Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


AWE Tuning


Page 1 of 2 1 2
Showing results 1 to 30 of 42
Search took 0.00 seconds. Search: Posts Made By: CW3SF
Forum: ZL1 Discussions 11-19-2022, 06:06 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Thanks. I think it would totally depend on which...

Thanks. I think it would totally depend on which track you are running. On a course with longer straights and higher speeds I think you’ll see a huge benefits. All the OEM aids are still there and...
Forum: ZL1 Discussions 11-18-2022, 06:14 PM
Replies: 103
Views: 12,791
Posted By CW3SF
Just wanted to close the loop on this build. At...

Just wanted to close the loop on this build. At 350ft altitude (sea level basically) this build made 740whp uncorrected on e50 blend with difficultly getting traction on the dyno. Here’s the thread...
Forum: ZL1 Discussions 05-21-2022, 01:59 PM
Replies: 103
Views: 12,791
Posted By CW3SF
Not stepping on it at all. Interesting discussion.

Not stepping on it at all. Interesting discussion.
Forum: ZL1 Discussions 05-21-2022, 01:59 PM
Replies: 103
Views: 12,791
Posted By CW3SF
I asked my tuner about that and he said it...

I asked my tuner about that and he said it shouldn’t make more heat because the blower isn’t spinning any faster. He thought the ported blower would run cooler than an unported blower. But I don’t...
Forum: ZL1 Discussions 05-21-2022, 09:01 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Correct. If I drove the car down to sea level I...

Correct. If I drove the car down to sea level I would likely have to reduce the ethanol blend down to e60ish. And the boost would go up about 2.5 lbs.
Forum: ZL1 Discussions 05-20-2022, 08:34 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Thanks. Personally I doubt a new lid does...

Thanks.

Personally I doubt a new lid does much of anything besides change appearance. I may do one later but I wouldnt expect any performance gain at all. I didn’t look at them during this build...
Forum: ZL1 Discussions 05-19-2022, 09:59 PM
Replies: 103
Views: 12,791
Posted By CW3SF
An added benefit to this build is that the blower...

An added benefit to this build is that the blower whine is noticeably louder. I removed the sound dampening plate from the lid. That combined with the switch to the Big Gulp and the Kong porting...
Forum: ZL1 Discussions 05-19-2022, 08:11 PM
Replies: 103
Views: 12,791
Posted By CW3SF
:crazy: You’re good man, please do...

:crazy:

You’re good man, please do contribute. That’s what it’s all about.

I’ll add that I was surprised just how easy it is to R&R the blower, HPFP and Injectors. Shops shouldn’t be charging...
Forum: ZL1 Discussions 05-19-2022, 06:01 PM
Replies: 103
Views: 12,791
Posted By CW3SF
Yes sir. I put some miles on this afternoon. It...

Yes sir. I put some miles on this afternoon. It pulls hard to redline. It’s quite a hoot to drive.
Forum: ZL1 Discussions 05-19-2022, 06:00 PM
Replies: 103
Views: 12,791
Posted By CW3SF
It’s all gonna get done eventually anyways. Just...

It’s all gonna get done eventually anyways. Just pick one and roll with it LOL. There’s no stopping at 725. :bonk:
Forum: ZL1 Discussions 05-19-2022, 04:08 PM
Replies: 103
Views: 12,791
Posted By CW3SF
Thanks Aaron. I appreciate it.

Thanks Aaron. I appreciate it.
Forum: ZL1 Discussions 05-19-2022, 11:52 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Interesting. That’s good to know. The rub will be...

Interesting. That’s good to know. The rub will be not increasing heat too much.
Forum: ZL1 Discussions 05-19-2022, 11:26 AM
Replies: 103
Views: 12,791
Posted By CW3SF
My tuner said that my low side is good and my...

My tuner said that my low side is good and my limiting factor is still the high side. He recommends a cam with fuel lobe next for the high side. You can see in my graph the HP was still climbing at...
Forum: ZL1 Discussions 05-19-2022, 11:23 AM
Replies: 103
Views: 12,791
Posted By CW3SF
XDI sells both as a pkg for $4299

XDI sells both as a pkg for $4299
Forum: ZL1 Discussions 05-19-2022, 11:20 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Thx, Good points. The injectors were very easy to...

Thx, Good points. The injectors were very easy to do also, since everything that’s in the way is already removed.
Forum: ZL1 Discussions 05-19-2022, 11:00 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Sorry, I didn’t think to ask that. He does all...

Sorry, I didn’t think to ask that. He does all their runs in SAE. My last run before these mods was 650 SAE on same dyno so 64 whp gain and able to run 15 points higher of ethanol. Glad to be using...
Forum: ZL1 Discussions 05-19-2022, 10:28 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Just picked up the car. Did a final pull on...

Just picked up the car.

Did a final pull on 91 this morning and made 627 SAE.

Final numbers are 713.81rwhp and 660.57rwtrq SAE. This was on indicated e84 (on HP Tuners) and 10 lbs of boost....
Forum: ZL1 Discussions 05-19-2022, 08:04 AM
Replies: 103
Views: 12,791
Posted By CW3SF
I’m not sure what to think at this point LOL. I...

I’m not sure what to think at this point LOL. I would love to see 700whp but everything is always lower at this altitude. I’ll be ok with whatever it makes. I’m not sure it can pick up 80 more rwhp...
Forum: ZL1 Discussions 05-19-2022, 06:57 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Dynojet. Near Denver, so the numbers are going to...

Dynojet. Near Denver, so the numbers are going to be lower than elsewhere. The 621 pull on 91 would probably be 640 at normal altitude.
Forum: ZL1 Discussions 05-18-2022, 06:28 PM
Replies: 103
Views: 12,791
Posted By CW3SF
Well, my tuner got pulled into something else and...

Well, my tuner got pulled into something else and wasn’t able to get back to my car today. Maybe tomorrow LOL.

I got a look at a dyno run from this morning where he was dialing in AFR for 91...
Forum: ZL1 Discussions 05-18-2022, 10:59 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Dyno operator got behind schedule. Doing pulls...

Dyno operator got behind schedule. Doing pulls right now. Should hopefully have results today.
Forum: ZL1 Discussions 05-16-2022, 03:45 PM
Replies: 103
Views: 12,791
Posted By CW3SF
Dyno is delayed a day. Sounds like they had a car...

Dyno is delayed a day. Sounds like they had a car with a problem still on the dyno from Friday. Mines still sitting where I parked it this morning. Stuff happens. Hopefully tomorrow.
Forum: ZL1 Discussions 05-16-2022, 10:14 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Good point. Boost will go up but blower RPM will...

Good point. Boost will go up but blower RPM will not.
Forum: ZL1 Discussions 05-16-2022, 10:11 AM
Replies: 103
Views: 12,791
Posted By CW3SF
Correct. Stock pulley. I think it’s a mistake to...

Correct. Stock pulley. I think it’s a mistake to spin the 1.7L harder without extensive cooling mods. I want to see just how much power it can make on stock pulley. Will know soon LOL.
Forum: ZL1 Discussions 05-16-2022, 09:33 AM
Replies: 103
Views: 12,791
Posted By CW3SF
It’s dropped at the tuner. He has another car to...

It’s dropped at the tuner. He has another car to finish up before he starts mine so hopefully he gets it done today.
Forum: ZL1 Discussions 05-15-2022, 02:32 PM
Replies: 103
Views: 12,791
Posted By CW3SF
Startup went without a hitch. Started up quickly...

Startup went without a hitch. Started up quickly and idles great. Drive low rpm around subdivision and no issues. Dyno tomorrow.

http://youtu.be/NpUTwtzRF5U
Forum: ZL1 Discussions 05-14-2022, 10:55 PM
Replies: 103
Views: 12,791
Posted By CW3SF
The supercharger R&R was easier than I...

The supercharger R&R was easier than I anticipated. This car is super easy to work on. And there are lots of videos on the tube showing how to do it. HPFP and injectors were also surprisingly easy....
Forum: ZL1 Discussions 05-14-2022, 09:18 PM
Replies: 103
Views: 12,791
Posted By CW3SF
Took delivery of Supercharger from UPS around 1pm...

Took delivery of Supercharger from UPS around 1pm today and have it completely buttoned up and ready to fire now. Decided to wait till tomorrow to start it. I actually spent more time tying in the...
Forum: ZL1 Discussions 05-12-2022, 08:36 PM
Replies: 103
Views: 12,791
Posted By CW3SF
https://www.camaro6.com/forums/picture.php?albumid...

https://www.camaro6.com/forums/picture.php?albumid=21491&pictureid=169304
Forum: ZL1 Discussions 05-12-2022, 05:18 PM
Replies: 103
Views: 12,791
Posted By CW3SF
Received UPS update today saying that my...

Received UPS update today saying that my Supercharger won’t make it here until Saturday (originally said today). In the mean time I have everything done that can be done ahead of time, including...
Showing results 1 to 30 of 42
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 11:59 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.