Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


Phastek Performance


Showing results 1 to 30 of 85
Search took 0.01 seconds.
Search: Posts Made By: barnesbr
Forum: ZL1 Discussions 07-18-2019, 12:53 PM
Replies: 49
Views: 8,421
Posted By barnesbr
Stingray. I have used them before and had no...

Stingray. I have used them before and had no issues. Their customer service is actually really good. The fiasco with my transmission was a mess from start to finish. However, ive put another 4K miles...
Forum: Dragstrip and Launching Discussion 06-17-2019, 05:23 PM
Replies: 2,409
Views: 867,578
Posted By barnesbr
Tires: Michelin Pilot Sport 4s Performance...

Tires: Michelin Pilot Sport 4s
Performance Mods: 95mm TB, LT’s, CAI, 9.17 lower pulley, tune
Category #8
R/T..........0.374
60'.............1.927
330'...........5.01
660'...........7.466...
Forum: ZL1 Discussions 04-23-2019, 08:59 AM
Replies: 57
Views: 13,368
Posted By barnesbr
I legitimately fear this happening to me every...

I legitimately fear this happening to me every day. My fear is worsened by the fact that I have no warranty. I check my oil pressure about every 30 seconds while driving. Haven’t seen too many 2018’s...
Forum: ZL1 Discussions 03-30-2019, 09:28 AM
Replies: 56
Views: 16,187
Posted By barnesbr
Do you know what resonators they installed? I’m...

Do you know what resonators they installed? I’m looking to do the same. I know the pipes are 2.75” but I’m having a hard time finding resonators is that size.
Forum: ZL1 Discussions 03-22-2019, 06:39 AM
Replies: 24
Views: 3,670
Posted By barnesbr
I don’t understand how you guys can’t hear a...

I don’t understand how you guys can’t hear a difference with the fuse pull. Before I had headers I could easily hear the difference. Highway cruising had much better sound and the valves never closed...
Forum: ZL1 Discussions 03-15-2019, 07:44 PM
Replies: 56
Views: 16,187
Posted By barnesbr
Did you clamp the resonators or weld them. One of...

Did you clamp the resonators or weld them. One of the connection pipes from kooks is angled, so how did the straight resonators line up?
Forum: ZL1 Discussions 03-13-2019, 07:28 PM
Replies: 56
Views: 16,187
Posted By barnesbr
Reviving and old thread, sorry. I just installed...

Reviving and old thread, sorry. I just installed Kooks LT’s into my stock NPP and absolutely hate the way it sounds 80% of the time. Cold starts make the whole neighborhood jump out of their beds and...
Forum: ZL1 Discussions 03-09-2019, 12:54 PM
Replies: 49
Views: 8,421
Posted By barnesbr
Sorry, I didn’t see your post before. I’m doing...

Sorry, I didn’t see your post before. I’m doing 2” kooks LT’s with off-road connection pipes, Lingenfelter 720HP kit (lower pulley, ATI balancer, bolts, etc) 95mm ported throttle body, Roto-Fab CAI...
Forum: ZL1 Discussions 03-08-2019, 04:10 PM
Replies: 49
Views: 8,421
Posted By barnesbr
So, I decided to jack the car up and take a look...

So, I decided to jack the car up and take a look for myself. Dealership left the oil level sensor disconnected. Plugged it in, good to go.
Forum: ZL1 Discussions 03-08-2019, 02:22 PM
Replies: 49
Views: 8,421
Posted By barnesbr
I totally agree with you. There is no way they...

I totally agree with you. There is no way they redesigned it that quick. There had to be something in the works already.

As far as being trouble free...not even one day! Engine oil low light came...
Forum: ZL1 Discussions 03-07-2019, 07:12 PM
Replies: 49
Views: 8,421
Posted By barnesbr
I promised an update, so here it is... My...

I promised an update, so here it is...

My pride and joy is finally home after 31 days. The drive gear and pump gear were replaced with the new angle gear design. My service advisor spent 20-30...
Forum: ZL1 Discussions 03-02-2019, 07:45 PM
Replies: 49
Views: 8,421
Posted By barnesbr
It sounds like they are putting some variant of...

It sounds like they are putting some variant of the 10sp in everything. They used a Tahoe to compare to mine. I will definitely keep you guys updated. I’m hoping they have the parts Mon/Tues and have...
Forum: ZL1 Discussions 03-02-2019, 02:17 PM
Replies: 49
Views: 8,421
Posted By barnesbr
Appreciate it!

Appreciate it!
Forum: ZL1 Discussions 03-01-2019, 03:39 PM
Replies: 23
Views: 3,291
Posted By barnesbr
Does it happen every time? Do you get a traction...

Does it happen every time? Do you get a traction control light? My guess would be low fuel in the tank and gravity starving the pump.
Forum: ZL1 Discussions 03-01-2019, 03:36 PM
Replies: 49
Views: 8,421
Posted By barnesbr
Day 24: After multiple calls to GM and causing my...

Day 24: After multiple calls to GM and causing my service advisor to pull his hair out, GM has finally acknowledged a problem. Enough so, that they have redesigned the transmission pump gears. They...
Forum: ZL1 Discussions 02-23-2019, 11:31 AM
Replies: 49
Views: 8,421
Posted By barnesbr
I know man. I told the service advisor yesterday,...

I know man. I told the service advisor yesterday, “I’m sorry for being a PITA, but this is getting ridiculous “ I’m not going to disclose any legal information, but steps have already been taken. I...
Forum: ZL1 Discussions 02-23-2019, 10:51 AM
Replies: 49
Views: 8,421
Posted By barnesbr
My issue is definitely different than this video....

My issue is definitely different than this video. My rattle is coming when unloadeing the driveline, ie cruising to a stop. I have a metal on metal tapping sound. The technician recreated it by...
Forum: ZL1 Discussions 02-23-2019, 10:47 AM
Replies: 49
Views: 8,421
Posted By barnesbr
I had a “gear whine” as well but the idler pulley...

I had a “gear whine” as well but the idler pulley and tensioner pulley were bad. When those were replaced I had no sort of driveline noise. I haven’t had the issue with switching between drive and...
Forum: ZL1 Discussions 02-23-2019, 09:21 AM
Replies: 12
Views: 2,471
Posted By barnesbr
Couldn’t you just swap a rear to the front if you...

Couldn’t you just swap a rear to the front if you have a flat in the front? I know the rears are wider, but it should be enough for a temporary fit, right?
Forum: ZL1 Discussions 02-23-2019, 06:42 AM
Replies: 49
Views: 8,421
Posted By barnesbr
It’s been 5 days since my last update. Went back...

It’s been 5 days since my last update. Went back to the dealer yesterday to try to get some more information and a status update. The service advisor went to the shop to see what was going on. He...
Forum: ZL1 Discussions 02-18-2019, 12:43 PM
Replies: 49
Views: 8,421
Posted By barnesbr
Stopped in to get an update. My car was on the...

Stopped in to get an update. My car was on the lift with the transmission pan (among other parts/valve body?) removed. He was nice enough to show me what was going on and explain the situation. Long...
Forum: ZL1 Discussions 02-17-2019, 05:46 AM
Replies: 49
Views: 8,421
Posted By barnesbr
PM’d you

PM’d you
Forum: ZL1 Discussions 02-16-2019, 04:23 PM
Replies: 49
Views: 8,421
Posted By barnesbr
That would be my luck! I had an idler pulley and...

That would be my luck! I had an idler pulley and tensioner pulley go out as well. I also have the clunk over speed bumps (end links) but dealer swears they are tight.
Forum: ZL1 Discussions 02-16-2019, 01:12 PM
Replies: 49
Views: 8,421
Posted By barnesbr
:lol: More like, tinktatinktatinktatinklrlrlr

:lol: More like, tinktatinktatinktatinklrlrlr
Forum: ZL1 Discussions 02-16-2019, 09:16 AM
Replies: 49
Views: 8,421
Posted By barnesbr
They are confident enough that they are bringing...

They are confident enough that they are bringing in a transmission specialist. Seems like it’s coming from the torque converter to me, but I’m no expert in transmissions by any means.
Forum: ZL1 Discussions 02-16-2019, 06:16 AM
Replies: 49
Views: 8,421
Posted By barnesbr
A10 Noise/Dealer Visit

Hey guys. I took my 2018 A10 in for a rattle noise under deceleration. I was contemplating doing some small mods and wanted to get the noise checked out under warranty before I lose it. Dealer had my...
Forum: ZL1 Discussions 12-15-2018, 01:56 AM
Replies: 38
Views: 5,639
Posted By barnesbr
Thanks. Me too. Still haven’t heard anything

Thanks. Me too. Still haven’t heard anything
Forum: ZL1 Discussions 12-14-2018, 03:11 AM
Replies: 38
Views: 5,639
Posted By barnesbr
Well, I dropped her off Wednesday. I'm also...

Well, I dropped her off Wednesday. I'm also having them look at the sway bar end links (for the second time) and they are going to do the TSB for the wire harness while it's there as well. They are...
Forum: ZL1 Discussions 12-09-2018, 10:51 PM
Replies: 44
Views: 5,949
Posted By barnesbr
Congrats and welcome. Bye-bye warranty :lol:

Congrats and welcome. Bye-bye warranty :lol:
Forum: ZL1 Discussions 12-07-2018, 08:27 PM
Replies: 38
Views: 5,639
Posted By barnesbr
Mine started at 7K miles. I’ve heard some guys...

Mine started at 7K miles. I’ve heard some guys saying they had the pulley replaced. One guy even got a new supercharger. I’ll find out Wednesday and report back. I wonder if they will complain about...
Showing results 1 to 30 of 85

 
Forum Jump

All times are GMT -5. The time now is 09:53 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.