Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: parish8
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 02-26-2021, 01:05 PM
Replies: 137
Views: 19,874
Posted By parish8
Is this your opinion on a street car or the lt in...

Is this your opinion on a street car or the lt in general? some of the fastest ls people I know spin their junk to over 8000rpm. These are 99% strip cars.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 02-23-2021, 09:24 PM
Replies: 137
Views: 19,874
Posted By parish8
I have read the total length of the pushrod is...

I have read the total length of the pushrod is not the stated length. I am not sure where exactly they measure from.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 02-23-2021, 09:21 PM
Replies: 137
Views: 19,874
Posted By parish8
No expert! I have been told shining the...

No expert!

I have been told shining the springs to within .060-.080 of bind at full lift causes the coils to bump into each other and dampens the spring which makes it much more effective.

I...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 02-23-2021, 02:06 PM
Replies: 137
Views: 19,874
Posted By parish8
If your talking to me Yeah, tried that. My head...

If your talking to me Yeah, tried that. My head was ****ed anyways so I had no mercy(BFH) and it wouldn’t come apart.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 02-23-2021, 02:01 PM
Replies: 137
Views: 19,874
Posted By parish8
I had a #7 exhaust valve break and my retainers...

I had a #7 exhaust valve break and my retainers were impossible to get off. I think it is valve float/bounce just beating stuff to death.

I think my biggest issue was the springs were not shimmed...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 02-20-2021, 03:39 PM
Replies: 137
Views: 19,874
Posted By parish8
I would get that compression tester working. It...

I would get that compression tester working. It should have a check valve(Schrader valve) built into it that holds the pressure. See how the compression compares to some of the other cylinders. You...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -5. The time now is 10:00 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.