Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Bigwormgraphix


Showing results 1 to 16 of 16
Search took 0.01 seconds. Search: Posts Made By: crz2fer
Forum: 2016+ Camaro: 6th Gen Camaro general forum 10-13-2019, 01:35 PM
Replies: 5
Views: 8,177
Posted By crz2fer
Much appreciated! Thanks so much!

Much appreciated! Thanks so much!
Forum: 2016+ Camaro: 6th Gen Camaro general forum 10-13-2019, 12:46 PM
Replies: 5
Views: 8,177
Posted By crz2fer
Yeah so far I’ve only noticed it within the first...

Yeah so far I’ve only noticed it within the first few minutes of the car being turned on during sharp turns from a stop.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 10-13-2019, 10:41 AM
Replies: 5
Views: 8,177
Posted By crz2fer
Strange rubbing/buzzing noise from passenger side

Got my A8 2018 2SS back in April and has about 2.3k miles on it (haven’t driven it hard whatsoever). I live at the top of a steep hill, so I’m used to hearing all the pops coming from the exhaust as...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 04-25-2019, 04:35 PM
Replies: 117
Views: 33,878
Posted By crz2fer
Restock?

Curious on when "2016-19 CAMARO SS DRY FILTER AIR INTAKE SYSTEM WITH SOUND TUBE DELETE" will be restocked. Saw in an earlier message that production was projected to have started already but still...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-17-2011, 01:17 AM
Replies: 54
Views: 23,743
Posted By crz2fer
Thanks everyone for your support, I already...

Thanks everyone for your support, I already ordered a new wheel well liner, still contemplating getting a BPV. But unfortunately I'm still getting puffs of white smoke out of my exhaust.. not to...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 04:30 PM
Replies: 54
Views: 23,743
Posted By crz2fer
yeah this is most likely my fault, i just figured...

yeah this is most likely my fault, i just figured since the wheel are rolling forward (and not backwards) the rotation wouldnt feed water into. When installing i just didnt see how having the filter...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 01:06 PM
Replies: 54
Views: 23,743
Posted By crz2fer
Compression is good on all 6, first thing i...

Compression is good on all 6, first thing i checked after i removed the intake, Thanks!
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 01:04 PM
Replies: 54
Views: 23,743
Posted By crz2fer
I toyed with the filter postion for a good while...

I toyed with the filter postion for a good while and couldnt get the liner to sit right, it would rub on the tire.
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 12:53 PM
Replies: 54
Views: 23,743
Posted By crz2fer
No it doesnt work, when I use the remote start up...

No it doesnt work, when I use the remote start up you can hear the starter catch and then i just makes a high pitched whining sound until I get in the car and shut it off. I have to start the car...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 12:51 PM
Replies: 54
Views: 23,743
Posted By crz2fer
This is how my set up looks, just that section of...

This is how my set up looks, just that section of the wheel well is removed, you can see the dirt and mud built up from how wet everything was :/ i needa clean
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 12:48 PM
Replies: 54
Views: 23,743
Posted By crz2fer
See when I installed it, leaving that section of...

See when I installed it, leaving that section of the wheel well on would push the plastic against the filer. And from it being bowed out by touching the filter, the wheel well was all of half and...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 12:44 PM
Replies: 54
Views: 23,743
Posted By crz2fer
My hyrdoshield has been on for no longer than 2...

My hyrdoshield has been on for no longer than 2 months, I had to remove it last night to try and dry off the filter as best I could (No holes, just a little dirty). If you put the end of the filter...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 12:40 PM
Replies: 54
Views: 23,743
Posted By crz2fer
Haha, I shouldn't have cheaped out and went with...

Haha, I shouldn't have cheaped out and went with that upgrade:facepalm:
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 12:39 PM
Replies: 54
Views: 23,743
Posted By crz2fer
I wasnt too worried about rain when I ordered my...

I wasnt too worried about rain when I ordered my intake, I live in the middle of the desert and we were already 2 months into what turned into a 6 month drought. Like i said I've ran through some...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 12:34 PM
Replies: 54
Views: 23,743
Posted By crz2fer
Im not really worried about everyone believing...

Im not really worried about everyone believing me, just needed to rant, but more curious if theres a way or IF its effective to install an AEM bypass valve on this intake. It was about a 4 hour...
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 09-16-2011, 12:19 PM
Replies: 54
Views: 23,743
Posted By crz2fer
Injen CAI W/ Hydroshield AND STILL Hydrolocked My Engine

It didnt even rain that bad yesterday but long story short, I ended up coasting through a puddle maybe 3-4 inches at about 10-15 mph, and my entire car just shut off. Friend and I pushed it into the...
Showing results 1 to 16 of 16

 
Forum Jump

All times are GMT -5. The time now is 10:28 AM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.