Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Bigwormgraphix


Page 1 of 4 1 234
Showing results 1 to 30 of 93
Search took 0.01 seconds. Search: Posts Made By: WEISHAAR37
Forum: Forced Induction - V8 09-17-2021, 09:41 AM
Replies: 2
Views: 816
Posted By WEISHAAR37
the engine and trans swap is fine, but do not...

the engine and trans swap is fine, but do not change the ECU. every module on the car talks on a CAN network and it will be your worst nightmare if you disrupt that.

just put the motor and trans...
Forum: Forced Induction - V8 06-30-2021, 07:24 AM
Replies: 6
Views: 1,179
Posted By WEISHAAR37
Do not do it that way. just get a -6 to -3...

Do not do it that way. just get a -6 to -3 adapter for the bottle and run the correct size -3 line from the bottle to the nozzle. the flare on the jet seals against the flare inside the hose fitting....
Forum: Forced Induction - V8 06-30-2021, 07:19 AM
Replies: 11
Views: 3,924
Posted By WEISHAAR37
shoot an email to Ben@Gwayneyperformance.com and...

shoot an email to Ben@Gwayneyperformance.com and we can talk over exactly what you are looking for and what you can expect out of the parts you choose.

Ben
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-30-2021, 07:09 AM
Replies: 22
Views: 2,933
Posted By WEISHAAR37
Keep the Fast manifold, it wont lose quite as...

Keep the Fast manifold, it wont lose quite as much down low as the High ram will but it will also hold power and not fall off to the 7800rpm range.

also a huge thing nobody has mentioned here is...
Forum: Dragstrip and Launch Techniques Discussion 10-20-2020, 09:53 AM
Replies: 15
Views: 4,752
Posted By WEISHAAR37
dont ever shift at peak TQ. for drag racing and...

dont ever shift at peak TQ. for drag racing and the best average HP through each gear you want to shift about 10% past peak HP. so if the car makes peak hp at 6500 then shift it at 7150. you can...
Forum: Member Car Journals 10-16-2020, 09:26 AM
Replies: 778
Views: 120,186
Posted By WEISHAAR37
This is the purpose of the bars. to keep the tire...

This is the purpose of the bars. to keep the tire round and not smash the sidewall. im far from an expert, but if its smacking the bars hard then slow the front end down and raise air pressure...
Forum: Tuning / Diagnostics -- engine and transmission 09-23-2020, 08:01 AM
Replies: 16
Views: 3,374
Posted By WEISHAAR37
Your car was likely tuned on the dyno with the TQ...

Your car was likely tuned on the dyno with the TQ Converter unlocked. i have no clue why other tuners continue to do this as it ends up in a thread like this 90% of the time. it also seems that they...
Forum: Tuning / Diagnostics -- engine and transmission 09-23-2020, 07:41 AM
Replies: 3
Views: 1,397
Posted By WEISHAAR37
if the car is tuned then there is a chance your...

if the car is tuned then there is a chance your tuner Disabled the Brake TQ Management table where it turns off with the traction control button. this a common mistake i find when retuning cars for...
Forum: Forced Induction - V8 09-22-2020, 07:23 AM
Replies: 16
Views: 3,285
Posted By WEISHAAR37
unhook your 2step and see if the car will rev...

unhook your 2step and see if the car will rev over 4k with the clutch pushed in, some tuners put a low rev limiter in with the clutch depressed to "act" like a no lift shift.

if your car is on...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-30-2020, 03:31 PM
Replies: 128
Views: 13,805
Posted By WEISHAAR37
I totally understand the frustrations of shipping...

I totally understand the frustrations of shipping costs. If you have a trusted installer down there for your parts we also offer a remote tuning service that may be appealing to you. You wont have to...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-29-2020, 08:44 AM
Replies: 128
Views: 13,805
Posted By WEISHAAR37
Hey man, Myself and Ryan up here at GPI...

Hey man,

Myself and Ryan up here at GPI Would love a chance to help you get the car sorted out. Some good flowing heads and a bump in compression would really help that intake come alive more...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-13-2020, 08:05 AM
Replies: 14
Views: 3,589
Posted By WEISHAAR37
youre more likely to clear the hood than you are...

youre more likely to clear the hood than you are the cowl.
Forum: Forced Induction - V8 01-28-2020, 05:34 PM
Replies: 16
Views: 4,786
Posted By WEISHAAR37
Ive tuned a good number if 7-800hp range LSA cars...

Ive tuned a good number if 7-800hp range LSA cars here at GPIin the last year or so and have never been anywhere close to 30+ degrees even on E. most cars make the best power between 19-24 degrees....
Forum: Dragstrip and Launch Techniques Discussion 01-08-2020, 02:22 PM
Replies: 13
Views: 2,321
Posted By WEISHAAR37
yall also need to consider if you are locking the...

yall also need to consider if you are locking the converter in 3rd as OP will not have that ability causing his trap RPM to be quite a bit higher than yours at the same MPH
Forum: Dragstrip and Launch Techniques Discussion 01-08-2020, 02:19 PM
Replies: 91
Views: 44,968
Posted By WEISHAAR37
Hey Fellas, we (GPI) have a pre order going...

Hey Fellas,

we (GPI) have a pre order going on right now for the tubular cradles. there are no pictures as of yet. I dropped off my stock Cradle to our fabricator this week. we should have the...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 12-06-2019, 01:22 PM
Replies: 11
Views: 5,883
Posted By WEISHAAR37
factory fuel pressure runs about 58psi, but is...

factory fuel pressure runs about 58psi, but is commanded to drop to 50-51psi in the upper RPM. most people believe that this is caused by the pump getting weak but in most cases that is not true. it...
Forum: Member Car Journals 11-26-2019, 09:25 AM
Replies: 778
Views: 120,186
Posted By WEISHAAR37
Price was very reasonable and saved me a bunch of...

Price was very reasonable and saved me a bunch of hours of welding lmao. and bet im going to push it as hard as it will go! thanks again Bud.

Ben
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 10-02-2019, 07:44 AM
Replies: 43
Views: 7,823
Posted By WEISHAAR37
Hello Fellas, Im running a custom Cam...

Hello Fellas,

Im running a custom Cam Motion LLSR specced here at GPI with our ported and milled LS3 heads and a CID intake with an Accufab 4500 throttle body. the cam is 25x/27x 78x/74x. T&D...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-19-2019, 07:49 AM
Replies: 13
Views: 4,612
Posted By WEISHAAR37
Im Far from being the baddest one out there, but...

Im Far from being the baddest one out there, but mine made 615whp through a th400 in the same configuration that i won camarofest with.

Ben
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-15-2019, 09:55 AM
Replies: 1,469
Views: 157,445
Posted By WEISHAAR37
Robert carter also makes a filter front for these...

Robert carter also makes a filter front for these scoops. just turn the scoop backwards and drive wherever you want even in the rain!

im a bad influence :happy0180:
Forum: Forced Induction - V8 08-13-2019, 08:03 AM
Replies: 6
Views: 3,855
Posted By WEISHAAR37
is the car an auto or manual? and how are you...

is the car an auto or manual? and how are you planning to calculate it into flywheel HP?

i work as a tuner here at GPI, and for reference last week i made 548/548 in a 2015 ZL1 M6 car wth nothing...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-13-2019, 07:58 AM
Replies: 13
Views: 4,612
Posted By WEISHAAR37
are you interested in flywheel numbers or rear...

are you interested in flywheel numbers or rear wheel?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-13-2019, 07:55 AM
Replies: 1,469
Views: 157,445
Posted By WEISHAAR37
man.... your car wth my intake/scoop setup would...

man.... your car wth my intake/scoop setup would be... rowdy to say the least on the big end :eyebulge:
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 07-01-2019, 12:35 PM
Replies: 1,469
Views: 157,445
Posted By WEISHAAR37
Slammed1000 the shift points are determined...

Slammed1000

the shift points are determined by the converters shift recovery point between gears. if we shift it at 8k and it drops to 6k it will be slower as an example. Chris has plans for FI in...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 06-20-2019, 09:11 AM
Replies: 1,469
Views: 157,445
Posted By WEISHAAR37
Hey Chris, Definitely give us a shout on the...

Hey Chris, Definitely give us a shout on the phone up here at GPI. i shoud definitely be able to get you moved over to monday without a problem!

Ben Weishaar
Forum: Dragstrip and Launch Techniques Discussion 05-09-2019, 05:28 PM
Replies: 152
Views: 138,348
Posted By WEISHAAR37
my car was 3150 with me (210) in it last time out...

my car was 3150 with me (210) in it last time out to the track...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-01-2019, 09:03 AM
Replies: 1,469
Views: 157,445
Posted By WEISHAAR37
JROD the gator aid bottle is my radiator...

JROD

the gator aid bottle is my radiator overflow tank...
i took the stock tank out to save weight and forgot till i got to the track. this was a quick fix to ensure no coolant got spit out in...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-27-2019, 02:58 PM
Replies: 1,469
Views: 157,445
Posted By WEISHAAR37
And here i am looking for 6400 flash on the...

And here i am looking for 6400 flash on the converter 😂😎🤘
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 02-27-2019, 10:23 AM
Replies: 1,469
Views: 157,445
Posted By WEISHAAR37
Id be interested to know which shop/tuner you are...

Id be interested to know which shop/tuner you are using?
Forum: Dragstrip and Launch Techniques Discussion 02-26-2019, 01:33 PM
Replies: 3,652
Views: 1,177,937
Posted By WEISHAAR37
NA SBE personal best

R/T..........(.1.985)
60'.............(1.377)
330'...........(4.121)
660'...........(6.435)
660’ mph...(106.15)
1000'..........(8.446)
1320'..........(10.163)
1320’ mph…(130.68)
Name of the...
Showing results 1 to 30 of 93
Page 1 of 4 1 234

 
Forum Jump

All times are GMT -5. The time now is 06:55 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.