Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums


Bigwormgraphix


Showing results 1 to 30 of 461
Search took 0.03 seconds.
Search: Posts Made By: Torquem
Forum: ZL1 Discussions 02-17-2021, 11:49 AM
Replies: 6
Views: 1,159
Posted By Torquem
Any changes from 17 to 21?

I'm debating picking up a 2021 Zl1. I had a 17 Zl1 10 speed when they came out and loved it. Were there any changes made in the interim? If so, what all was changed? Thanks for any information!
Forum: Wash/Wash/Detailing and Cosmetic Maintenance Parts 05-04-2020, 06:47 PM
Replies: 0
Views: 2,337
Posted By Torquem
Metrovac Master Blaster Revolution w/ 30 ft hose. Like new - Houston TX

Bought this at end of February this year. Used it a couple of times. It blows an INSANE amount of heated / filtered air. Awesome for drying off cars / motorcycles. Comes with everything as new. ...
Forum: ZL1 Parts 05-01-2020, 07:26 AM
Replies: 1
Views: 862
Posted By Torquem
Firecore plug wires are SOLD. thank you

Firecore plug wires are SOLD. thank you
Forum: ZL1 Parts 04-30-2020, 04:06 PM
Replies: 1
Views: 862
Posted By Torquem
Firecore plug wires (new), Zl1 floor mats, oil, grill clips, etc - Houston

I have some leftover parts from when I had my 17 ZL1. Located in Houston TX.

Firecore Promod wires. Brand new. These were about 180 bucks new. SOLD

Genuine GM front grill / duct clips. These...
Forum: ZL1 Parts 02-02-2020, 02:22 PM
Replies: 12
Views: 2,894
Posted By Torquem
Have a few items left.

Have a few items left.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-26-2020, 01:46 PM
Replies: 3
Views: 982
Posted By Torquem
Any upholstery guys in here?

Hoping someone here can give me some input. Drivers side seat leather on my new Supra pulls out of headrest piece. I'm hoping some steam or something will relax it enough to keep it from continuing....
Forum: ZL1 Parts 01-14-2020, 08:30 AM
Replies: 12
Views: 2,894
Posted By Torquem
Would take 100 bucks for everything remaining...

Would take 100 bucks for everything remaining picked up. The plug wires alone were 125.
Forum: ZL1 Parts 01-12-2020, 07:15 PM
Replies: 12
Views: 2,894
Posted By Torquem
Trunk lid and center caps sold

Trunk lid and center caps sold
Forum: ZL1 Parts 01-12-2020, 01:29 PM
Replies: 12
Views: 2,894
Posted By Torquem
Also found these Zl1 center caps new in plastic

Also found these Zl1 center caps new in plastic
Forum: ZL1 Parts 01-12-2020, 01:26 PM
Replies: 12
Views: 2,894
Posted By Torquem
Might be cost prohibitive. It would require a...

Might be cost prohibitive. It would require a decent size box.
Forum: ZL1 Parts 01-12-2020, 01:26 PM
Replies: 12
Views: 2,894
Posted By Torquem
I will sell you the trunk lid. Would need to be...

I will sell you the trunk lid. Would need to be picked up in rosenberg/richmond area though.
Forum: ZL1 Parts 01-05-2020, 04:20 PM
Replies: 12
Views: 2,894
Posted By Torquem
Bunch of misc ZL1 parts in Houston (no shipping)

Still have some parts left over. 100 bucks picked up in Houston. No time to ship anything. The plug wires alone were 125 new and took a month to get.
OEM floor mats. Black / plain. Brand new...
Forum: ZL1 Discussions 01-02-2020, 01:32 PM
Replies: 6
Views: 1,223
Posted By Torquem
But, louder = faster. Always.

But, louder = faster. Always.
Forum: Wheels / Tires 12-31-2019, 02:57 PM
Replies: 13
Views: 5,604
Posted By Torquem
Why would you shit on a forum members sales...

Why would you shit on a forum members sales thread?? :twitch: If they are too expensive, they wont sell.
Also, factory wheels are forged. Replicas are almost always cast. Forged>Cast. ...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-02-2019, 03:13 PM
Replies: 40
Views: 7,622
Posted By Torquem
That, and it was akin to driving with shades on...

That, and it was akin to driving with shades on at night.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-02-2019, 01:02 PM
Replies: 40
Views: 7,622
Posted By Torquem
Earmark Car Audio in Plano, TX tinted my...

Earmark Car Audio in Plano, TX tinted my Corvette. They did an excellent job. Formula One dealer as well. Tell Ben that Preston sent you :)
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-02-2019, 12:58 PM
Replies: 40
Views: 7,622
Posted By Torquem
If it is grainy and orange peel, the installer...

If it is grainy and orange peel, the installer applied too much heat to it during install. Properly installed it is perfectly clear with a slight bluish hue.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-02-2019, 12:56 PM
Replies: 40
Views: 7,622
Posted By Torquem
I don't have "tints", but I do have tint :) I...

I don't have "tints", but I do have tint :)
I am running 35% formula one stratos on side and back windows. Air80 is an 80% tint with excellent heat rejection. It's all I run on my windshield these...
Forum: ZL1 Discussions 12-02-2019, 12:51 PM
Replies: 15
Views: 3,808
Posted By Torquem
I'm sure there are instances when a set could...

I'm sure there are instances when a set could last the lifetime of the car, but I have never seen it. All my buddies that run them have just about passed out when they had to replace them. Several...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-02-2019, 12:31 PM
Replies: 46
Views: 11,999
Posted By Torquem
Check your wire / coil connections. I had this...

Check your wire / coil connections. I had this exact thing happen and it was a loose coil / wire connection on my #6 cylinder. Snugged it up and it has been perfect since.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-02-2019, 12:26 PM
Replies: 40
Views: 7,622
Posted By Torquem
I tinted front windshield with 35% ONCE back in...

I tinted front windshield with 35% ONCE back in the day. Regretted it immediately. Now I only run Air80. But no, it will not effect your HUD
Forum: ZL1 Discussions 11-29-2019, 08:49 AM
Replies: 14
Views: 2,780
Posted By Torquem
You do not need anything other than the ACS...

You do not need anything other than the ACS pieces. And yes I went with gloss black
Forum: 2016+ Camaro: 6th Gen Camaro general forum 11-29-2019, 08:43 AM
Replies: 20
Views: 3,753
Posted By Torquem
Done plenty. Used to do it for a living. No...

Done plenty. Used to do it for a living. No comparison. Powder coat every time. Of course if prep is garbage, product will be garbage. That is true with anything. Given the same attention to...
Forum: ZL1 Discussions 11-29-2019, 08:18 AM
Replies: 14
Views: 2,780
Posted By Torquem
I love my ACS rock guards. The could have...

I love my ACS rock guards. The could have designed them a little wider IMO, but they are the best look / fit you can get.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 11-27-2019, 01:08 PM
Replies: 47
Views: 8,927
Posted By Torquem
I like this guy

I like this guy
Forum: 2016+ Camaro: 6th Gen Camaro general forum 11-27-2019, 10:53 AM
Replies: 20
Views: 3,753
Posted By Torquem
Powder coat. No question. Painted wheels are...

Powder coat. No question. Painted wheels are straight garbage.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 11-20-2019, 03:41 PM
Replies: 15
Views: 3,079
Posted By Torquem
Well scratch previous comment. I dropped her a...

Well scratch previous comment. I dropped her a PM and she instantly responded. lol
Forum: 2016+ Camaro: 6th Gen Camaro general forum 11-20-2019, 03:15 PM
Replies: 15
Views: 3,079
Posted By Torquem
Becky has not returned a single email or...

Becky has not returned a single email or voicemail I have left her. Not sure what the issue is. That was month or two ago.
Forum: ZL1 Discussions 11-20-2019, 03:12 PM
Replies: 34
Views: 7,605
Posted By Torquem
I only do neutral drop starts off rev limiter. ...

I only do neutral drop starts off rev limiter. No issues yet.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 11-19-2019, 03:57 PM
Replies: 17
Views: 4,646
Posted By Torquem
A lot of installs with them on the ZL1 have...

A lot of installs with them on the ZL1 have rubbing issues, clearance issues, etc. Seems silly to not spend the extra little bit up front to avoid issues down the road. Great luck with ARH and...
Showing results 1 to 30 of 461

 
Forum Jump

All times are GMT -5. The time now is 04:17 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.