Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Bigwormgraphix


Showing results 1 to 12 of 12
Search took 0.01 seconds. Search: Posts Made By: Waxenate
Forum: Cosmetic modifications (exterior and interior) 12-10-2023, 07:08 PM
Replies: 8
Views: 4,620
Posted By Waxenate
Anyone figure the reason out?

Anyone figure the reason out?
Forum: Cosmetic modifications (exterior and interior) 12-01-2023, 01:46 PM
Replies: 8
Views: 4,620
Posted By Waxenate
BCM 6 for me also. Anyone know what causes it to...

BCM 6 for me also. Anyone know what causes it to blow?
Forum: ZL1 Discussions 10-04-2023, 03:19 PM
Replies: 65
Views: 9,615
Posted By Waxenate
Boots

How do you get the boots on? Lol. Seems impossible. Any tricks?
Forum: ZL1 Discussions 09-27-2023, 05:29 PM
Replies: 65
Views: 9,615
Posted By Waxenate
I read something about going to full droop by...

I read something about going to full droop by removing springs to make sure it didn’t bind. Did you do that?
Forum: 2016+ Camaro: 6th Gen Camaro general forum 09-09-2023, 05:05 PM
Replies: 0
Views: 585
Posted By Waxenate
Front lower control arm bushing shot

Out of the blue the bushing on my front right control arm gave out. Was considering just replacing the bushing but then the modder in me kicked in. Lol

Anyone have experience with the SPL front...
Forum: Wheels | Tires -- Sponsored by The Tire Rack 11-14-2022, 11:03 AM
Replies: 3
Views: 7,118
Posted By Waxenate
Agreed! Only slotted and drilled rotors and...

Agreed! Only slotted and drilled rotors and braided lines. I don’t track it but every once in a while there’s a smart ass hellcat that thinks they have something lol. Traction is my weakness….
Forum: Wheels | Tires -- Sponsored by The Tire Rack 11-14-2022, 08:21 AM
Replies: 3
Views: 7,118
Posted By Waxenate
Rim and tire size question

I have a 2019 2SS and I’m currently on the 20 inch rims with 11inch on rear and 10inch on the front. Had the engine built, procharger and custom engine/trans tune. I’m wanting to go to a 17inch rim...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-10-2022, 06:39 PM
Replies: 1
Views: 1,020
Posted By Waxenate
Led wiring tap question

I am wiring in some small under hood leds and was planning to run off of the headlamps. (They will be located in hood heat extractor) I noticed there is a fuse for the right and left headlight and...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 04-09-2022, 05:26 PM
Replies: 15
Views: 6,407
Posted By Waxenate
I was trying to be good after I had my 2019 SS...

I was trying to be good after I had my 2019 SS built. Ended up blowing the high flow cars out. One completely and dislodged the other. There are HP limits on them so make sure to check that. Keep...
Forum: ZL1 Discussions 04-09-2022, 05:23 PM
Replies: 72
Views: 9,459
Posted By Waxenate
I have the borla s type on my 2019 SS and had...

I have the borla s type on my 2019 SS and had high flow cats installed. Engine is built to the hilt. Cammed, I take ported, headers, heads ported and polished, stroked to a 418 and procharged, ended...
Forum: Suspension | Brakes | Chassis 11-22-2020, 10:56 AM
Replies: 94
Views: 29,738
Posted By Waxenate
8k, 12k? I don’t know a ton about suspension...

8k, 12k? I don’t know a ton about suspension...
Forum: Suspension | Brakes | Chassis 11-20-2020, 01:59 PM
Replies: 94
Views: 29,738
Posted By Waxenate
I put a set on and so far that feel about 100...

I put a set on and so far that feel about 100 times better than the Eibach springs. Ride is better and cornering is ridiculous. Not a track guy just want to be able to set my ride height without...
Showing results 1 to 12 of 12

 
Forum Jump

All times are GMT -5. The time now is 10:13 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.