Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


BeckyD @ James Martin Chevy


Showing results 1 to 20 of 20
Search took 0.01 seconds. Search: Posts Made By: JayRow52
Forum: Suspension | Brakes | Chassis 03-20-2021, 04:40 PM
Replies: 3
Views: 1,453
Posted By JayRow52
https://lh3.googleusercontent.com/FvMFdX8vT7QWQgqo...

https://lh3.googleusercontent.com/FvMFdX8vT7QWQgqofZAnILkvdK2EnXqdrQ8Uusycrk9_U1SuVbo_3Sb2Ryit3_sQjaL28K1UKmtK-Wlfe2Dtw8n_Ze7zd6hlBdnHl_TrH9Wh3kued-m0kymQgjL3BzCkcQKMkU2wixXoK2X872GmEAreuksugy1nPuVjgn...
Forum: Suspension | Brakes | Chassis 03-18-2021, 10:15 AM
Replies: 3
Views: 1,453
Posted By JayRow52
I have the FE3 front bar with the FEA rear bar....

I have the FE3 front bar with the FEA rear bar. The rear FEA bar is adjustable and in its' neutral setting has the same torsion rate as the FE3 rear bar. From there you can adjust one step softer or...
Forum: Suspension | Brakes | Chassis 03-18-2021, 10:03 AM
Replies: 6
Views: 1,286
Posted By JayRow52
I ran -1.5f & -1.3r with the stock 245s and FE2...

I ran -1.5f & -1.3r with the stock 245s and FE2 suspension for a year without any extra wear - approx. 3,000 miles. Added the FE3 suspension the next year and did another 2,000 miles with the same...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 09-07-2020, 12:45 AM
Replies: 3
Views: 1,105
Posted By JayRow52
I use Redline D6 in mine. I track the car...

I use Redline D6 in mine. I track the car casually (4 to 5 times a year) and do a trans drain and fill every spring. The Redline D6 has slightly better kinematic viscosity ratings than the OEM AC...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 07-10-2020, 10:12 PM
Replies: 15
Views: 6,349
Posted By JayRow52
Here's my car after my first track session on the...

Here's my car after my first track session on the FE3 and Chevy Performance brake setup. It sits the same as far as I can tell. I didn't bother to measure ride height before or after.

I pieced...
Forum: Wheels | Tires -- Sponsored by The Tire Rack 07-10-2020, 09:46 PM
Replies: 5
Views: 1,281
Posted By JayRow52
Yes, they'll fit just fine. You should have about...

Yes, they'll fit just fine. You should have about 3/8" clearance from the inner of the front wheel to the strut body. 18" wheels will clear the SS 1LE brakes so no worries with the 19". WookWook has...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 07-08-2020, 10:58 PM
Replies: 15
Views: 6,349
Posted By JayRow52
They used to offer a Chevrolet Performance front...

They used to offer a Chevrolet Performance front brake upgrade for the LS/LT models for a really good price (I got mine on sale for $480). It's since been discontinued. However, you can still buy the...
Forum: Suspension | Brakes | Chassis 07-08-2020, 10:29 PM
Replies: 10
Views: 4,647
Posted By JayRow52
Just to add a bit of clarification to this, It's...

Just to add a bit of clarification to this, It's been verified in both of the links provided that the 2.0T/V6 1LE packages use the same front springs as their FE2 equipped counterparts along with FE3...
Forum: Suspension | Brakes | Chassis 02-22-2020, 06:05 PM
Replies: 72
Views: 17,695
Posted By JayRow52
Great write up. Ordered mine during a Presidents’...

Great write up. Ordered mine during a Presidents’ Day sale and hope to get them on in the next couple weeks. Has anyone done the BMR differential bushings to go with their subframe bushings?
Forum: Suspension | Brakes | Chassis 02-15-2020, 12:58 AM
Replies: 2
Views: 2,705
Posted By JayRow52
The front springs won’t work. A combination of...

The front springs won’t work. A combination of the stiffer spring rate, minor change in spring perch height for the non-MRC struts, and lighter front end weight for the LS 2.0t will result in those...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 08-29-2019, 08:02 PM
Replies: 33
Views: 6,554
Posted By JayRow52
Here's the link to the track prep guide. Worth a...

Here's the link to the track prep guide. Worth a read before an autoX or track session: chevrolet-camaro-track-preparation-guide.pdf...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 08-28-2019, 10:02 PM
Replies: 33
Views: 6,554
Posted By JayRow52
Those look great, wook! Did you get the track...

Those look great, wook! Did you get the track alignment done too? If you’re worried about the front poking out you could always look at adding the C7 Z06 front fender trim. A few others on the forum...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 08-28-2019, 09:51 PM
Replies: 22
Views: 4,584
Posted By JayRow52
Thanks guys! This conversation was way...

Thanks guys! This conversation was way informative. I’m just getting started with logging via HPT and it’s easy to get lost in all the channels and chart series.
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 08-24-2019, 11:16 AM
Replies: 22
Views: 4,584
Posted By JayRow52
wookwook, would you mind sharing your math for...

wookwook, would you mind sharing your math for boost in HPT? I see a few channels related to the turbo bypass valve and pressure, but none seem to be actual boost pressure...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 08-23-2019, 07:30 PM
Replies: 33
Views: 6,554
Posted By JayRow52
Keep us updated on those wheels and tires, wook....

Keep us updated on those wheels and tires, wook. I'm planning on switching to a staggered set of Arc-8's first thing in the spring (these all-season's should be thoroughly destroyed by then :thumb:)...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 08-23-2019, 07:10 PM
Replies: 33
Views: 6,554
Posted By JayRow52
The offset is the distance from the wheel hub...

The offset is the distance from the wheel hub mounting surface to the wheel centerline. A smaller number means the outer wheel edge sits further out. In switching from a 32 offset to 22 like wook is...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 08-17-2019, 01:48 PM
Replies: 174
Views: 37,544
Posted By JayRow52
Not to get too much further off topic, but ZTS...

Not to get too much further off topic, but ZTS I'd consider an aftermarket oil cooler either before or with the intercooler. If you're glowing red I bet your oil temps are getting pretty high. I hit...
Forum: Road Course/Track and Autocross 07-24-2019, 06:37 PM
Replies: 18
Views: 2,771
Posted By JayRow52
Chevy will do it. For the price they quoted me it...

Chevy will do it. For the price they quoted me it was cheaper to buy the fluid and the Motive unit and do it myself. I was looking for an excuse to add that pressure bleeder to the tool box :thumb:
...
Forum: Road Course/Track and Autocross 07-22-2019, 09:14 PM
Replies: 18
Views: 2,771
Posted By JayRow52
Lafourche1's advice is solid. Coming from a...

Lafourche1's advice is solid. Coming from a fellow 2.0T owner that tracks around once a month at Utah Motorsports Campus, flush that DOT3 fluid out and replace with Motul 600. One 20 minute session...
Forum: 4-Cylinder - Engine, Exhaust, Bolt-Ons, Tuning Equipment 12-16-2018, 03:57 PM
Replies: 17
Views: 6,239
Posted By JayRow52
Sent you a PM on the downpipe.

Sent you a PM on the downpipe.
Showing results 1 to 20 of 20

 
Forum Jump

All times are GMT -5. The time now is 11:57 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.