Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


AWE Tuning


Page 1 of 2 1 2
Showing results 1 to 30 of 44
Search took 0.01 seconds. Search: Posts Made By: OneWheelPeel
Forum: 6th gen Camaro Convertible 05-09-2021, 11:27 PM
Replies: 8
Views: 1,677
Posted By OneWheelPeel
No part number, I think I picked up the variety...

No part number, I think I picked up the variety pack at Harbor Freight years ago
Forum: 6th gen Camaro Convertible 05-07-2021, 10:26 PM
Replies: 8
Views: 1,677
Posted By OneWheelPeel
I had a variety pack of e-clips and found one...

I had a variety pack of e-clips and found one that fit, bought he pack years ago for occasions like this. It’s not the same as the factory clip but doubt it can do any worse :smiling1:
Forum: 6th gen Camaro Convertible 05-02-2021, 01:48 AM
Replies: 8
Views: 1,677
Posted By OneWheelPeel
Ok here are three pics. A= This is the good...

Ok here are three pics.
A= This is the good side with factory clip in place
B= This is the one missing a clip and partially slid out, I first saw it caught on something with the top closed but...
Forum: 6th gen Camaro Convertible 05-01-2021, 02:59 PM
Replies: 8
Views: 1,677
Posted By OneWheelPeel
Ok mods can close if they want. Posting the...

Ok mods can close if they want. Posting the solution in case someone else has a similar issue.
A 10 cent clip was missing which was letting a pin slide out from the end of the hydraulic cylinder,...
Forum: 6th gen Camaro Convertible 02-06-2021, 09:22 PM
Replies: 8
Views: 1,677
Posted By OneWheelPeel
Rear corner of top popping loose

Recently I started getting a top not secure message, after a lot of poking around I can see its the passenger side rear becoming unlatched. When this happens I can see just a little bit of daylight...
Forum: Camaro DIY & HOW-TO instructions & discussions 05-30-2020, 02:49 PM
Replies: 6
Views: 2,370
Posted By OneWheelPeel
3D print? ABS or other material?

3D print? ABS or other material?
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-15-2020, 12:42 AM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
Well if it comes back in 40k at that point I may...

Well if it comes back in 40k at that point I may just put in a TC myself and get a full tune. Life gives you lemons yadda yadda
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-10-2020, 10:06 PM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
Good luck, let us know if you learn anything...

Good luck, let us know if you learn anything interesting about the problem.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-09-2020, 11:02 PM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
Hope it’s fixed too, or the next camaro is a...

Hope it’s fixed too, or the next camaro is a stick shift.
Hopefully your shifting issue gets sorted.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-09-2020, 02:36 PM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
I also got mine from a used dealer, a Subaru...

I also got mine from a used dealer, a Subaru dealer to be exact. No issue taking it to the local Chevy dealer.

So they called this morning, it was done and I picked it up. They did the TSB fluid...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 03-05-2020, 12:27 AM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
It actually didn’t go in until this morning. They...

It actually didn’t go in until this morning. They had me drive it with the tech and he could feel the issue right away. He says ok he has to do look into it now, he said depending on build date I may...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 02-19-2020, 06:13 PM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
Well went to the dealership today. Good news is...

Well went to the dealership today. Good news is even tho I bought it used I am still in the power train warranty. Its runs out at 60k and I am at 53k.
It will go in for a diagnostic in March. The...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 02-17-2020, 11:16 PM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
So is it a case of go to the dealer and they will...

So is it a case of go to the dealer and they will determine if it’s a TSB and fix it?
I’m in a totally foreign environment when it comes to anyone repairing something for me. I generally am the one...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 02-17-2020, 08:43 PM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
Ok I'll keep that in mind as I continue trying to...

Ok I'll keep that in mind as I continue trying to diagnose it. Thanks.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 02-17-2020, 08:10 PM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
Did you feel anything along with the rpm bounce?

Did you feel anything along with the rpm bounce?
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 02-17-2020, 07:45 PM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
As far as I can tell it does it about the same. I...

As far as I can tell it does it about the same. I can even make it happen in a lower gear if like 6th and just feather the throttle up a slight incline.


If it was an older car I would suspect...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 02-17-2020, 06:35 PM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
That was one of the first things I looked up, but...

That was one of the first things I looked up, but maybe I got the wrong results, people describe a more violent feel with their issues. This is more like hummmmMMMmmmmMMMmmmmMMM

I will search some...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 02-17-2020, 05:46 PM
Replies: 27
Views: 5,529
Posted By OneWheelPeel
Weird surging at cruise

Hey All.

So this is for a v6 2018 with auto tranny.
About a week ago I noticed a slight surge if I am cruising on the freeway, it will do it on level ground at around 70 mph, but at lower speeds...
Forum: V6 LGX Engine, Exhaust, and Bolt-Ons 01-03-2020, 12:14 PM
Replies: 65
Views: 24,595
Posted By OneWheelPeel
I don’t have any toys for my 2018 RS yet, but...

I don’t have any toys for my 2018 RS yet, but that is some good info on HPT, thanks!
Forum: ZL1 Discussions 02-18-2019, 06:09 PM
Replies: 34
Views: 4,438
Posted By OneWheelPeel
VR modeling with my iPhone and Google cardboard...

VR modeling with my iPhone and Google cardboard would be cool.
Forum: ZL1 Discussions 02-17-2019, 08:11 PM
Replies: 34
Views: 4,438
Posted By OneWheelPeel
Yeah I actually was super lucky, the blue...

Yeah I actually was super lucky, the blue filament was almost out and I only had black on hand so I paused and gently swapped it.
Forum: ZL1 Discussions 02-17-2019, 07:04 PM
Replies: 34
Views: 4,438
Posted By OneWheelPeel
Also if you time it right you can switch filament...

Also if you time it right you can switch filament colors while printing instead of gluing pieces together, but that is only possible in some cases, like the black strip in the C64 case in this pic.
Forum: ZL1 Discussions 02-17-2019, 02:38 PM
Replies: 34
Views: 4,438
Posted By OneWheelPeel
I’ve been 3D printing off and on for about a year...

I’ve been 3D printing off and on for about a year now, car projects and other things. I was gonna suggest the ironing part but saw you already know about it :)
I see you are kind of local, I’ve had...
Forum: Cosmetic modifications (exterior and interior) 02-10-2019, 09:21 PM
Replies: 4
Views: 1,186
Posted By OneWheelPeel
Any idea how well it’s blocks the wind compared...

Any idea how well it’s blocks the wind compared to some other options?
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 01-14-2019, 09:43 AM
Replies: 16
Views: 2,507
Posted By OneWheelPeel
If you aren’t attached to a particular model then...

If you aren’t attached to a particular model then yeah, but at least with the old cars, like fox bodies, third gen f bodies and in my case first gen Miata a lot could be done with just add ons,...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 01-13-2019, 08:56 PM
Replies: 16
Views: 2,507
Posted By OneWheelPeel
Chip thing used to be the only option with a...

Chip thing used to be the only option with a stock ecu, we may be headed back there
Forum: V6 LGX Engine, Exhaust, and Bolt-Ons 12-16-2018, 06:53 PM
Replies: 30
Views: 4,897
Posted By OneWheelPeel
Kind of thing they would use piggy backs for when...

Kind of thing they would use piggy backs for when tuning was rarer, I remember a supercharger kit that used a switched resistor in the maf, kicked in when in boost, went back to normal during cruise....
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-01-2018, 09:42 PM
Replies: 22
Views: 7,804
Posted By OneWheelPeel
I only go to one car wash that basically has rags...

I only go to one car wash that basically has rags that gently shimmy back and forth, and no high pressure spray. Used the place even when I had a Miata with a thin top, I won’t take a vert in any...
Forum: ZL1 Discussions 11-18-2018, 07:29 PM
Replies: 37
Views: 10,232
Posted By OneWheelPeel
If it’s long term lift with the quick jack and...

If it’s long term lift with the quick jack and then put rhino ramps or wood blocks under the tires?
Forum: Cosmetic modifications (exterior and interior) 09-30-2018, 09:09 PM
Replies: 2
Views: 1,075
Posted By OneWheelPeel
Thanks!

Thanks!
Showing results 1 to 30 of 44
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 01:03 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.