Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 30 of 390
Search took 0.04 seconds.
Search: Posts Made By: Katech_Zach
Forum: Autos For Sale / Wanted 11-11-2022, 08:53 AM
Replies: 6
Views: 997
Posted By Katech_Zach
Bump to the top

Bump to the top
Forum: Member Car Journals 11-10-2022, 01:26 PM
Replies: 58
Views: 8,843
Posted By Katech_Zach
That audio quality sounds great! I tried engine...

That audio quality sounds great! I tried engine bay, air box, rear bumper, and the GoPro native. All had their pros and cons.

If you want to have some fun, throw it on your intake. You hear some...
Forum: Member Car Journals 11-10-2022, 01:25 PM
Replies: 58
Views: 8,843
Posted By Katech_Zach
I used the Apex VS-5RS in the brushed clear...

I used the Apex VS-5RS in the brushed clear finish. The center caps are authentic GM brushed bowtie caps that fit the factory camaro bore:

https://www.apexraceparts.com/our-wheels/forged-vs5rs.html
Forum: Member Car Journals 11-10-2022, 08:25 AM
Replies: 58
Views: 8,843
Posted By Katech_Zach
Thank you guys. I do have some footage but the...

Thank you guys. I do have some footage but the audio quality is not great. I will try to scrap together any footage of the vehicle with a decent sound bite. I used an external mic setup in a few...
Forum: Member Car Journals 11-09-2022, 05:21 PM
Replies: 58
Views: 8,843
Posted By Katech_Zach
Update on the dyno session. The fuel system fell...

Update on the dyno session. The fuel system fell just short on E85. It was a fun science experiment but still needs some work. My low side fuel system held near 80 psi all the way to 8000 RPM. My LT4...
Forum: Autos For Sale / Wanted 11-09-2022, 03:51 PM
Replies: 6
Views: 997
Posted By Katech_Zach
Its a great car. If I wasn't so stubborn i would...

Its a great car. If I wasn't so stubborn i would have purchased it myself instead of buying my stock zl1 1le and modifying that.
Forum: Autos For Sale / Wanted 11-09-2022, 08:46 AM
Replies: 9
Views: 1,506
Posted By Katech_Zach
100% bone stock C6 Z06 with the exception of a...

100% bone stock C6 Z06 with the exception of a replacement trans/diff/torque tube. Very crazy, I know.
Forum: Autos For Sale / Wanted 11-08-2022, 11:01 PM
Replies: 6
Views: 997
Posted By Katech_Zach
Purpose built combination, bleeding off the...

Purpose built combination, bleeding off the appropriate amount of compression + keeping the engine cooled. It is difficult to do. Knock sensors are still active on this car as well.

This is...
Forum: Autos For Sale / Wanted 11-08-2022, 10:50 PM
Replies: 6
Views: 997
Posted By Katech_Zach
FS: 870rwhp 93 Octane Katech Powered ZL1

Making this posting for a good customer of ours. Up for sale is a Katech Stage 6 ZL1 Camaro. This is the ultimate street/strip vehicle for anyone looking for a reliable car that can be taken to the...
Forum: Member Car Journals 11-08-2022, 04:31 PM
Replies: 58
Views: 8,843
Posted By Katech_Zach
Good Afternoon Guys, its been awhile! Things have...

Good Afternoon Guys, its been awhile! Things have been good on the car, I have a few videos at Pitt Race and Grattan Raceway. The car is running very well.

I am working on getting a PDF of the...
Forum: Autos For Sale / Wanted 11-07-2022, 12:01 PM
Replies: 9
Views: 1,506
Posted By Katech_Zach
Mileage is a general standard of condition. If a...

Mileage is a general standard of condition. If a car was appropriately maintained during that mileage, there could be zero issues wrong with the car. We have a customer with a C7 Z06 that has nearly...
Forum: Road Course/Track and Autocross 11-07-2022, 11:56 AM
Replies: 8
Views: 519
Posted By Katech_Zach
You just have to add xineering shock sims into...

You just have to add xineering shock sims into the mag ride harness, and then you can install any coilover/shock you choose.

The only downside is you do not have an electronically adjustable...
Forum: Forced Induction 11-01-2022, 10:18 AM
Replies: 2
Views: 545
Posted By Katech_Zach
SOLD: Fresh Katech Ported LT4 ZL1 Supercharger + HX

SOLD

Selling an LT4 supercharger taken off from my personal ZL1 Camaro. This supercharger was taken off my 10,000 mile ZL1 when it was intake/exhaust/tune. The blower was never overspun (stock...
Forum: ZL1 Discussions 10-25-2022, 10:57 AM
Replies: 41
Views: 2,557
Posted By Katech_Zach
~725 on pump, Probably closer to 775-800~ on full...

~725 on pump, Probably closer to 775-800~ on full E but likely going to run out of high side on the top end. Injectors first, HPFP shortly after
Forum: Forced Induction Discussions 10-20-2022, 02:53 PM
Replies: 14
Views: 1,356
Posted By Katech_Zach
Two different dynos, i would not compare data...

Two different dynos, i would not compare data from two different dynos even if they claim to have the same correction factor.
Forum: Road Course/Track and Autocross 10-19-2022, 01:48 PM
Replies: 204
Views: 27,947
Posted By Katech_Zach
https://www.bmrsuspension.com/?page=products&produ...

https://www.bmrsuspension.com/?page=products&productid=2681&superpro=0

I dont know if any of you have seen these, but they offer an upgraded billet/delrin sway bar mount. This would resolve the...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 10-07-2022, 12:14 PM
Replies: 48
Views: 3,366
Posted By Katech_Zach
There is always a tradeoff. I did not read 100%...

There is always a tradeoff. I did not read 100% of the information on this thread, but going to a wider tire really doesn't change straight line traction too much. If you want to hook better, you...
Forum: ZL1 Discussions 10-07-2022, 09:34 AM
Replies: 27
Views: 1,976
Posted By Katech_Zach
Sounds like you are blowing through the torque...

Sounds like you are blowing through the torque converter. Common with cars that have large cams and a stock converter (gets very tricky). Assuming you have a stock cam, I would check the tune
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 10-04-2022, 02:46 PM
Replies: 10
Views: 1,532
Posted By Katech_Zach
Run 3/8 .080 or .135 pushrods, measure the...

Run 3/8 .080 or .135 pushrods, measure the length. Do not make the mistake of assuming length and accidentally hanging a valve open. It takes about 5 minutes to measure with a length checker
Forum: Road Course/Track and Autocross 10-03-2022, 02:10 PM
Replies: 12
Views: 954
Posted By Katech_Zach
Have someone plug into it and see what chassis /...

Have someone plug into it and see what chassis / communication codes are active. If you lose any sensor relating to the EBCM, PSCM, or CCM, it has the potential to throw out the axle as...
Forum: Road Course/Track and Autocross 10-03-2022, 10:06 AM
Replies: 12
Views: 954
Posted By Katech_Zach
What size tires are you running?

What size tires are you running?
Forum: Wheels | Tires -- Sponsored by The Tire Rack 09-23-2022, 02:37 PM
Replies: 243
Views: 84,731
Posted By Katech_Zach
The Apex VS-5RS's in brushed clear are great! A...

The Apex VS-5RS's in brushed clear are great! A little dirty from Pitt Race, but thats racing right? :cool:
...
Forum: ZL1 Discussions 09-22-2022, 02:55 PM
Replies: 17
Views: 1,232
Posted By Katech_Zach
I unfortunately am not a catalytic converter...

I unfortunately am not a catalytic converter expert. If you are going to use a catalytic converter on a modified ZL1 making any sort of power, I would be paying top dollar (GESI 85500 or GESI 85600)...
Forum: ZL1 Discussions 09-22-2022, 10:42 AM
Replies: 17
Views: 1,232
Posted By Katech_Zach
Catalytic converters need to be at their...

Catalytic converters need to be at their operating temperature in order to work efficiently. With long tube headers, they lose a lot more heat to the atmosphere than factory manifolds. You will not...
Forum: Road Course/Track and Autocross 09-21-2022, 09:56 AM
Replies: 22
Views: 1,334
Posted By Katech_Zach
Engine valve springs

Engine valve springs
Forum: Road Course/Track and Autocross 09-21-2022, 08:54 AM
Replies: 10
Views: 730
Posted By Katech_Zach
What do you mean by lugging? Is it clearly a...

What do you mean by lugging? Is it clearly a chassis related issue or is the engine bogging?

If the engine is bogging, what is your fuel level? Log fuel tank level and see if the lugs correspond...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 09-20-2022, 02:19 PM
Replies: 14
Views: 1,798
Posted By Katech_Zach
MSD + 103 is great. We commonly pick up 30rwhp on...

MSD + 103 is great. We commonly pick up 30rwhp on 93 octane with an msd, 103, rotofab, 160 thermostat, and retune. Its hard to say what youd pick up since you already have a tune + headers, but it...
Forum: ZL1 Discussions 09-14-2022, 08:48 AM
Replies: 50
Views: 3,534
Posted By Katech_Zach
We have installed both the ZL1 solid kit and the...

We have installed both the ZL1 solid kit and the BMR lockout kit. Both are great, the ZL1 kit obviously being the best. The BMR kit is much more user friendly, and installs a lot easier. For 99% of...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 09-14-2022, 08:45 AM
Replies: 8
Views: 763
Posted By Katech_Zach
Likely from the off-road headers and not your...

Likely from the off-road headers and not your catch can. If the tune is even barely off, then you will be shooting fuel out of your exhaust valve close event and it will come out as black smoke if...
Forum: Member Car Journals 09-10-2022, 04:33 PM
Replies: 58
Views: 8,843
Posted By Katech_Zach
Weekend update! The car is alive and well. I will...

Weekend update! The car is alive and well. I will post some preliminary dyno numbers when they are available.

On Monday, I will also post the aux pump fuel system and injector choices for this...
Showing results 1 to 30 of 390

 
Forum Jump

All times are GMT -5. The time now is 11:20 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2022, vBulletin Solutions, Inc.