Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


Phastek Performance


Showing results 1 to 30 of 133
Search took 0.02 seconds.
Search: Posts Made By: Yosh6
Forum: Dragstrip and Launching Discussion Today, 05:31 AM
Replies: 2,325
Views: 723,583
Posted By Yosh6
I admire your optimism, Choda, but it is going to...

I admire your optimism, Choda, but it is going to take a whole lot more than "bump" to get these fast lists updated. It is going to take someone who has some authority and can actually do something...
Forum: Dragstrip and Launching Discussion 05-18-2022, 02:03 PM
Replies: 405
Views: 138,211
Posted By Yosh6
:thumbup: +1 If there were a current list;...

:thumbup: +1

If there were a current list; sigh, I would be No. 3 with a 6.765. You are about to blow past that. I know how hard it is to get these bolt-on cars to move like that. You're...
Forum: Dragstrip and Launching Discussion 05-15-2022, 06:05 AM
Replies: 49
Views: 4,916
Posted By Yosh6
In reading your posts I didn't see where you...

In reading your posts I didn't see where you installed the Circle D converter. Can't imagine you doing those 60's with a stock converter. Sounds like you may have the same Circle D that I have, a...
Forum: Dragstrip and Launching Discussion 05-14-2022, 03:40 PM
Replies: 49
Views: 4,916
Posted By Yosh6
[QUOTE=Murder6.2;11173902] Any feedback...

[QUOTE=Murder6.2;11173902]

Any feedback would be appreciated.

1/2 a 1/4 tank of fuel which is how I race it.[QUOTE]


Try 1/8 or less tank of fuel. Weight is weight. gas 7+/- lbs per...
Forum: Dragstrip and Launching Discussion 05-09-2022, 06:30 AM
Replies: 25
Views: 1,733
Posted By Yosh6
There are two light beams in the staging area...

There are two light beams in the staging area similar to the light beams on a garage door opener. The first beam lights the pre-stage light on the top of the tree. It is just a reference and has...
Forum: Dragstrip and Launching Discussion 05-05-2022, 06:46 AM
Replies: 12
Views: 1,141
Posted By Yosh6
Some more discussion of this issue here: ...

Some more discussion of this issue here:


https://www.camaro6.com/forums/showthread.php?t=588702


NOTE: As you will see, apparently, not all Gen 6's react in the same way to removing TPMS...
Forum: Dragstrip and Launching Discussion 05-03-2022, 07:13 AM
Replies: 25
Views: 1,733
Posted By Yosh6
You've gotten some good advice here; but you are...

You've gotten some good advice here; but you are limited at Little River, one of the oldest and narrowest tracks in Texas. It is impossible to drive around the water in either lane. For what it's...
Forum: Dragstrip and Launching Discussion 04-20-2022, 04:56 AM
Replies: 37
Views: 3,513
Posted By Yosh6
DB, I'm not saying it is not a drag radial, it...

DB, I'm not saying it is not a drag radial, it is. But, it is a drag radial SLICK, not a drag radial D.O.T. "D.O.T." being the critical, missing descriptor that would solve our problem. Hoping...
Forum: Dragstrip and Launching Discussion 04-11-2022, 06:37 AM
Replies: 37
Views: 3,513
Posted By Yosh6
Good point and you are correct. Last summer when...

Good point and you are correct. Last summer when tires were so scarce, the NHRA track that I go to said they would allow the DBR in the Street Legal Program because it is a "drag radial" even though...
Forum: Dragstrip and Launching Discussion 04-10-2022, 06:11 AM
Replies: 23
Views: 1,748
Posted By Yosh6
What I do: Track, Manual (with TUTD tables...

What I do: Track, Manual (with TUTD tables populated so the tranny will shift on it's own; and, can choose to launch in 1st or 2nd) all nannies OFF ('16 A-8 - Hold Stabilatrak button down for about...
Forum: Dragstrip and Launching Discussion 04-10-2022, 05:40 AM
Replies: 37
Views: 3,513
Posted By Yosh6
Ditto on the (nearly) impossible to balance...

Ditto on the (nearly) impossible to balance M/T's. I've returned 3 of them in the past three years. Frustrated me, the tire guys, spent hours chasing vibrations that, every time, ended up being the...
Forum: Dragstrip and Launching Discussion 04-08-2022, 06:46 AM
Replies: 23
Views: 1,748
Posted By Yosh6
One more comment on your original question, psi. ...

One more comment on your original question, psi. Generally speaking, and this comes from M/T, the better the traction, track prep, etc. the higher pressure you can and should run. My 18 psi...
Forum: Dragstrip and Launching Discussion 04-08-2022, 06:32 AM
Replies: 23
Views: 1,748
Posted By Yosh6
Sorry, didn't see your post until this morning. ...

Sorry, didn't see your post until this morning. Hope you got to go to the track and hope it went well. Brett @ Pray Performance coaches that 1) best STOCK converter (1,800 rpm stall speed) launch...
Forum: Dragstrip and Launching Discussion 04-07-2022, 06:22 AM
Replies: 23
Views: 1,748
Posted By Yosh6
Good question. I don't know. Removed the rear...

Good question. I don't know. Removed the rear sway bar primarily for the weight reduction and as an experiment to see how the car would launch and go down the track. Removed the muffler and...
Forum: Dragstrip and Launching Discussion 04-05-2022, 12:31 PM
Replies: 23
Views: 1,748
Posted By Yosh6
Correct. I can't prove it, but I think removing...

Correct. I can't prove it, but I think removing or disconnecting the rear sway bar will help the rear squat at the launch. Likewise on the front, except for lift and transfer of weight to rear.
Forum: Dragstrip and Launching Discussion 04-05-2022, 11:13 AM
Replies: 23
Views: 1,748
Posted By Yosh6
This was a dedicated track car for three years so...

This was a dedicated track car for three years so I did a lot to it that I would not do to a street-driven car. Now, most of what I took off is back on and I drive the car on the street and go to...
Forum: Dragstrip and Launching Discussion 04-05-2022, 06:20 AM
Replies: 23
Views: 1,748
Posted By Yosh6
What he said. Don't overdo the burnout. Not a...

What he said. Don't overdo the burnout. Not a recommendation but what I did: Bought a really good pressure gauge 0-30 with 1/4 lb. graduations. M/T says best results are with tire temp within 15...
Forum: Dragstrip and Launching Discussion 03-22-2022, 10:36 AM
Replies: 2,325
Views: 723,583
Posted By Yosh6
Thanks for the reply; good points. I'm not going...

Thanks for the reply; good points. I'm not going to split hairs or argue this point too much because I, too, noticed that word "your". That could imply your car, your entry fee, you signed the tech...
Forum: Dragstrip and Launching Discussion 03-22-2022, 06:05 AM
Replies: 2,325
Views: 723,583
Posted By Yosh6
wnta1ss, while in general I agree with you, with...

wnta1ss, while in general I agree with you, with no one updating the list, what the heck? This list is so screwed up now, (since Merc stopped updating) it is no more than a message board. I'm a...
Forum: Dragstrip and Launching Discussion 03-22-2022, 05:47 AM
Replies: 2,325
Views: 723,583
Posted By Yosh6
Good runs! Great MPH. With those MPH's and a...

Good runs! Great MPH. With those MPH's and a better 60' you can get into the 10.60's; maybe 10.50's (With you in the seat - Ha!). Good going.
Forum: Dragstrip and Launching Discussion 12-20-2021, 05:13 PM
Replies: 405
Views: 138,211
Posted By Yosh6
Driven car a few times now on the street. ...

Driven car a few times now on the street. Converter is fine. No problem.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-18-2021, 01:22 PM
Replies: 0
Views: 423
Posted By Yosh6
Axleback Muffler Delete straight pipes $175 shipped

Axleback Muffler Delete straight pipes $175 shipped to lower 48 states. Were on 2016 1SS with NPP exhaust. Loud (not why I had them; weight reduction was the goal). On car 13 mo., never street...
Forum: Dragstrip and Launching Discussion 12-16-2021, 08:44 AM
Replies: 405
Views: 138,211
Posted By Yosh6
Selling Bogart front skinnies with tires. -...

Selling Bogart front skinnies with tires. - UPdate, Gone.
Forum: Dragstrip and Launching Discussion 12-15-2021, 06:32 AM
Replies: 405
Views: 138,211
Posted By Yosh6
Can't really say. Only driven it in the pits at...

Can't really say. Only driven it in the pits at the drag strip. That is something I need to figure out once I get the car streetable. Plan to do that in the next few weeks and will let you know. ...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-15-2021, 06:18 AM
Replies: 4
Views: 741
Posted By Yosh6
It fits and it works. This setup really shines...

It fits and it works. This setup really shines with higher volume air flow like on a heads/cam motor. Good addition to stock motor with cold air, headers, E-85 and tune with plans to do more later.
Forum: Dragstrip and Launching Discussion 12-14-2021, 05:36 PM
Replies: 405
Views: 138,211
Posted By Yosh6
Thank you. Appreciate it.

Thank you. Appreciate it.
Forum: Dragstrip and Launching Discussion 12-14-2021, 01:24 PM
Replies: 405
Views: 138,211
Posted By Yosh6
Going back closer to stock. Pray ported stock...

Going back closer to stock. Pray ported stock intake manifold and throttle body. Also selling front skinnies, Zero Gravity battery and charger and, most likely, gears (3.27) and converter (Circle D...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-14-2021, 08:11 AM
Replies: 4
Views: 741
Posted By Yosh6
***SOLD*** PRAY Ported MSD Intake & 95mm Throttle Body

**No longer for sale** PRAY Ported MSD Atomic Air Force Intake Manifold and Pray ported 95mm throttle body. Outright sale, no exchange.
Forum: Wheels / Tires 12-14-2021, 07:30 AM
Replies: 0
Views: 443
Posted By Yosh6
*** SOLD ***Skinnies 4.5" X 17" Bogart Fronts w/ M&H Racemaster 4.5" Radial Tires

*** SOLD ****Drag racers, if you are looking for skinnies and to lighten your rotating weight, this is as good as it gets. Looking high and low for the lightest 4.5" front wheels led me to Bogart. ...
Forum: Dragstrip and Launching Discussion 12-14-2021, 06:37 AM
Replies: 405
Views: 138,211
Posted By Yosh6
Thank you.

Thank you.
Showing results 1 to 30 of 133

 
Forum Jump

All times are GMT -5. The time now is 05:52 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2022, vBulletin Solutions, Inc.