Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


BeckyD @ James Martin Chevy


Page 1 of 7 1 2345 Last »
Showing results 1 to 30 of 200
Search took 0.01 seconds. Search: Posts Made By: KLG
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 02-17-2024, 09:15 PM
Replies: 10
Views: 5,157
Posted By KLG
Yes, I use RP MaxGear 75w-90 in the differential...

Yes, I use RP MaxGear 75w-90 in the differential of my Camaro and also in the differential of my C7 Z06.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-18-2023, 01:56 PM
Replies: 18
Views: 3,156
Posted By KLG
A few years ago, I had my Camaro lowered using...

A few years ago, I had my Camaro lowered using the GMP suspension kit for convertibles and I had similar issues. The alignment measurements were all good except the right front caster was off...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 10-08-2022, 10:21 PM
Replies: 16
Views: 3,097
Posted By KLG
With the convertible, I don't really push it, but...

With the convertible, I don't really push it, but the car does feel more planted in the curves.

The GM kit lowers the car slightly, about 3/4". I think the Camaro looks better slightly lowered.
...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 10-08-2022, 01:57 PM
Replies: 16
Views: 3,097
Posted By KLG
Yes, Chevrolet's Lowering Suspension Upgrade...

Yes, Chevrolet's Lowering Suspension Upgrade System can be installed later, which is exactly what I did. No need to order the car with that option unless you want to do so.

--KLG--
Forum: 2016+ Camaro: 6th Gen Camaro general forum 09-23-2022, 09:50 PM
Replies: 6
Views: 1,346
Posted By KLG
You may be hearing the tonneau cover rubbing...

You may be hearing the tonneau cover rubbing against this small bumper. Mine quiets down when I apply a little lubricant between the bumper and the tonneau cover.

In addition, this bumper is...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 09-20-2022, 03:15 PM
Replies: 31
Views: 5,011
Posted By KLG
Hey OP, that sounds like a horrible dealership...

Hey OP, that sounds like a horrible dealership experience for you.

However, just as an FYI regarding the Heli-coil thread insert in your oil pan, I believe that is OEM on the LT1. I just changed...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 08-28-2022, 04:49 PM
Replies: 19
Views: 5,150
Posted By KLG
No crush washer. The seal on the OEM drain...

No crush washer.

The seal on the OEM drain plug is reusable. I've never replaced the seal on mine and still have no leak issues.

--KG--
Forum: 2016+ Camaro: 6th Gen Camaro general forum 10-07-2021, 09:51 PM
Replies: 48
Views: 8,497
Posted By KLG
It is in the C7s that came equipped with...

It is in the C7s that came equipped with HomeLink.

I did the same as Mike7409. I have a 1LZ C7Z which did not come with HomeLink. I bought the appropriate C7 sun visor with the HomeLink...
Forum: 6th gen Camaro Convertible 10-06-2021, 06:27 PM
Replies: 205
Views: 85,924
Posted By KLG
Mine was repaired under warranty (top replaced)...

Mine was repaired under warranty (top replaced) in December 2017. So far, so good.

However, my Camaro is not a daily driver and is garaged between drives. Sometimes, even covered while in the...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 10-04-2021, 03:49 PM
Replies: 5
Views: 1,746
Posted By KLG
I am currently using a PF63E. Same...

I am currently using a PF63E. Same specifications as a PF64, but has a longer cannister than the PF64. Note that it hangs down a bit lower than the stock filter but not too low as you can see in...
Forum: 6th gen Camaro Convertible 10-03-2021, 05:31 PM
Replies: 19
Views: 4,615
Posted By KLG
I ended up replacing the upper quarter trim...

I ended up replacing the upper quarter trim panels on both sides and no problem with either side.

I carefully removed the third clip and it fit perfectly.

The last few posts within this thread...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 09-27-2021, 05:42 PM
Replies: 16
Views: 2,339
Posted By KLG
Have you recently done any work on your car such...

Have you recently done any work on your car such as installing a skip-shift eliminator?

--KLG--
Forum: 6th gen Camaro Convertible 09-22-2021, 04:48 PM
Replies: 114
Views: 38,058
Posted By KLG
I did not try that when I replaced mine, I...

I did not try that when I replaced mine, I removed the additional retaining clip.

My issue was the arm that holds the spring broke off the trim panel door on the LH side. But, I replaced both...
Forum: 6th gen Camaro Convertible 09-13-2021, 12:41 PM
Replies: 19
Views: 4,615
Posted By KLG
Those upper quarter panel part numbers shown...

Those upper quarter panel part numbers shown above are the part numbers listed in the original TSB. Both are superseded now. Ask me how I know...:smiling1:

The updated part numbers are:
Upper...
Forum: 6th gen Camaro Convertible 09-09-2021, 02:59 PM
Replies: 114
Views: 38,058
Posted By KLG
While cleaning my interior this morning I heard a...

While cleaning my interior this morning I heard a plastic snapping/breaking sound while putting the top up. I put the top back down and found that the trim panel door (the one that opens and closes...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 09-02-2021, 02:36 PM
Replies: 15,074
Views: 5,168,853
Posted By KLG
Took the convertible for a drive in the mountains...

Took the convertible for a drive in the mountains this morning. It was 53 degrees at 8,000 feet up and the top was down and the heater was on. Then back to town and breakfast at a new restaurant...
Forum: Transmissions 08-21-2021, 03:35 PM
Replies: 5
Views: 1,540
Posted By KLG
As an FYI, Gen6 SS convertibles, with the M6 and...

As an FYI, Gen6 SS convertibles, with the M6 and the 3.73 LSD do not have differential coolers.

--KLG--
Forum: Cosmetic modifications (exterior and interior) 06-09-2021, 07:27 PM
Replies: 5
Views: 1,451
Posted By KLG
No, I did it with everything in place. Just...

No, I did it with everything in place. Just emptied the storage compartment and removed the rubber liner in the bottom before drilling. I notched the rubber liner to allow the lightning cable to go...
Forum: Cosmetic modifications (exterior and interior) 06-09-2021, 02:21 PM
Replies: 5
Views: 1,451
Posted By KLG
Iphone cable routing

Cleaned up the lightning cable routing. I had the cable coming out of the console then going under the right side panel of the console to the cell phone holder. However, the passenger seat back...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-25-2021, 10:40 AM
Replies: 36
Views: 7,737
Posted By KLG
1065905

1065905
Forum: 2016+ Camaro: 6th Gen Camaro general forum 03-27-2021, 01:41 PM
Replies: 18
Views: 3,507
Posted By KLG
That is the oil drain plug in the pan that you've...

That is the oil drain plug in the pan that you've broken, I think?

If so, center punch it as close to the center of the broken piece as possible, then use a reverse drill bit to drill a hole into...
Forum: Camaro DIY & HOW-TO instructions & discussions 03-27-2021, 01:18 PM
Replies: 138
Views: 92,161
Posted By KLG
88861800 is what the 2016/2017 owners manual...

88861800 is what the 2016/2017 owners manual states and what the 2016/2017 service manual states as the correct OEM transmission fluid for the TR6060 manual transmission.

--KLG--
Forum: 6th gen Camaro Convertible 03-13-2021, 09:45 PM
Replies: 3
Views: 1,025
Posted By KLG
Good job and result. :thumbup: Like you, I...

Good job and result. :thumbup:

Like you, I didn't find the trunk lighting adequate.

First, I replaced the stock incandescent bulb with a downward firing LED bulb, which really brightened up the...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 02-15-2021, 11:22 AM
Replies: 327
Views: 156,269
Posted By KLG
Good reminder about cleaning the connections. I...

Good reminder about cleaning the connections. I had to make sure I was down to bare metal when I was making those two new connections to the body. I did clean the OEM frame lug connection since I...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 02-14-2021, 09:06 PM
Replies: 327
Views: 156,269
Posted By KLG
After reading about SSDan’s success (and everyone...

After reading about SSDan’s success (and everyone else’s) with adding secondary grounding cables, I decided to do something similar. I really haven’t had issues with the starter turning the engine...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 02-05-2021, 07:29 PM
Replies: 41
Views: 6,307
Posted By KLG
I have the front end on ramps, about a 6" rise. ...

I have the front end on ramps, about a 6" rise. I drain the oil with the engine warm to hot. I usually let it drain for an hour or so.

New filter and 10 quarts back in.

With the car level and...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 02-05-2021, 07:19 PM
Replies: 4
Views: 1,298
Posted By KLG
The rushing water sound is sometimes noticed on...

The rushing water sound is sometimes noticed on the dry sump engines. I hear it on my Z06 from time to time.

--KLG--
Forum: 2016+ Camaro: 6th Gen Camaro general forum 02-03-2021, 09:04 PM
Replies: 26
Views: 11,718
Posted By KLG
I have not done an exhaustive search, but you are...

I have not done an exhaustive search, but you are correct about Fram and Wix offering oil filters with the correct BPV pressure setting for the LT1/LT4. Also NAPA (essentially the same as Wix). And...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 02-03-2021, 05:09 PM
Replies: 26
Views: 11,718
Posted By KLG
This is true... Notice that Mobil’s website...

This is true...

Notice that Mobil’s website oil filter cross reference chart states that the M1-113a is the correct oil filter for the 2010 Camaro SS all the way through to the 2020 Camaro SS. ...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 02-03-2021, 03:26 PM
Replies: 26
Views: 11,718
Posted By KLG
I am sure the Mobil One filter is a very good...

I am sure the Mobil One filter is a very good filter. I think M1-113a is the part number for the LT1/LT4 engines.

However, I have not found the published BPV pressure setting for the M1-113a oil...
Showing results 1 to 30 of 200
Page 1 of 7 1 2345 Last »

 
Forum Jump

All times are GMT -5. The time now is 11:46 AM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.