Homepage Garage Wiki Register Members List Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 30 of 500
Search took 0.07 seconds.
Search: Posts Made By: ICTsccaCamaro
Forum: Suspension / Chassis / Brakes 12-12-2019, 01:40 PM
Replies: 22
Views: 2,676
Posted By ICTsccaCamaro
Still have sets available?

Still have sets available?
Forum: Wheels | Tires -- Sponsored by The Tire Rack 12-11-2019, 10:10 AM
Replies: 9
Views: 293
Posted By ICTsccaCamaro
I run the 355's ACR Kumhos on the rear of mine...

I run the 355's ACR Kumhos on the rear of mine and love the traction
Forum: ZL1 Discussions 12-09-2019, 10:13 AM
Replies: 21
Views: 899
Posted By ICTsccaCamaro
Damn, thank you for your time and research!

Damn, thank you for your time and research!
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-03-2019, 09:53 AM
Replies: 9
Views: 955
Posted By ICTsccaCamaro
I replace my down shaft tube every oil change...

I replace my down shaft tube every oil change because racecar, I normally keep a few down shaft tubes in the trunk because not all autoparts stores will have them in stock and I want to make sure...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 11-27-2019, 09:13 AM
Replies: 26
Views: 1,358
Posted By ICTsccaCamaro
Just got mine paid off last month also, it feels...

Just got mine paid off last month also, it feels pretty good.
Forum: ZL1 Discussions 11-21-2019, 09:45 AM
Replies: 11
Views: 615
Posted By ICTsccaCamaro
I'm running a 305 front and a 355 rear currently...

I'm running a 305 front and a 355 rear currently on mine for track and autocross use
Forum: ZL1 Discussions 11-17-2019, 10:42 PM
Replies: 4
Views: 508
Posted By ICTsccaCamaro
The 2 3/4" band clamps fit over the 3" borla...

The 2 3/4" band clamps fit over the 3" borla pipes without to much of a fight?
Forum: ZL1 Discussions 11-13-2019, 05:25 PM
Replies: 4
Views: 508
Posted By ICTsccaCamaro
Borla 60626 install with factory exhaust.

For those of you that have installed the Borla 60626 onto your factory ZL1 exhaust, do you just butt the borla 3" pipe up to the factory 3in pipe and use a 3" sleeve style exhaust clamp like this...
Forum: Camaro DIY & HOW-TO instructions & discussions 11-13-2019, 08:49 AM
Replies: 1
Views: 281
Posted By ICTsccaCamaro
I took the few screws out of the very lower...

I took the few screws out of the very lower section of the rear bumper, stick my hand up there and took the screws out for the reflectors and swapped them. Wasn't too bad.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 11-01-2019, 09:39 AM
Replies: 57
Views: 4,348
Posted By ICTsccaCamaro
Do this and have a much better car in the future.

Do this and have a much better car in the future.
Forum: Road Course/Track and Autocross 10-29-2019, 04:42 PM
Replies: 24
Views: 1,008
Posted By ICTsccaCamaro
I have ran all of these different tire sets on...

I have ran all of these different tire sets on mine with no issues, also one of my sets of wheels does not have TPS.

305/30R19 front
325/30R19 rear

285/35R19 front
285/35R19 rear

305/30R19...
Forum: Wheels | Tires -- Sponsored by The Tire Rack 10-25-2019, 11:19 AM
Replies: 10
Views: 1,190
Posted By ICTsccaCamaro
I was planning on buying a set for track use but...

I was planning on buying a set for track use but really didn't want to lose the tire width, and ended up on 305 front Bridgestone RE-71r's and 355 rear Kumho ACR's and am very happy with the grip.
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 10-22-2019, 05:45 PM
Replies: 26
Views: 2,215
Posted By ICTsccaCamaro
Damn that looks really good, so you are using...

Damn that looks really good, so you are using Torque Pro and abd2aa and it is good? You also using a bluetooth device for torque correct?
Forum: ZL1 Discussions 10-18-2019, 11:33 PM
Replies: 24
Views: 2,099
Posted By ICTsccaCamaro
The ZL1 1LE is in SS with 200tw tires and SSR...

The ZL1 1LE is in SS with 200tw tires and SSR with A7's
Forum: ZL1 Discussions 10-18-2019, 10:23 AM
Replies: 24
Views: 2,099
Posted By ICTsccaCamaro
When you are setting up a car for track vs....

When you are setting up a car for track vs. autocross vs. drag, the ability to adjust front and rear camber, caster is needed. And no 99% of SRT vehicles do not have -2* of camber from the factory...
Forum: ZL1 Discussions 10-17-2019, 10:16 AM
Replies: 24
Views: 2,099
Posted By ICTsccaCamaro
But the C8 will have suspension adjustment so...

But the C8 will have suspension adjustment so what is your point?
Forum: ZL1 Discussions 10-16-2019, 09:25 AM
Replies: 24
Views: 2,099
Posted By ICTsccaCamaro
The lack of camber adjustment on the LX platform...

The lack of camber adjustment on the LX platform vs. the 5th and 6th gen platform is a huge difference if you are actually planning on using the car.
So yes your opinion is wrong.
Forum: ZL1 Discussions 10-16-2019, 09:18 AM
Replies: 24
Views: 2,099
Posted By ICTsccaCamaro
With no camber adjustability front or rear the...

With no camber adjustability front or rear the LC/LX platform is not something I would want to take on a road course at speed.
Forum: ZL1 Discussions 10-15-2019, 01:14 PM
Replies: 44
Views: 2,171
Posted By ICTsccaCamaro
And this is a bad thing? The C8 is the poor mans...

And this is a bad thing? The C8 is the poor mans Ferrari 458.
Forum: ZL1 Discussions 10-15-2019, 01:12 PM
Replies: 12
Views: 873
Posted By ICTsccaCamaro
I've only used factory GM fluid for my rear axle...

I've only used factory GM fluid for my rear axle and trans.
Forum: ZL1 Discussions 10-15-2019, 12:20 AM
Replies: 8
Views: 435
Posted By ICTsccaCamaro
The car has never felt better and more gripped up...

The car has never felt better and more gripped up now with the 305 and 355 set up, I am running a Bridgestone RE71r in the front and a kumho ACR in the rear.
Forum: ZL1 Discussions 10-15-2019, 12:18 AM
Replies: 8
Views: 435
Posted By ICTsccaCamaro
The stock 19x12, Kumho recommends a 12-13in wheel...

The stock 19x12, Kumho recommends a 12-13in wheel for the 355. They are a little pokey but just barely clear with the rear camber set a -2.3° in the rear with the camber curve under compression....
Forum: ZL1 Discussions 10-14-2019, 06:28 PM
Replies: 8
Views: 435
Posted By ICTsccaCamaro
I have ran all of these different tire sets on...

I have ran all of these different tire sets on mine with no issues

305/30R19 front
325/30R19 rear

285/35R19 front
285/35R19 rear

305/30R19 front
305/30R19 rear
Forum: ZL1 Discussions 10-13-2019, 12:35 PM
Replies: 10
Views: 704
Posted By ICTsccaCamaro
Im running 355/30R19's on the rear of my ZLE and...

Im running 355/30R19's on the rear of my ZLE and at 27.4in tall I have no issues
Forum: 2016+ Camaro: 6th Gen Camaro general forum 10-11-2019, 10:39 AM
Replies: 16
Views: 1,028
Posted By ICTsccaCamaro
Etrack with wheel straps is the best way to tie...

Etrack with wheel straps is the best way to tie down, with anything else you are just compressing the suspension for no reason the whole time you are towing. Every major auto transport company uses...
Forum: ZL1 Discussions 10-07-2019, 01:10 PM
Replies: 3
Views: 372
Posted By ICTsccaCamaro
Track drive mode with all nannies off for...

Track drive mode with all nannies off for autocross and track drive mode with PTM in race mode for trackdays
Forum: ZL1 Discussions 09-26-2019, 09:56 AM
Replies: 26
Views: 803
Posted By ICTsccaCamaro
I would definitely agree if someone was running a...

I would definitely agree if someone was running a weird 4th tire heith that did not match the other 3 on the car the car could definitely think something was wrong and activate traction control ect.
Forum: ZL1 Discussions 09-26-2019, 08:55 AM
Replies: 26
Views: 803
Posted By ICTsccaCamaro
You will need to relocate the wiring harness in...

You will need to relocate the wiring harness in the front of the drivers rear wheel well as it is close and pin the inner fender back to the wiring harness clip location, I have ran autocross and...
Forum: ZL1 Discussions 09-26-2019, 08:53 AM
Replies: 26
Views: 803
Posted By ICTsccaCamaro
Did you not see my post with my tire height???...

Did you not see my post with my tire height??? How can you agree with someone that is wrong?
Forum: ZL1 Discussions 09-26-2019, 08:49 AM
Replies: 26
Views: 803
Posted By ICTsccaCamaro
I already am running front and rear tires with an...

I already am running front and rear tires with an overall diameter of over 1" difference.
The factory heights are 26.2" front and 26.7" rear, I'm currently running 26.2" front and 27.4" rear, with...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 03:39 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2019, vBulletin Solutions, Inc.