Homepage Garage Wiki Register Members List Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 30 of 500
Search took 0.05 seconds.
Search: Posts Made By: LiqTenExp
Forum: ZL1 Discussions 01-17-2022, 01:51 AM
Replies: 9
Views: 414
Posted By LiqTenExp
I've tried the NGK and Brisk and seem to favor...

I've tried the NGK and Brisk and seem to favor the Brisk (both 1 step colder than stock). This is based on lower count of misfire in general (not just at WOT). I really don't "feel" any difference...
Forum: ZL1 Discussions 01-04-2022, 05:42 PM
Replies: 23
Views: 1,303
Posted By LiqTenExp
FYI, IAT2 = useless, it is not measured,...

FYI,

IAT2 = useless, it is not measured, from what I've seen it is IAT1+ECT math. If you disconnect IAT1 (part of MAF) it will go away.
Forum: ZL1 Discussions 12-14-2021, 08:58 PM
Replies: 22
Views: 1,426
Posted By LiqTenExp
95-97 using fuel additive put me into the 26-27°...

95-97 using fuel additive put me into the 26-27° degree timing area easily/safely with my 2300.

I'm on 50/50 methanol right now and seems to have put me there plus some in equivalent octane, I can...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 12-14-2021, 12:39 PM
Replies: 16
Views: 937
Posted By LiqTenExp
Katech t-stat all the way, I had another 180°...

Katech t-stat all the way, I had another 180° fail on me in less than 2 years
Forum: Wheels | Tires -- Sponsored by The Tire Rack 12-12-2021, 08:29 PM
Replies: 6
Views: 518
Posted By LiqTenExp
I ran PS4S all the way around and now have them...

I ran PS4S all the way around and now have them just on the front (555RII now on rear) and they were always quiet. BTW the 555RII are also very quiet.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 12-01-2021, 06:27 AM
Replies: 23
Views: 2,293
Posted By LiqTenExp
VTT you mean VVE? If you meant VVE: If you...

VTT you mean VVE?

If you meant VVE:
If you aren't taking the easy/lazy way out of a MAF only tune (which I think is done way too often by lazy tuners) and are keeping Dynamic mode operational you...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 11-30-2021, 09:42 AM
Replies: 23
Views: 2,293
Posted By LiqTenExp
I'm not sure a 5% change is the right answer. You...

I'm not sure a 5% change is the right answer. You need to fully review all your tq parameters and see what is out of wack.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 11-29-2021, 09:33 PM
Replies: 23
Views: 2,293
Posted By LiqTenExp
Wiring harness under coolant reservoir isn't...

Wiring harness under coolant reservoir isn't damaged/overheated?

You've said you've set the following to max
Torque Management\General\Traction Control System\TCS Method - Max Torque to 6042 and...
Forum: ZL1 Discussions 11-29-2021, 06:19 AM
Replies: 4
Views: 552
Posted By LiqTenExp
McLeod RTX twin worked well for me. Initially it...

McLeod RTX twin worked well for me. Initially it had a little more chatter but that cleared up after the break-in mostly.
Forum: ZL1 Discussions 11-24-2021, 03:11 PM
Replies: 11
Views: 1,482
Posted By LiqTenExp
One thing I don't see mentioned in this thread is...

One thing I don't see mentioned in this thread is where whp wise this check valve is actually a concern/restriction... I see 3400-3700 psi (with 70-74 psi feeding it) WOT on my fuel rail pressure...
Forum: ZL1 Discussions 11-14-2021, 08:27 AM
Replies: 24
Views: 2,050
Posted By LiqTenExp
That is an impressive amount of fail for 1 shop...

That is an impressive amount of fail for 1 shop to create. 3rd the above request.
Forum: ZL1 Discussions 11-05-2021, 04:29 PM
Replies: 31
Views: 2,017
Posted By LiqTenExp
2300

2300
Forum: ZL1 Discussions 11-05-2021, 12:07 AM
Replies: 31
Views: 2,017
Posted By LiqTenExp
I am my tuner, the drop was in MAT temp not...

I am my tuner, the drop was in MAT temp not timing!
Forum: ZL1 Discussions 11-04-2021, 10:15 AM
Replies: 31
Views: 2,017
Posted By LiqTenExp
That is warm MAT at 180! Wonder what your IAT...

That is warm MAT at 180! Wonder what your IAT Advance parameter was.. it should have been pulling multiple degrees of timing at that temp.

I was in the 120-140 MAT during my runs. My MAT will...
Forum: USA - NY / NJ / PA 10-29-2021, 09:33 PM
Replies: 12
Views: 1,710
Posted By LiqTenExp
Sold

Sold
Forum: ZL1 Discussions 10-29-2021, 07:10 PM
Replies: 31
Views: 2,017
Posted By LiqTenExp
Note I actually asked for 2 more degrees and got...

Note I actually asked for 2 more degrees and got closer to 4, got love all the sneaky advance parameters that add up!
Forum: ZL1 Discussions 10-29-2021, 03:00 PM
Replies: 31
Views: 2,017
Posted By LiqTenExp
Looking at gains/shape of HP curve and knock. ...

Looking at gains/shape of HP curve and knock.

Yes on 93, that is where I stopped. Now with meth I can get to 26+ using the same knock sensor settings, 26 seemed like more than enough!
Forum: ZL1 Discussions 10-29-2021, 02:31 PM
Replies: 31
Views: 2,017
Posted By LiqTenExp
Put down ~760whp on a miser mustang dyno on drag...

Put down ~760whp on a miser mustang dyno on drag radials, translating that to dynojet is ~847 whp. A stock LT4 on their dyno 510-520 whp depending on transmission. Would have made more if I wasn't on...
Forum: ZL1 Discussions 10-28-2021, 08:38 PM
Replies: 31
Views: 2,017
Posted By LiqTenExp
I can hit 24-26° as the log shows above

I can hit 24-26° as the log shows above
Forum: ZL1 Discussions 10-28-2021, 07:30 PM
Replies: 31
Views: 2,017
Posted By LiqTenExp
Timing question for anyone running 2300/2650

Where are you guys timing wise in your table around 1600 mg Airmass?

Hitting the dyno tomorrow and I have some minor fueling to correct, was planning on leaving timing alone.

I'm running 93 +...
Forum: ZL1 Discussions 10-16-2021, 03:59 PM
Replies: 16
Views: 1,346
Posted By LiqTenExp
I'm running a 2300 and never planned on going...

I'm running a 2300 and never planned on going past 800 whp. I recently replaced my injectors due to one being bad and it is a lot of work... make the right choice LOL. If the are going in for a...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 10-02-2021, 10:03 AM
Replies: 8
Views: 1,369
Posted By LiqTenExp
Look at MAF connector and MAF sensor. If the...

Look at MAF connector and MAF sensor. If the temperature signal from there is lost this can occur.
Forum: ZL1 Discussions 10-01-2021, 08:17 AM
Replies: 18
Views: 1,244
Posted By LiqTenExp
My front subframe was dropped It's more...

My front subframe was dropped It's more efficient, especially if you are doing Cam, valvetrain, valley cover, oil pump, heads, etc. Less chance to damage car and all you pay is the price of an...
Forum: ZL1 Discussions 09-26-2021, 09:09 PM
Replies: 15
Views: 995
Posted By LiqTenExp
Traction Control and Stability Control lights...

Traction Control and Stability Control lights will be on while in PTM, you have turned off the standard Traction/Stability Control and now are using PTM Traction Control and Stability control, all is...
Forum: ZL1 Discussions 09-25-2021, 10:02 PM
Replies: 24
Views: 1,620
Posted By LiqTenExp
No rub

No rub
Forum: ZL1 Discussions 09-23-2021, 05:06 PM
Replies: 24
Views: 1,620
Posted By LiqTenExp
I'm running Nitto 555RII on 19x12" wheels in the...

I'm running Nitto 555RII on 19x12" wheels in the rear. Passenger's side is no issue, driver's side requires moving a harness and a little messaging of the inner liner with a heat gun and a small...
Forum: ZL1 Discussions 09-20-2021, 09:20 PM
Replies: 14
Views: 781
Posted By LiqTenExp
Engine\Airflow\General\MAP (this is just info...

Engine\Airflow\General\MAP (this is just info more or less about the expected values on car)
Max = 180 kPa
Min = 10 kPa

Engine\Airflow\General\MAP Estimation (these are the important values for...
Forum: ZL1 Discussions 09-20-2021, 09:04 PM
Replies: 14
Views: 781
Posted By LiqTenExp
Yeah, not sure why they went 4 bar... I actually...

Yeah, not sure why they went 4 bar... I actually considered going to 3 bar map to get better resolution in SD tuning but never got around to it.
Forum: ZL1 Discussions 09-20-2021, 07:46 PM
Replies: 14
Views: 781
Posted By LiqTenExp
Stock is a 4 bar TMAP, no need to change from the...

Stock is a 4 bar TMAP, no need to change from the perspective of pressure measurement limits.
Forum: ZL1 Discussions 09-17-2021, 11:16 AM
Replies: 17
Views: 1,411
Posted By LiqTenExp
Try placing the plastic funnel that comes with...

Try placing the plastic funnel that comes with the car (in trunk) into gas fill tube to open the anti-siphon valve and then insert a small diameter hose through it?
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 07:47 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2022, vBulletin Solutions, Inc.