Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Phastek Performance


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.06 seconds. Search: Posts Made By: brettman
Forum: Forced Induction Discussions 05-03-2018, 09:26 AM
Replies: 17
Views: 5,165
Posted By brettman
Just above MAP,

Just above MAP,
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 05-03-2018, 06:37 AM
Replies: 6
Views: 1,431
Posted By brettman
Went with Focal 6x9 3 way all around (4) doing...

Went with Focal 6x9 3 way all around (4) doing the package tray next. And rear quarters with JVC 2 way. Amp and LC7I on the list. Tweeters, unknown at this time, if I just disconnect or replace them....
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 05-02-2018, 10:44 AM
Replies: 6
Views: 1,431
Posted By brettman
LOL, When I unplugged it, it wasn't the mic. It...

LOL, When I unplugged it, it wasn't the mic. It was getting dark and I was rushing. SO....I'm a stupid A$$. Upside: Factory installed clips need replaced.
I moved all the good ones to the driver...
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 05-02-2018, 06:09 AM
Replies: 6
Views: 1,431
Posted By brettman
after some research, I'm see that only two wires...

after some research, I'm see that only two wires at the amp are for mic.
That plug, (upper rear location) had 4 wires, I think.
I'll look more into today, removing driver side later.
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 05-01-2018, 01:06 PM
Replies: 6
Views: 1,431
Posted By brettman
Unplugged mic, window not working properly

Upgrading audio, passenger side speaker installed, mic disconnected.
Window doesn't drop when opened, and stays up when closing?? Driver side still works properly (mic still connected) NO speaker...
Forum: Cosmetic modifications (exterior and interior) 04-26-2018, 10:38 AM
Replies: 9
Views: 3,149
Posted By brettman
My opinion, "they are large". In the vents they...

My opinion, "they are large". In the vents they are less bold.
I have SC emblems on my hood, but they are small, it's all about flow.
Forum: Member Car Journals 04-24-2018, 04:06 PM
Replies: 168
Views: 37,092
Posted By brettman
No codes, even when I test drove it. How ever I...

No codes, even when I test drove it.
How ever I ran the stock MAP till tune and dyno.
After that I got ALL kinds of codes.
That shop was just learning how to tune.
Forum: Member Car Journals 04-24-2018, 09:48 AM
Replies: 168
Views: 37,092
Posted By brettman
Mine did the same thing After a couple heat...

Mine did the same thing
After a couple heat cycles, it was back to normal.
Forum: Member Car Journals 04-15-2018, 07:46 PM
Replies: 168
Views: 37,092
Posted By brettman
Rob, have fun. Not the end of the story.

Rob, have fun. Not the end of the story.
Forum: Forced Induction Discussions 04-12-2018, 10:49 AM
Replies: 74
Views: 13,480
Posted By brettman
I know I sent you PM's on some drivable fix's. ...

I know I sent you PM's on some drivable fix's.
I just hate to see this, even thus I experienced it.
I hope it works out, If the installer don't know........
Don't touch it!!!!
Forum: Forced Induction Discussions 04-11-2018, 06:28 PM
Replies: 74
Views: 13,480
Posted By brettman
Ask him about the MAP, or if anybody can confirm....

Ask him about the MAP, or if anybody can confirm. I was told I would be OK with pumps and injector swap driving mine (but has a custom tune)
But good luck, i hope can help.
Forum: Forced Induction Discussions 04-11-2018, 06:07 PM
Replies: 74
Views: 13,480
Posted By brettman
What a shame. If you unplug the 3bar MAP,...

What a shame. If you unplug the 3bar MAP, reinstall the OEM MAP (front LH side) Just left of the 06/ and plug into it, it will run OK. Drive it like Grandma.
I ran mine with NO codes. Get that CAR...
Forum: ZL1 Discussions 04-10-2018, 06:28 PM
Replies: 18
Views: 8,040
Posted By brettman
I have the same thing with my Whipple. As do...

I have the same thing with my Whipple. As do other SC people.
I went round an round with Whipple, Cause when I installed it it wasn't there.
TIP: close the hood!
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 04-10-2018, 12:42 PM
Replies: 21
Views: 10,771
Posted By brettman
Thanks Buddy, you have been most helpfully. ...

Thanks Buddy, you have been most helpfully.
This issue seems to be quite an issue.
Sad thing is most people don't do research.
Just ask to make a decision...LOL
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-10-2018, 11:51 AM
Replies: 5
Views: 1,693
Posted By brettman
Remember, tone/exhaust is out the back. ...

Remember, tone/exhaust is out the back.
Rattle/vibration/cockpit is interior. Separate the two.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-10-2018, 09:16 AM
Replies: 5
Views: 1,693
Posted By brettman
No, jack it up, inspect it. Something must have...

No, jack it up, inspect it. Something must have changed.
EX: pipe touching body (vibration transfer). If it was good before????????
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 04-10-2018, 09:12 AM
Replies: 29
Views: 14,138
Posted By brettman
After all the research (hope I didn't pick your...

After all the research (hope I didn't pick your brain clean KingLT1)
IMHO, the 1SS system is real worth it (another plus) EX: Pop the truck access the audio system. Old school: lay on your back...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-10-2018, 07:34 AM
Replies: 6
Views: 1,283
Posted By brettman
I haven't had a problem. Besides having to change...

I haven't had a problem. Besides having to change to a 45 degree fitting,
I teflon taped mine.
Forum: Member Car Journals 04-10-2018, 07:27 AM
Replies: 21
Views: 10,727
Posted By brettman
I'm all set-up for that job too. Just need some...

I'm all set-up for that job too. Just need some good weather. Looks like 4-12/ 4-13 suppose to be nice. Made speaker templates depending on mounting surfaces.
Then I can cut my rubber mat (vibration...
Forum: Member Car Journals 04-10-2018, 07:16 AM
Replies: 21
Views: 10,727
Posted By brettman
Next up is ZL1 shirts (or rockers) I have started...

Next up is ZL1 shirts (or rockers) I have started a thread on that mod, due to having GM splash guards.

And then up-grading the audio
Forum: Member Car Journals 04-10-2018, 07:08 AM
Replies: 21
Views: 10,727
Posted By brettman
Late, but engine finished

Late, but engine finished
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-10-2018, 06:04 AM
Replies: 6
Views: 1,283
Posted By brettman
I went with the Mishimoto as you can see. I too...

I went with the Mishimoto as you can see. I too was concerned about access draining it, so I installed a petcock. Then in between oil changes I remove and washout. Has worked well, I had deposits...
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 04-10-2018, 05:50 AM
Replies: 21
Views: 10,771
Posted By brettman
I have 4 of those speakers sitting for install....

I have 4 of those speakers sitting for install. (also going rear deck)
And replacing the 6-1/2 rear side panels. A friend replaced his with the Focals
(same GM radio, i believe) sounds great. The...
Forum: Cosmetic modifications (exterior and interior) 04-10-2018, 05:37 AM
Replies: 11
Views: 3,279
Posted By brettman
I see you ordered those emblems on Ebay, Nice. I...

I see you ordered those emblems on Ebay, Nice. I installed some emblems on the fenders, like old school school. All my SS cars had them on the fenders, just like emblems on the hood. Then I see some...
Forum: Forced Induction Discussions 04-09-2018, 04:46 PM
Replies: 7
Views: 2,252
Posted By brettman
Tell them what you want. I think its the owner...

Tell them what you want. I think its the owner son that does all the layout.
I can't remember the guys name (talk to him on the phone) nice people.
Told them what I wanted (size, color, font)...
Forum: Forced Induction Discussions 04-09-2018, 04:22 PM
Replies: 7
Views: 2,252
Posted By brettman
http://www.emblempros.com/inc/sdetail/3448/66033 ...

http://www.emblempros.com/inc/sdetail/3448/66033

Thanks
I had him reverse the emblems so the would be slanted the same directions both sides. (like being blown back) Also I had them smaller....
Forum: Forced Induction Discussions 04-09-2018, 01:57 PM
Replies: 7
Views: 2,252
Posted By brettman
here's mine

here's mine
Forum: Forced Induction Discussions 04-08-2018, 11:29 AM
Replies: 64
Views: 49,537
Posted By brettman
Well, I'll throw my worthless two cents in here....

Well, I'll throw my worthless two cents in here. I am a firm believer that a stock
block is good (safe) to 10 LBS of boost. I have NOT dealt with the (stock SS) fuel systems yet. But we all know:...
Forum: Cosmetic Maintenance - Wash, Wax, Detailing, Exterior Repairs 04-08-2018, 06:33 AM
Replies: 7
Views: 1,690
Posted By brettman
Ya, I got mine already. Not to bad, a little...

Ya, I got mine already. Not to bad, a little filing and paint touch-up.
If your's is really bad you can fiberglass it (make it strong again) then filler.
Post a pic.
Forum: Cosmetic modifications (exterior and interior) 04-07-2018, 07:08 AM
Replies: 13
Views: 6,494
Posted By brettman
Added complication?? That is not in my...

Added complication?? That is not in my vocabulary.
Man made it... it WILL come apart...lol.
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 02:41 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.