Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


Bigwormgraphix


Showing results 1 to 30 of 197
Search took 0.02 seconds.
Search: Posts Made By: aronSlusa
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 05-09-2022, 05:50 PM
Replies: 1
Views: 730
Posted By aronSlusa
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 05-03-2022, 12:58 PM
Replies: 0
Views: 672
Posted By aronSlusa
Forum: Wheels / Tires 04-29-2022, 11:09 AM
Replies: 0
Views: 644
Posted By aronSlusa
Forum: Wheels | Tires -- Sponsored by The Tire Rack 03-25-2022, 08:01 AM
Replies: 5
Views: 1,807
Posted By aronSlusa
I ran a 295/35/20 in the rear until this past...

I ran a 295/35/20 in the rear until this past week, relocated the harness, no issues worked great. Running the 285 you'll have no problem.
Forum: New Member Introductions 03-23-2022, 08:01 AM
Replies: 10
Views: 2,064
Posted By aronSlusa
When's the next time you're headed to RA? May 14,...

When's the next time you're headed to RA? May 14, for this guy...
Forum: Camaro DIY & HOW-TO instructions & discussions 01-07-2022, 11:00 AM
Replies: 7
Views: 2,325
Posted By aronSlusa
disregard

disregard
Forum: Road Course/Track and Autocross 10-30-2021, 09:46 PM
Replies: 27
Views: 2,419
Posted By aronSlusa
That last picture, the smile on your face......

That last picture, the smile on your face... that's what its about!
Forum: Exterior Parts & Accessories 10-30-2021, 09:44 PM
Replies: 2
Views: 683
Posted By aronSlusa
What makes them stealth? How are they different...

What makes them stealth? How are they different from the other lift pads they have?
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 10-15-2021, 01:08 PM
Replies: 3
Views: 1,203
Posted By aronSlusa
Did your can vent and the oil heat up / smoke?

Did your can vent and the oil heat up / smoke?
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 09-15-2021, 04:16 PM
Replies: 25
Views: 3,442
Posted By aronSlusa
So is the higher octane gas over in Russia...

So is the higher octane gas over in Russia refined worse than our higher octane in the states here, is that what you're saying?
I'm just curious is all.
Forum: Cosmetic Maintenance - Wash, Wax, Detailing, Exterior Repairs 09-05-2021, 07:21 AM
Replies: 1
Views: 1,277
Posted By aronSlusa
Love their stuff and pretty much all I use (short...

Love their stuff and pretty much all I use (short of sprayway window cleaner). Built up quite the collection from their mystery bucket, box and cart sales.
Forum: Tuning / Diagnostics 08-31-2021, 09:07 PM
Replies: 3
Views: 2,438
Posted By aronSlusa
Send back anything you find, please. Having an...

Send back anything you find, please. Having an issue with that #35 fuse that just started under WOT.
Forum: Cosmetic modifications (exterior and interior) 08-31-2021, 12:12 PM
Replies: 7
Views: 2,246
Posted By aronSlusa
Yup, I do.

Yup, I do.
Forum: Road Course/Track and Autocross 08-30-2021, 09:26 PM
Replies: 34
Views: 4,361
Posted By aronSlusa
Videos and pics welcome of the journies and event!

Videos and pics welcome of the journies and event!
Forum: Cosmetic modifications (exterior and interior) 08-28-2021, 06:36 PM
Replies: 4
Views: 1,618
Posted By aronSlusa
Trade it in ahead of lease maturity and you won’t...

Trade it in ahead of lease maturity and you won’t feel a thing.
Nice car man! Love that LT1 badging.
Forum: Suspension | Brakes | Chassis 08-28-2021, 10:59 AM
Replies: 25
Views: 5,194
Posted By aronSlusa
Used Brembo LCF 600+ during my last couple track...

Used Brembo LCF 600+ during my last couple track days and was not impressed compared to Motul660 despite the wet and dry boiling points supposed to have been a little better in the Brembo vs Motul....
Forum: Road Course/Track and Autocross 08-27-2021, 01:46 PM
Replies: 13
Views: 2,312
Posted By aronSlusa
I feel forced to use the paddle shifters, on my...

I feel forced to use the paddle shifters, on my '16 SS it cannot make up its mind it seems unless I'm WOT. Going into turns it gets too squirly and tries to shift at the worst time.

Wonder if the...
Forum: Forced Induction Discussions 08-27-2021, 08:02 AM
Replies: 16
Views: 2,450
Posted By aronSlusa
Just keep an eye on it after your runs, drain it...

Just keep an eye on it after your runs, drain it and you should be fine.

Finally had some time and finished, what I hope will work, last night.
This is all just a safeguard in the event that it...
Forum: Suspension | Brakes | Chassis 08-24-2021, 11:35 AM
Replies: 5
Views: 1,378
Posted By aronSlusa
Maybe they don't have it in their computer? I...

Maybe they don't have it in their computer?
I have mine done at a Ford and CDJR dealer (I work at them), and the techs have no issues with aligning an off brand vehicle.
Forum: Forced Induction Discussions 08-24-2021, 07:43 AM
Replies: 16
Views: 2,450
Posted By aronSlusa
I have a y-section of piping from Dorman that I'm...

I have a y-section of piping from Dorman that I'm going to install in the yellow area.
Check valve in place so the pressurized air from the MM goes into the Mishimoto and back out to the ProCharger...
Forum: Forced Induction Discussions 08-23-2021, 08:19 PM
Replies: 16
Views: 2,450
Posted By aronSlusa
Maybe it’s just me as it’s happened before where...

Maybe it’s just me as it’s happened before where it ventilates… and if you’re out there mightymouse and watching chime in…. But in the event of it venting it’s going to push any stored oil into the...
Forum: Forced Induction Discussions 08-23-2021, 06:06 PM
Replies: 16
Views: 2,450
Posted By aronSlusa
Probably the most effective way is a can / water...

Probably the most effective way is a can / water bottle IMO.
It takes just a couple minutes of time to unbolt and drain and bolt back in. Can't see there being a more effective way of doing...
Forum: Forced Induction Discussions 08-23-2021, 04:18 PM
Replies: 16
Views: 2,450
Posted By aronSlusa
How are you setting up your recirculating top if...

How are you setting up your recirculating top if you don't mind my asking? Curious how my design stacks up

Going to be completely dependent on usage. Normal street driving I'm checking every third...
Forum: Forced Induction Discussions 08-23-2021, 02:14 PM
Replies: 16
Views: 2,450
Posted By aronSlusa
I usually fill a can each time I’m at the track,...

I usually fill a can each time I’m at the track, if not two depending on how hard I get on it and how many sessions.
Really impressed with the MM can! I have their wild setup and just picked up...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 08-21-2021, 11:52 AM
Replies: 1
Views: 1,268
Posted By aronSlusa
Check the cooler lines that run along the bottom...

Check the cooler lines that run along the bottom by the exhaust, they have small circle spacers around them.
I had a rattle that would come and go and it ended up being those lines were not seated...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-18-2021, 07:08 PM
Replies: 8
Views: 1,848
Posted By aronSlusa
Do share more info on this, I’m interested. ...

Do share more info on this, I’m interested.
Does the motion raceworks vent crankcase pressure somewhere other than in the engine bay, along with all the oil the CC caught?
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-16-2021, 06:22 AM
Replies: 8
Views: 1,848
Posted By aronSlusa
That was my biggest gripe at first, even more of...

That was my biggest gripe at first, even more of a pita when it comes to the strut tower brace… but the last couple times all I’ve done is undo the fitting on the oil fill adapter, this allows me to...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 07-19-2021, 05:04 PM
Replies: 0
Views: 448
Posted By aronSlusa
LT1 high side and in tank pump

Have them sitting around, want to offer them up here first in the event someone needs something to go back to stock or can use them in a different application.
$100 shipped a piece, or $175 shipped...
Forum: Suspension / Chassis / Brakes 06-09-2021, 04:40 PM
Replies: 9
Views: 1,153
Posted By aronSlusa
80 shipped, paypal tonight just pm me

80 shipped, paypal tonight just pm me
Forum: Exterior Parts & Accessories 06-09-2021, 04:39 PM
Replies: 7
Views: 1,857
Posted By aronSlusa
325 shipped and i'll take it

325 shipped and i'll take it
Showing results 1 to 30 of 197

 
Forum Jump

All times are GMT -5. The time now is 02:55 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.