Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 30 of 70
Search took 0.01 seconds.
Search: Posts Made By: GN_Drake
Forum: Forced Induction Discussions 01-12-2022, 09:18 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
I only show one log with a 60-130, not sure what...

I only show one log with a 60-130, not sure what my settings were back then. Mexico is a long trip, normally I keep it tame.

I need to get it back out. Been messing with this SSR I bought the...
Forum: Forced Induction Discussions 12-08-2021, 06:37 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Don't come in here tag teaming Jabroni! Lol ...

Don't come in here tag teaming Jabroni! Lol

I killed that 2.0 launch like a boss!
Forum: Forced Induction Discussions 12-08-2021, 05:22 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Ha. Not arguing the need for driver mod

Ha. Not arguing the need for driver mod
Forum: Forced Induction Discussions 12-05-2021, 09:22 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Driver mod needed.... First fill pull from dig...

Driver mod needed....
First fill pull from dig in Mexico. Had to shut it down early for safety.
Forum: Forced Induction Discussions 11-08-2021, 12:18 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Had a solid run while scanning the no meth tunes....

Had a solid run while scanning the no meth tunes. Custom 40-110mph due to Mexico not being long enough of a strip. This in only at 10.5#.

Should have enough to get to 12# on e50 once we have a...
Forum: Forced Induction Discussions 11-07-2021, 02:16 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
No reason in particular. Gauge setup is easier...

No reason in particular. Gauge setup is easier than the two modules the Alkycontrol comes with. I have Alkycontrol on my GN and worked flawlessly for a decade plus.

Regret that decision now......
Forum: Forced Induction Discussions 11-06-2021, 12:32 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Ok, so I have been battling this meth coming on...

Ok, so I have been battling this meth coming on late during boost tip in... I got ahold of nitrous express, and only way for them to diagnose the Snow setup, is for me to send them the...
Forum: Forced Induction Discussions 10-26-2021, 06:51 AM
Replies: 117
Views: 19,855
Posted By GN_Drake
Agree, it's not on that planet. It's only...

Agree, it's not on that planet. It's only pushing 12# and 13# on shifts. So it's not going full send by any means. If I found a way to fit a full 4" dp, then it would have alot more steam to work...
Forum: Forced Induction Discussions 10-25-2021, 09:25 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Lt4 high and low side plus aux pump. +30...

Lt4 high and low side plus aux pump.
+30 injectors.
+32 cam.
Meth.

I've done 40-110 on draggy, but not 60-130. Mexico is far away...
Forum: Forced Induction Discussions 10-24-2021, 06:00 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Baby update: Adjusting sensitivity in...

Baby update:

Adjusting sensitivity in Eboost2 fixed the boost taper through RPM. Just need to finalize boost tip in before meth hits and tune is pretty close to dialed. 18* timing and 12.5# is a...
Forum: Forced Induction Discussions 10-13-2021, 08:07 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Little update. Boost maxing at 9# was due to...

Little update.

Boost maxing at 9# was due to the baby spring in WG. Put a 7# spring in on Monday and saw 12# on low boost setting. Adjusted controller and can now adjust boost from 7# to 13#. ...
Forum: Forced Induction Discussions 09-10-2021, 10:43 PM
Replies: 488
Views: 94,606
Posted By GN_Drake
That lt4 pump upgrade was not my favorite...

That lt4 pump upgrade was not my favorite thing.... But def helped my car.

Was gonna go mess withy car on street tonight, until I realized it hadn't been inspected in over a year... Good call
Forum: Forced Induction Discussions 09-10-2021, 10:40 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Well, she is back. Pulled in last night around...

Well, she is back. Pulled in last night around 11pm

Eboost2 fixed low boost adjustments, but max boost is currently set to 9#, which is plenty for the street based on the one hit I did on my...
Forum: Forced Induction Discussions 09-01-2021, 09:36 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Earlier today diagnosing controller

Earlier today diagnosing controller
Forum: Forced Induction Discussions 09-01-2021, 09:09 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Well, ended up being the AEM after all. Confirmed...

Well, ended up being the AEM after all. Confirmed by taking out of the loop and immediately boost went over 10#.

Just ordered Eboost2 to replace and combine the meth into one controller. Flight...
Forum: Forced Induction Discussions 08-10-2021, 08:23 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Up to 720whp now on E63 with injectors around...

Up to 720whp now on E63 with injectors around 4.2ms. This is with 10# dropping to 8-9# at shift. I didn't ask about timing when I was talking to them. Didn't think this was bad power at 10# and a 3"...
Forum: Forced Induction Discussions 08-09-2021, 08:24 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Injectors are in, hoping it's on Dyno tomorrow...

Injectors are in, hoping it's on Dyno tomorrow for finally tune to start and add E.
Forum: Forced Induction Discussions 08-05-2021, 10:06 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
New injectors finally got delivered today. Now I...

New injectors finally got delivered today. Now I wait until they can get them installed and finally tune on flex. Light at the end...
Forum: Forced Induction Discussions 08-05-2021, 10:40 AM
Replies: 117
Views: 19,855
Posted By GN_Drake
Forgot to mention they stopped at 8# of boost and...

Forgot to mention they stopped at 8# of boost and 680whp on gas with the old LT4 injectors. Hopeful to hit a safe 750-800 and be happy for awhile.

If the DP restriction doesn't become a limiting...
Forum: Forced Induction Discussions 08-02-2021, 09:31 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
New injectors should get to GPI this week....

New injectors should get to GPI this week. Hopefully see some numbers on E by end of week or early next week... Fingers crossed.
Forum: Forced Induction Discussions 07-16-2021, 10:12 AM
Replies: 488
Views: 94,606
Posted By GN_Drake
You make me feel like my luck isn't so bad after...

You make me feel like my luck isn't so bad after all. Thanks Choda
Forum: Forced Induction Discussions 07-15-2021, 11:32 AM
Replies: 117
Views: 19,855
Posted By GN_Drake
Ended up being the new injectors. Called FIC,...

Ended up being the new injectors. Called FIC, and they are getting a new set out ASAP. GPI is shipping this set back.

They put my LT4 injectors back in to complete the shakedown tune and check...
Forum: Forced Induction Discussions 07-07-2021, 08:50 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Can't speak to any diagnosis, GPI working through...

Can't speak to any diagnosis, GPI working through and just gave me an update. I trust they will isolate it. Sounds like several issues were fixed from previous shop, and hope to hear more early next...
Forum: Forced Induction Discussions 07-06-2021, 08:55 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Breaking up a little under load. Working on...

Breaking up a little under load. Working on figuring out exactly why. Hoping it's not the brand new injectors. TBD and it'll be getting tuned
Forum: Forced Induction Discussions 06-30-2021, 07:34 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Noted Choda. I'll have to ask if they did. ...

Noted Choda. I'll have to ask if they did.

Got a first-start video today, so it's alive.
Forum: Forced Induction Discussions 06-27-2021, 05:37 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Injectors get there Monday. Could finish up this...

Injectors get there Monday. Could finish up this week or next. Going to look for flights now. Holiday going to mess up my schedule
Forum: Forced Induction Discussions 06-24-2021, 10:41 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Current status. Just shipped out injectors this...

Current status. Just shipped out injectors this morning.
Forum: Forced Induction Discussions 06-23-2021, 06:59 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Engine is now in the car again. I'm shipping the...

Engine is now in the car again. I'm shipping the injectors to them in the morning so they can start buttoning the top up.
Forum: Forced Induction Discussions 06-18-2021, 08:56 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
Hoping this progress continues now.

Hoping this progress continues now.
Forum: Forced Induction Discussions 06-18-2021, 02:16 PM
Replies: 117
Views: 19,855
Posted By GN_Drake
#2

#2
Showing results 1 to 30 of 70

 
Forum Jump

All times are GMT -5. The time now is 01:41 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.