Homepage Garage Wiki Register Members List Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Emblempros


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.09 seconds. Search: Posts Made By: laynlo15
Forum: Forced Induction Discussions 01-14-2021, 11:13 AM
Replies: 300
Views: 32,668
Posted By laynlo15
Looking good.

Looking good.
Forum: Forced Induction Discussions 01-14-2021, 11:11 AM
Replies: 29
Views: 4,805
Posted By laynlo15
Plus the Ats is a turbo set and I almost bought...

Plus the Ats is a turbo set and I almost bought one before I ended up with my C7. The Ats is pretty sick for sure and it pulled hard especially from a roll of about 50 mph.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-14-2021, 11:04 AM
Replies: 28
Views: 1,000
Posted By laynlo15
Nice

Nice
Forum: Forced Induction Discussions 01-12-2021, 08:39 AM
Replies: 29
Views: 4,805
Posted By laynlo15
Buy a 16 Camaro with an Lt1 and forget the V6....

Buy a 16 Camaro with an Lt1 and forget the V6. Everyone makes a SC for them and you'll come out better in the long run. Good luck
Forum: Forced Induction Discussions 01-11-2021, 03:14 PM
Replies: 28
Views: 714
Posted By laynlo15
Great build and congrats on some big hp. Have fun...

Great build and congrats on some big hp. Have fun with it and get to the track with it so you can put down some good numbers.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 01-09-2021, 03:18 PM
Replies: 6
Views: 331
Posted By laynlo15
I had to turn off anything related to the rear 02...

I had to turn off anything related to the rear 02 sensors on mine since I did the long tubes and no cats.
Forum: Forced Induction Discussions 01-04-2021, 10:26 PM
Replies: 68
Views: 3,321
Posted By laynlo15
Yup, bucks rule how much HP you can make with E85.

Yup, bucks rule how much HP you can make with E85.
Forum: Forced Induction Discussions 01-04-2021, 07:47 PM
Replies: 68
Views: 3,321
Posted By laynlo15
Thats true but there is a trade off as the race...

Thats true but there is a trade off as the race fuel requires less money for a fuel system. I made well over 850 with just the Lt4 fuel system and boost a pump. You can't do that with E85.
Forum: Forced Induction Discussions 01-04-2021, 03:26 PM
Replies: 68
Views: 3,321
Posted By laynlo15
MS109 is a great fuel but to expensive to run on...

MS109 is a great fuel but to expensive to run on the street at 14 per gal. I loved it in my Camaro but didn't drive it on the street for over 2 years. I spent an average of about 1100.00 a year on...
Forum: Forced Induction Discussions 01-04-2021, 03:21 PM
Replies: 300
Views: 32,668
Posted By laynlo15
The BMRs are for sure. You have more room for...

The BMRs are for sure. You have more room for headers, lines or whatever you need. I loved mine plus your weight will be less then the hydraulic filled stock mounts. I think I weighed mine and it...
Forum: ZL1 Discussions 01-03-2021, 07:35 PM
Replies: 27
Views: 1,686
Posted By laynlo15
Just go to the 1/4 mile in drag racing and you...

Just go to the 1/4 mile in drag racing and you can see the fastest to the slowest Zl1 times.
Forum: Forced Induction Discussions 01-01-2021, 04:48 PM
Replies: 40
Views: 1,295
Posted By laynlo15
Its possible for sure, I ran mine about 12.0...

Its possible for sure, I ran mine about 12.0 after my failures although mine was rich most of the time because of the Meth/Water.
Forum: Forced Induction Discussions 12-31-2020, 11:44 AM
Replies: 40
Views: 1,295
Posted By laynlo15
I had a failure on 0-20 and never again. I ran...

I had a failure on 0-20 and never again. I ran the 15-50 Mobile one in my last engine. The problem with the 0 start up is these motors have a tendency to run real rich if not tuned properly. I...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 12-31-2020, 11:36 AM
Replies: 5
Views: 529
Posted By laynlo15
I've run Mike's Roto Fab Intakes since the old...

I've run Mike's Roto Fab Intakes since the old Pontiac G8GT days, both NA and Magnuson Supercharged. Had one on my Gen5 Camaro NA and then my Gen6 Camaro NA and Magnuson SC. I've run the 4" on my...
Forum: ZL1 Discussions 12-31-2020, 11:06 AM
Replies: 5
Views: 335
Posted By laynlo15
I think they are either 2.75 or 3 inch.

I think they are either 2.75 or 3 inch.
Forum: 2020 Camaro Fest (X) 12-29-2020, 03:51 PM
Replies: 296
Views: 54,518
Posted By laynlo15
Even though I sold my Camaro I'll be there with...

Even though I sold my Camaro I'll be there with my C7 to do some grudge, TNT and bracket racing. Love this event.
Forum: Forced Induction Discussions 12-28-2020, 11:01 PM
Replies: 28
Views: 2,316
Posted By laynlo15
Hell of a lot going with all the wiring. Man that...

Hell of a lot going with all the wiring. Man that ain't my forte at all, wiring screws with my mind. Great job on all the setup you've done. Should be a bad hombre.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-28-2020, 10:53 PM
Replies: 11
Views: 674
Posted By laynlo15
I think since you already have a cam set up you...

I think since you already have a cam set up you won't benefit that much from the Lt2 as it may not make hp in the rpm range of your cam. Ported Msd or High Ram would make more since and probably the...
Forum: Forced Induction Discussions 12-28-2020, 07:14 AM
Replies: 68
Views: 3,321
Posted By laynlo15
Well Ted I've done lots of street and track logs....

Well Ted I've done lots of street and track logs. When you look at them and see all the timing changes and injector pulse, high pressure fuel pump at the rails you can see there is a lot of shit...
Forum: Forced Induction Discussions 12-28-2020, 06:59 AM
Replies: 68
Views: 3,321
Posted By laynlo15
You get it dialed in again when your back on the...

You get it dialed in again when your back on the road and maybe you'll have something for those Stangs.
Forum: Forced Induction Discussions 12-27-2020, 02:51 PM
Replies: 68
Views: 3,321
Posted By laynlo15
So here is the deal and I've broke a couple short...

So here is the deal and I've broke a couple short blocks. When your trying to run 20 psi on the street shit will happen. Its too easy to spin the tires and you know what happens when its delivering...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-27-2020, 02:33 PM
Replies: 22
Views: 1,108
Posted By laynlo15
Good looking Camaro. Love the white.

Good looking Camaro. Love the white.
Forum: Forced Induction Discussions 12-27-2020, 08:06 AM
Replies: 15
Views: 712
Posted By laynlo15
Cool build

Cool build
Forum: ZL1 Discussions 12-27-2020, 08:04 AM
Replies: 240
Views: 33,071
Posted By laynlo15
More stuff for Christmas

More stuff for Christmas
Forum: ZL1 Discussions 12-26-2020, 03:20 PM
Replies: 50
Views: 1,403
Posted By laynlo15
Race Star has an 8.5x18 and a 18x10.5 so you'd be...

Race Star has an 8.5x18 and a 18x10.5 so you'd be cover there.
Forum: ZL1 Discussions 12-26-2020, 01:34 PM
Replies: 50
Views: 1,403
Posted By laynlo15
The 10.5 spreads the sidewall out more which is...

The 10.5 spreads the sidewall out more which is good because it flattens the tires out for more contact. I ran the Race Star 10.5 with the 305-45-17 MT Rs and I run a 10.5 on my Vette with the...
Forum: ZL1 Discussions 12-26-2020, 11:06 AM
Replies: 50
Views: 1,403
Posted By laynlo15
I think at your HP you'd be ok with the 555r2s on...

I think at your HP you'd be ok with the 555r2s on the street and drag strip. There was a Nickey Zl1 with a 2650 at an NMCA race I went to in St louis last summer and he was making 770 detuned so he...
Forum: ZL1 Discussions 12-26-2020, 08:06 AM
Replies: 50
Views: 1,403
Posted By laynlo15
I ran the MT Rs on my Camaro and the Nitto 555r2s...

I ran the MT Rs on my Camaro and the Nitto 555r2s on my C7 and love them both. The
MT Rs aren't going to be a good street tire but the 555r2s are great. I got caught in the rain one night coming...
Forum: ZL1 Discussions 12-26-2020, 07:59 AM
Replies: 21
Views: 759
Posted By laynlo15
I like my 1 7/8 Speed Engineering. Great fit and...

I like my 1 7/8 Speed Engineering. Great fit and the price is right.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-24-2020, 11:57 AM
Replies: 20
Views: 1,114
Posted By laynlo15
If you ever need to drain the top reservoir I use...

If you ever need to drain the top reservoir I use a Turkey baster to pull the fluid out. Works great and I also used that on the reservoir for the SC if you have a Magnuson.
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 01:34 AM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2021, vBulletin Solutions, Inc.