Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 30 of 100
Search took 0.01 seconds.
Search: Posts Made By: ZL1_Chris
Forum: 5th Gen Camaro SS LS LT General Discussions 06-01-2023, 08:43 PM
Replies: 40
Views: 4,865
Posted By ZL1_Chris
My apologies I was mistaken on the holes but...

My apologies I was mistaken on the holes but honestly you sir and this forum can go **** its self because I am off later:happy0180:
Forum: 5th Gen Camaro SS LS LT General Discussions 06-01-2023, 08:11 PM
Replies: 40
Views: 4,865
Posted By ZL1_Chris
There is no oil holes for the oil to flow through...

There is no oil holes for the oil to flow through a cam bearing try agian I've built a few engines
Forum: 5th Gen Camaro SS LS LT General Discussions 06-01-2023, 08:08 PM
Replies: 40
Views: 4,865
Posted By ZL1_Chris
I think you should read his post agian........ he...

I think you should read his post agian........ he said cam bearings not main bearings I sir challenge you as well to convince me that CAM bearings have anything to do with oil pressure in an LS...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-01-2023, 07:04 PM
Replies: 40
Views: 4,865
Posted By ZL1_Chris
Please explain further how cam bearings or worn...

Please explain further how cam bearings or worn journals effects oil pressure :pop2:
Forum: Transmission / Driveline 06-01-2023, 05:49 PM
Replies: 7
Views: 1,034
Posted By ZL1_Chris
[QUOTE=CamaroCracka;11321579]Most of they guys on...

[QUOTE=CamaroCracka;11321579]Most of they guys on here I've seen, including me, just leave the ports open with nothing in them if they run a ZL1 or Z28 diff without the cooling lines. I have cooling...
Forum: Forced Induction - V8 06-01-2023, 05:08 PM
Replies: 16
Views: 1,444
Posted By ZL1_Chris
I understand completely and apologize. My...

I understand completely and apologize. My commitment was actually misdirected. My point was actually intended toward a different comment and you are 💯 percent correct no judgments just opinions....
Forum: Forced Induction - V8 06-01-2023, 03:25 PM
Replies: 16
Views: 1,444
Posted By ZL1_Chris
Is the crossmember cut in the pic? I believe...

Is the crossmember cut in the pic? I believe that's more structural that the piece OP is talking about cutting.
Forum: 5th Gen Camaro SS LS LT General Discussions 06-01-2023, 02:48 PM
Replies: 40
Views: 4,865
Posted By ZL1_Chris
I second FasNuf about the possibility of the bar...

I second FasNuf about the possibility of the bar bell issue although I am leaning more towards something you did during the cam install like the pinching pick-up tube O-ring normally this causes no...
Forum: ZL1 Parts 06-01-2023, 12:38 PM
Replies: 13
Views: 2,465
Posted By ZL1_Chris
Honestly I'm open to offers, $250 sound good

Honestly I'm open to offers, $250 sound good
Forum: ZL1 Parts 05-31-2023, 03:46 PM
Replies: 13
Views: 2,465
Posted By ZL1_Chris
Surly someone can use a forged crank and rods....

Surly someone can use a forged crank and rods. These should work on most ls applications and with a little polish on the crank and some good forged pistons someone has a forged rotating assembly....
Forum: Transmission / Driveline 05-31-2023, 03:36 PM
Replies: 7
Views: 1,034
Posted By ZL1_Chris
Nobody...... iv found some weld up the ports on...

Nobody...... iv found some weld up the ports on the diff and not run fluid through the diff. not a fan of that idea although probably ok for the dragstrip i think i still would like the extra...
Forum: Forced Induction - V8 05-31-2023, 03:22 PM
Replies: 16
Views: 1,444
Posted By ZL1_Chris
Looks like you already started :laughabove:Answer...

Looks like you already started :laughabove:Answer is yes and yes but I'd weld up the seam and add support elsewhere if needed.
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 05-29-2023, 06:58 PM
Replies: 3
Views: 389
Posted By ZL1_Chris
:popcorn:

:popcorn:
Forum: Off-topic Discussions 05-29-2023, 07:57 AM
Replies: 13
Views: 2,013
Posted By ZL1_Chris
:popcorn:Best of luck, love a clean car. Just a...

:popcorn:Best of luck, love a clean car. Just a thought, maybe do detail product reviews Subscribed
Forum: 5th Gen Camaro SS LS LT General Discussions 05-29-2023, 07:48 AM
Replies: 8
Views: 809
Posted By ZL1_Chris
Wondering since you are saying you are straight...

Wondering since you are saying you are straight piped do you still have cats and is there still downstream o2s. Its possible the previous tune had the downstream o2s disabled. If you do have cats and...
Forum: New Member Introductions 05-28-2023, 07:20 PM
Replies: 4
Views: 1,011
Posted By ZL1_Chris
:happy0180::thumbup:Welcome!! Window tent should...

:happy0180::thumbup:Welcome!! Window tent should be on the horizon as well
Forum: ZL1 Parts 05-28-2023, 09:12 AM
Replies: 6
Views: 1,601
Posted By ZL1_Chris
Still Available?

Still Available?
Forum: 5th Gen Camaro SS LS LT General Discussions 05-26-2023, 05:17 PM
Replies: 22
Views: 2,492
Posted By ZL1_Chris
100% correct, because of the higher compression...

100% correct, because of the higher compression ratio premium fuel is recamended to combat detonation. While not recamended running lower octane fuel will only potentially allow for detonation or...
Forum: ZL1 Parts 05-26-2023, 12:33 PM
Replies: 13
Views: 2,465
Posted By ZL1_Chris
Bump

Bump
Forum: 5th Gen Camaro SS LS LT General Discussions 05-26-2023, 11:23 AM
Replies: 22
Views: 2,492
Posted By ZL1_Chris
I would check injectors or possibly a intake leak...

I would check injectors or possibly a intake leak otherwise it could be a number of problems. If the car was tuned for 93 and you are running 87 that would cause detonation but doubtful with your set...
Forum: Suspension / Brakes / Chassis 05-26-2023, 07:17 AM
Replies: 3
Views: 391
Posted By ZL1_Chris
I would go with what ever option best suits your...

I would go with what ever option best suits your performance goals and is serviceable. Most OE parts you cannot grease while most aftermarket suspension parts you can.
Forum: Transmission / Driveline 05-26-2023, 07:10 AM
Replies: 7
Views: 1,034
Posted By ZL1_Chris
I wont be needing the cooler lines or...

I wont be needing the cooler lines or transmission mount so ill include them as well $3400.
Forum: Transmission / Driveline 05-25-2023, 07:45 PM
Replies: 7
Views: 1,034
Posted By ZL1_Chris
Status Report

Well ive got a Stage 3 4l80e with Jake's d3 transbrake ordered. Wondering what others that has done this swap on a zl1 did with the cooler lines feeding the rear diff. I'm thinking about just...
Forum: Cosmetics and Lighting Modification Discussions 05-23-2023, 11:37 AM
Replies: 18
Views: 1,128
Posted By ZL1_Chris
checked out the link and looks like endless...

checked out the link and looks like endless customization options. This will definitely be on my list for future mods. looks like a way to add paddle shifters after my 4l80e swap thats currently in...
Forum: General Automotive + Other Cars Discussion 05-20-2023, 06:43 AM
Replies: 4
Views: 3,716
Posted By ZL1_Chris
Looks good. Any chance you're still bored, I...

Looks good. Any chance you're still bored, I could use mine gone through :w00t:
Forum: Forced Induction - V8 05-19-2023, 09:23 PM
Replies: 9
Views: 618
Posted By ZL1_Chris
Most likely it wasn't your cam killing your low...

Most likely it wasn't your cam killing your low end more likely incorrect torque converter.
Forum: Forced Induction - V8 05-19-2023, 09:17 PM
Replies: 9
Views: 618
Posted By ZL1_Chris
I run there 4" stroke crank along with the TSP...

I run there 4" stroke crank along with the TSP stage 2 cam. Im not disappointed :happy0180:
Forum: 5th Gen Camaro SS LS LT General Discussions 05-19-2023, 09:05 PM
Replies: 43
Views: 3,003
Posted By ZL1_Chris
Knew you had an beuatiful build, never noticed...

Knew you had an beuatiful build, never noticed that engine compartment, just watched the video and must say wow!!!!!!
Forum: 5th Gen Camaro SS LS LT General Discussions 05-18-2023, 01:43 PM
Replies: 43
Views: 3,003
Posted By ZL1_Chris
Submodel (V6, SS, ZL1) -2015 ZL1- Cam, TSP 1 7/8"...

Submodel (V6, SS, ZL1) -2015 ZL1- Cam, TSP 1 7/8" LT
Brand of Exhaust -Full custom 3" Flow Master Muffler and X Pipe
Type (Axle or Cat Back) - Offroad
Pros - What not to like about it
Cons -...
Forum: Transmission / Driveline 05-18-2023, 12:53 PM
Replies: 7
Views: 1,034
Posted By ZL1_Chris
TR6060 4l80e swap

Well finally decided, 4L80e swap is next on the list. If anyone is interested I will be selling the MG9 TR6060 out of My 2015 ZL1 with 84k on the transmission. Also up for grabs, Tilton st246 twin...
Showing results 1 to 30 of 100

 
Forum Jump

All times are GMT -5. The time now is 07:19 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.