning / Diagnostics 03-31-2021, 01:16 AM
Replies: 5
Views: 2,023
Posted By Herold Motorsports
Lambda for tuning. On nitrous tuning I...

Lambda for tuning.
On nitrous tuning I typically stick around .85-.86
Have tried a little leaner but the gains weren’t there to justify it. Just keep an eye on everything. Is this a flex set up or...
Forum: Tuning / Diagnostics 03-04-2021, 08:46 PM
Replies: 10
Views: 1,600
Posted By Herold Motorsports
I'm dumb. I thought that log was for the OP...

I'm dumb. I thought that log was for the OP :bonk:

OP if you have a log you could post I'd be more than happy to look over it for you. If you need any remote tuning assistance just lmk. :thumbup:
Forum: Tuning / Diagnostics 03-04-2021, 02:40 PM
Replies: 10
Views: 1,600
Posted By Herold Motorsports
This pull shows .87-.91 Lambda in PE @ WOT, not...

This pull shows .87-.91 Lambda in PE @ WOT, not 1.15? Timing looks about right, honestly could probably take more seeing as the car appears to be on E85.

Also I'd work more on your fueling for...
Forum: Forced Induction Discussions 02-24-2021, 02:12 PM
Replies: 54
Views: 7,289
Posted By Herold Motorsports
You’re gonna have one bad a transmission. ...

You’re gonna have one bad a transmission.

You doing the brake and all?
Forum: Forced Induction Discussions 02-08-2021, 08:30 PM
Replies: 54
Views: 7,289
Posted By Herold Motorsports
Do you have your file by chance or is does he...

Do you have your file by chance or is does he have it on his HPTuners only?
Forum: Forced Induction Discussions 02-02-2021, 11:20 PM
Replies: 2
Views: 1,201
Posted By Herold Motorsports
Yes the F1X fits the 6th gen camaros.

Yes the F1X fits the 6th gen camaros.
Forum: Tuning / Diagnostics 02-02-2021, 02:39 AM
Replies: 7
Views: 2,107
Posted By Herold Motorsports
Required? No, until the CEL pops for the rear...

Required? No, until the CEL pops for the rear o2's (if he hasnt already shut them off)

However to say that the same tune with factory manifolds will be as efficient as an updated file for the...
Forum: Forced Induction Discussions 01-26-2021, 02:12 AM
Replies: 7
Views: 1,614
Posted By Herold Motorsports
Normally the SS kit, but could change depending...

Normally the SS kit, but could change depending on the blower.

At the end of the day you could always just get the sensor itself with QD to AN fittings and make your own.
Forum: Forced Induction Discussions 01-12-2021, 03:26 AM
Replies: 29
Views: 8,520
Posted By Herold Motorsports
A turbo you say? Let’s make it happen. :D

A turbo you say?
Let’s make it happen. :D
Forum: Forced Induction Discussions 01-11-2021, 02:32 PM
Replies: 54
Views: 7,289
Posted By Herold Motorsports
Sounds good! I know he said he gave it a couple...

Sounds good! I know he said he gave it a couple more pounds over gate to get the 700 number so just wondering if he gave it all of the controller for the 900 number or if it still had room in them. I...
Forum: Forced Induction Discussions 01-11-2021, 02:00 PM
Replies: 54
Views: 7,289
Posted By Herold Motorsports
Which turbos and how much pressure to get you to...

Which turbos and how much pressure to get you to the 900 number? Car came out awesome and look forward to seeing more from it.
Forum: Forced Induction Discussions 01-06-2021, 07:52 PM
Replies: 7
Views: 1,953
Posted By Herold Motorsports
We are not in Florida but would be more than...

We are not in Florida but would be more than happy to assist you in the install should you want to send the car. We are based out of Houston and have enclosed transport for our customer cars outside...
Forum: Forced Induction Discussions 01-05-2021, 04:55 AM
Replies: 8
Views: 1,671
Posted By Herold Motorsports
Looking at his sig and profile pic it appears...

Looking at his sig and profile pic it appears he’s still Lt4blower, which would explain why his is quiet.

To OP, straight cut gears are noisy, you’re going to hear it at idle. Even the helical...
Forum: Forced Induction Discussions 01-04-2021, 06:00 PM
Replies: 68
Views: 12,114
Posted By Herold Motorsports
With True E85 / E85.R / E98 at <300.00 for 55gal...

With True E85 / E85.R / E98 at <300.00 for 55gal drums, it's hard to beat.
Forum: Forced Induction Discussions 01-04-2021, 05:56 PM
Replies: 488
Views: 94,803
Posted By Herold Motorsports
The BMR stuff is nice and opens up room for more...

The BMR stuff is nice and opens up room for more activities for sure. We didnt use them in our single set up, but our twin set up will come with them hands down.
Forum: Tuning / Diagnostics 01-03-2021, 09:45 PM
Replies: 3
Views: 1,430
Posted By Herold Motorsports
We would love to take care of you if no others...

We would love to take care of you if no others can. Just let me know!
Forum: Tuning / Diagnostics 01-03-2021, 09:44 PM
Replies: 7
Views: 1,504
Posted By Herold Motorsports
Do you have a log and tune file we can see?

Do you have a log and tune file we can see?
Forum: Forced Induction Discussions 01-03-2021, 07:35 PM
Replies: 47
Views: 6,778
Posted By Herold Motorsports
Weird suggestion but I have seen it before....

Weird suggestion but I have seen it before. Methanol has to be sprayed through a nozzle at a minimum of 50psig. If not it cannot atomize properly pre-intake manifold and wont distribute correctly....
Forum: Forced Induction Discussions 01-03-2021, 07:04 PM
Replies: 47
Views: 6,778
Posted By Herold Motorsports
you were very lean. You want to get closer to the...

you were very lean. You want to get closer to the 12.0 mark but in reality you should be tuning in lambda not by afr.

For the meth however, I dont see a problem with it. We use methanol on TONS...
Forum: Forced Induction Discussions 12-26-2020, 11:27 PM
Replies: 117
Views: 19,877
Posted By Herold Motorsports
What kit is this? And why is there a wastegate...

What kit is this? And why is there a wastegate flange on the downpipe/exhaust as well as only 1 bank on the crossover?
Forum: Forced Induction Discussions 12-16-2020, 10:31 PM
Replies: 68
Views: 12,114
Posted By Herold Motorsports
This is more than likely the case. I’m sure...

This is more than likely the case.

I’m sure it’s a tuning issue. Post the log file.
Forum: Forced Induction Discussions 12-15-2020, 12:43 AM
Replies: 10
Views: 4,626
Posted By Herold Motorsports
We typically do LT4 pump/injectors first ...

We typically do LT4 pump/injectors first

Then cam

Then auxiliary system

Then in tank pump.

And if they still want more, port injection system at the end.
Forum: Forced Induction Discussions 12-15-2020, 12:42 AM
Replies: 30
Views: 16,019
Posted By Herold Motorsports
We got this single T6 80mm set up to fit and work...

We got this single T6 80mm set up to fit and work just fine. Keeps AC, all amenities, and drives great. Low Temps and no issues. Car did 700/700+ stock LT1, stock fuel system + meth and just recently...
Forum: Forced Induction Discussions 08-13-2020, 04:37 PM
Replies: 78
Views: 21,302
Posted By Herold Motorsports
I'd kill for 76* dyno temps here in Houston, TX...

I'd kill for 76* dyno temps here in Houston, TX lol.

Our shop is at 102-105 during the daytime....
Awesome set up and amazing numbers for sure.
Don't sweat 750 range on sbe, they can take it...
Forum: Forced Induction Discussions 08-12-2020, 09:23 PM
Replies: 14
Views: 2,150
Posted By Herold Motorsports
You'll eventually need to go T6. Keep in mind...

You'll eventually need to go T6.
Keep in mind the hp / lb of boost has a threshold. Once you start getting into higher boost levels you will gain significantly less HP per lb of boost.
I agree...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 08-12-2020, 02:50 PM
Replies: 15,330
Views: 2,507,110
Posted By Herold Motorsports
You boys got room for a single turbo Fifty in...

You boys got room for a single turbo Fifty in here? :usa2:
Forum: Forced Induction Discussions 08-12-2020, 01:41 PM
Replies: 488
Views: 94,803
Posted By Herold Motorsports
There's a fix for that. Delete the speed PID from...

There's a fix for that. Delete the speed PID from your channel list and go to add another. Look for "speed" (search). You'll find one that'll be highlighted as a broadcast (the 12 should be in...
Forum: Forced Induction Discussions 08-12-2020, 01:36 PM
Replies: 51
Views: 11,118
Posted By Herold Motorsports
That's why I was asking if it had the ZL1 pump in...

That's why I was asking if it had the ZL1 pump in tank also. Could be something with the install of the in tank pump. Pinched wire or loose. Though I don't think the pump is bad if you are saying the...
Forum: Forced Induction Discussions 08-11-2020, 01:53 PM
Replies: 51
Views: 11,118
Posted By Herold Motorsports
Is it something that happened out of nowhere or...

Is it something that happened out of nowhere or is this a new build set up that the code popped up from?

Unplug the JMS and see if it still occurs. I see your sig says LT4 fuel system, does that...
Showing results 1 to 30 of 31
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 05:35 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.