Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


AWE Tuning


Showing results 1 to 25 of 25
Search took 0.01 seconds. Search: Posts Made By: NorCalLT1
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 01-15-2023, 08:05 PM
Replies: 0
Views: 549
Posted By NorCalLT1
MSD carb sticker

Hopefully this is the right place. I have a MSD intake but I don't have the CARB sticker. Is there anywhere I can get one or does anyone here have one? Thanks
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-19-2022, 06:20 PM
Replies: 7
Views: 1,881
Posted By NorCalLT1
I had just put new gas in it since it was pretty...

I had just put new gas in it since it was pretty empty. Well now I'm very confused. I replaced the injector and the problem was still there. Now I'll admit I should have done this first and tried new...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-19-2022, 11:36 AM
Replies: 7
Views: 1,881
Posted By NorCalLT1
Should have mentioned that. Yes it's modified msd...

Should have mentioned that. Yes it's modified msd intake, rotofab, 95mm TB, tuned for e85
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-18-2022, 10:01 PM
Replies: 7
Views: 1,881
Posted By NorCalLT1
P0300 and P0308 help

So this morning i drove my car to work and it felt fine then i felt like it began to sputter or miss. eventually the car threw a CEL and a stabilitrak error. I could tell the car was not firing on...
Forum: Camaro DIY & HOW-TO instructions & discussions 06-17-2022, 01:22 AM
Replies: 37
Views: 11,049
Posted By NorCalLT1
Hopefully someone chimes in about this because if...

Hopefully someone chimes in about this because if this can work that would be awesome. and did swapping the harness get everything working correctly?
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 12-15-2020, 07:00 PM
Replies: 6
Views: 1,088
Posted By NorCalLT1
s346k i completely agree with you. i hate how it...

s346k i completely agree with you. i hate how it goes together too. all wavy with gaps. of course the bolts that go into the head help seal all that up but its still suspect. the allen heads that...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 12-15-2020, 05:44 PM
Replies: 6
Views: 1,088
Posted By NorCalLT1
I did try threading the bolts right into the head...

I did try threading the bolts right into the head and they seemed fine. I didn't torque them to spec but I snugg them up. Also I did remove the factory heat shield and used the high temp adhesive...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 12-15-2020, 04:45 PM
Replies: 6
Views: 1,088
Posted By NorCalLT1
Well i just removed the manifold and now im...

Well i just removed the manifold and now im confused. I could not see any visible damage to any of the threads in the head or the bolts going into the head. i attached a couple pics of the threads...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 12-15-2020, 02:48 PM
Replies: 6
Views: 1,088
Posted By NorCalLT1
Stripped heads from IM help

Recently my car was running like it had a vacuum leak. I have the MSD IM so i decided to check the bolts and there were some loose ones that i retorqued. However there were 2 of the longer bolts...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-06-2020, 12:21 AM
Replies: 23
Views: 4,504
Posted By NorCalLT1
This ^^^^its been verified by SSC

This ^^^^its been verified by SSC
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 11-22-2020, 07:00 PM
Replies: 3
Views: 1,522
Posted By NorCalLT1
i gave up on the passenger side. i cannot get...

i gave up on the passenger side. i cannot get those studs to budge regardless of heat or lube. so i switched my attention to the driver side. i have everything unbolted and now im trying to slide...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 11-22-2020, 11:22 AM
Replies: 3
Views: 1,522
Posted By NorCalLT1
Cat delete/removal

So im trying to remove the passenger primary cat so i can weld an 02 bung. is there a trick to removing the cats? right now im trying to remove the 2 studs mounting the primary to the secondary cat...
Forum: Camaro DIY & HOW-TO instructions & discussions 10-14-2020, 08:00 PM
Replies: 53
Views: 53,908
Posted By NorCalLT1
I have a '19 m6, will this tune work with my car?...

I have a '19 m6, will this tune work with my car? Also what timing should I see with 80% ethanol? If I can use this tune im willing to try because I've installed and activated my sensor and...
Forum: Tuning / Diagnostics 10-07-2020, 12:38 PM
Replies: 7
Views: 2,195
Posted By NorCalLT1
Yes, i populated the stoich table for ethonol and...

Yes, i populated the stoich table for ethonol and i can see that the AFR is adjusted for whatever ethonol % is present as well.
Forum: Tuning / Diagnostics 10-07-2020, 08:12 AM
Replies: 7
Views: 2,195
Posted By NorCalLT1
Ok, I thought from the factory it had a tune that...

Ok, I thought from the factory it had a tune that advanced it a certain amount. Thanks
Forum: Tuning / Diagnostics 10-06-2020, 10:14 PM
Replies: 7
Views: 2,195
Posted By NorCalLT1
so any reason why mine is so low? I was at 80%.

so any reason why mine is so low? I was at 80%.
Forum: Tuning / Diagnostics 10-06-2020, 09:38 PM
Replies: 7
Views: 2,195
Posted By NorCalLT1
Flex fuel and WOT timing question

i just installed my flex fuel sensor and i'm the stock tune. I was curious what timing people are seeing at WOT. when i looked at my data the ethonol content was 80% and my WOT timing was 21-22...
Forum: ZL1 Discussions 08-02-2020, 07:13 PM
Replies: 28
Views: 4,958
Posted By NorCalLT1
So i live close enough to drive to summit in NV. ...

So i live close enough to drive to summit in NV. will i have any issues driving there and buying it in person or will they check where i live first?
Forum: Dragstrip and Launching Discussion 03-19-2020, 03:45 AM
Replies: 28
Views: 7,457
Posted By NorCalLT1
so all this talk about torque management tuning...

so all this talk about torque management tuning to prevent bogs, is this a 1LE fix or an M6 fix? i have an SS (not 1LE) and have to slip the clutch to get a decent launch. in my experience theres...
Forum: Dragstrip and Launching Discussion 01-11-2020, 06:31 PM
Replies: 417
Views: 173,526
Posted By NorCalLT1
Stock M6

I just picked up my car a month or so ago and took it out the first time a couple weeks ago. The car is stock and had about 800 miles on it. It was my first time taking her out and launching this...
Forum: USA - California 01-11-2020, 02:58 PM
Replies: 241
Views: 52,640
Posted By NorCalLT1
Elk Grove 916 here!!!

Elk Grove 916 here!!!
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 12-09-2019, 12:16 PM
Replies: 5
Views: 1,630
Posted By NorCalLT1
thanks for responses guys. the possible cam swap...

thanks for responses guys. the possible cam swap would be the only thing i would do that isnt carb legal. everything else i would keep smog legal like exhaust and what not. but i figured theres no...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 12-01-2019, 09:39 PM
Replies: 5
Views: 1,630
Posted By NorCalLT1
Has anyone in CA done it?

hello everyone, i've been lurking around here a while. this is my first post and i was wondering if anyone has cammed their car and actually smogged it in CA? is a mild cam possible? i'm so...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-06-2019, 01:36 AM
Replies: 6
Views: 2,559
Posted By NorCalLT1
i plan on getting msd IM, CAI since thats a quick...

i plan on getting msd IM, CAI since thats a quick easy swap, cnc ported heads since visually they will be the same, lt5 TB, and e85. i doubt any of those should be an issue. just debating whether...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-05-2019, 03:47 PM
Replies: 6
Views: 2,559
Posted By NorCalLT1
For all my California owners

Hello, new to the forum and have been reading various posts on here for a while. Since i live in CA i know i'm very limited in what i can do to my car. So my question is, has anyone installed a...
Showing results 1 to 25 of 25

 
Forum Jump

All times are GMT -5. The time now is 06:06 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.