Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Phastek Performance


Page 1 of 2 1 2
Showing results 1 to 30 of 58
Search took 0.02 seconds. Search: Posts Made By: Yimetime
Forum: USA - Texas 05-03-2022, 08:31 AM
Replies: 4
Views: 1,407
Posted By Yimetime
PCM-Electric mechanic needed in DFW

Anyone have a good mechanic in this area that they recommend. I have been chasing a gremlin causing a P0205 code that I believe is tied to a wiring issue between my fuel injector and the PCM. I have...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 01-12-2022, 01:13 PM
Replies: 1
Views: 1,245
Posted By Yimetime
PCM going bad or another issue?

Hello Camaro5, I am having an ongoing issue with my car. My body guy thought that maybe the battery was the cause of the issues but sadly a new battery did not change anything. This began when my car...
Forum: USA - Texas 06-26-2019, 10:29 AM
Replies: 0
Views: 986
Posted By Yimetime
Mechanic/Repair for BCM/Ignition in DFW

Can anyone recommend someone that can check out my 2011 SS to diagnose and repair my car. The issue began when I would place my car in park (auto), and turn the key off and remove it. The engine...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 06-19-2019, 11:45 AM
Replies: 3
Views: 1,888
Posted By Yimetime
I won’t need to replace my cylinder right? I’m...

I won’t need to replace my cylinder right? I’m just wanting to change out the old switch for the new one i purchased.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 06-19-2019, 09:54 AM
Replies: 3
Views: 1,888
Posted By Yimetime
Possible Ignition Switch Failure?

Hi camaro5,

So, starting like Monday night I believe, my car continues running after I drive, put it into park (6 speed auto), and turn the key off and remove it. I’ll put it back in, all my...
Forum: Cosmetics and Lighting Modification Discussions 05-25-2016, 06:00 PM
Replies: 56
Views: 45,660
Posted By Yimetime
I actually got it eventually, thanks. The push...

I actually got it eventually, thanks. The push and pull was just a little vague
Forum: Cosmetics and Lighting Modification Discussions 05-23-2016, 08:34 PM
Replies: 56
Views: 45,660
Posted By Yimetime
Does anyone know how to remove the black locking...

Does anyone know how to remove the black locking ring around the HID bulb? No one shows themselves removing the ring on YouTube and the OP's instructions just say push and push but that doesn't help..
Forum: 5th Gen Camaro SS LS LT General Discussions 05-20-2016, 01:49 PM
Replies: 49
Views: 8,725
Posted By Yimetime
I have FEAR IT, as you might be able to see from...

I have FEAR IT, as you might be able to see from my sig
Forum: Cosmetics and Lighting Modification Discussions 05-17-2016, 02:20 PM
Replies: 0
Views: 571
Posted By Yimetime
12v Center Console outlet smoked and broke, anyone know how to fix?

Please delete, got it fixed on my own
Forum: 5th Gen Camaro SS LS LT General Discussions 05-14-2016, 12:20 PM
Replies: 3
Views: 1,231
Posted By Yimetime
Not to mention the Z28 has the 2014 lines so some...

Not to mention the Z28 has the 2014 lines so some parts may not be compatible with our pre-facelifted 5th gens
Forum: Cosmetics and Lighting Modification Discussions 05-02-2016, 09:55 AM
Replies: 4
Views: 1,785
Posted By Yimetime
That's my thing too, I am running off road pipes...

That's my thing too, I am running off road pipes on glass packs so my current tips get incredibly sooty anyways.
Forum: Cosmetics and Lighting Modification Discussions 05-02-2016, 09:22 AM
Replies: 4
Views: 1,785
Posted By Yimetime
Black Chrome or Gloss Black Exhaust Tips

Hi Camaro5! I got my new diffuser and quad tips coming in for my car and plan on either getting the steel tips powder coated a dark black chrome or Gloss Black. Anyone have any input on this or...
Forum: Suspension / Brakes / Chassis 04-24-2016, 12:25 PM
Replies: 8
Views: 1,810
Posted By Yimetime
Hmm interesting, so my best bet would be to do...

Hmm interesting, so my best bet would be to do the FE4 conversion. But that means I would need to get new FE4 compatible sway bars at the same time because my current sway bars would not fit...
Forum: Exterior Parts & Accessories 04-23-2016, 02:45 PM
Replies: 9
Views: 1,824
Posted By Yimetime
I have some black T4 ports that are scratched but...

I have some black T4 ports that are scratched but it might be possible to sand them down and repaint. If I have time I will PM you some pics. They were on my car until someone backed up into me and...
Forum: Suspension / Brakes / Chassis 04-23-2016, 02:25 PM
Replies: 8
Views: 1,810
Posted By Yimetime
BMR Sways and FE4 conversion end links?

So I am fairly set on these BMR sway bars http://www.bmrsuspension.com/?page=products&productid=472. My question is that they recommend purchasing rear end links with new sway bars. I was wondering...
Forum: Cosmetics and Lighting Modification Discussions 04-15-2016, 12:44 PM
Replies: 12
Views: 2,284
Posted By Yimetime
I got the kit from Gen5DIY. The white is alright...

I got the kit from Gen5DIY. The white is alright though by no means fantastic as a pure white is difficult to get with an RGB LED. T be honest I have tended to stick to other colors with no trouble...
Forum: Cosmetics and Lighting Modification Discussions 04-12-2016, 02:01 PM
Replies: 21
Views: 2,889
Posted By Yimetime
I got the SLP ebay splitter and painted it...

I got the SLP ebay splitter and painted it myself! Thanks for the input guys :)
Forum: 5th Gen Camaro SS LS LT General Discussions 04-05-2016, 12:08 PM
Replies: 18
Views: 4,748
Posted By Yimetime
thanks for the input guys!, now I just need to...

thanks for the input guys!, now I just need to mull over pulling the trigger on the diffuser and tips...most likely would just go chrome and paint them myself, i can't find any 3 inch inlet 4 inch...
Forum: 5th Gen Camaro SS LS LT General Discussions 04-05-2016, 10:07 AM
Replies: 18
Views: 4,748
Posted By Yimetime
Will that hold up, or are my better options going...

Will that hold up, or are my better options going to be powder coating or ceramic coating?
Forum: 5th Gen Camaro SS LS LT General Discussions 04-05-2016, 09:55 AM
Replies: 18
Views: 4,748
Posted By Yimetime
Where to find black quad tips?

I am looking at doing the 1LE diffuser swap on my 2011 SS along with quad tips. I have a black theme going and want black tips. Obviously I can find chrome tips easily, however I'd rather skip...
Forum: Cosmetics and Lighting Modification Discussions 03-29-2016, 04:12 PM
Replies: 21
Views: 2,889
Posted By Yimetime
Thoughts on Front Splitter without other Body Kit Pieces?

Basically as the title says, I am mulling over a front splitter/spoiler, such as the RPI or SLP one specifically. My car is black, stock ride height. Just want some input on how it would look if I...
Forum: Cosmetics and Lighting Modification Discussions 03-25-2016, 09:38 AM
Replies: 7
Views: 1,901
Posted By Yimetime
I'll chime in, I did not think it did. A foot or...

I'll chime in, I did not think it did. A foot or two around it as you crack it open with a screwdriver it MAYBE does have a slight odor. More than anything it was the silicon you use to reseal it...
Forum: Cosmetics and Lighting Modification Discussions 03-23-2016, 01:19 PM
Replies: 395
Views: 80,305
Posted By Yimetime
This is likely a shot in the dark, but is there...

This is likely a shot in the dark, but is there anything similar that can be made using the Sparks Restoration front SS emblems? I very much doubt it since its a solid billet emblem front to back,...
Forum: Cosmetics and Lighting Modification Discussions 03-09-2016, 09:22 PM
Replies: 8
Views: 1,577
Posted By Yimetime
I was referring to a black frame going over the...

I was referring to a black frame going over the white border of the plate. Its not hiding anything. Your post sounded snarky and insulting so I responded in kind. :focus:
Forum: Cosmetics and Lighting Modification Discussions 03-09-2016, 09:05 PM
Replies: 8
Views: 1,577
Posted By Yimetime
That's not what I am asking, read the title. I...

That's not what I am asking, read the title. I am asking for a bracket, that will let me represent my school. I am only using legal brackets, so don't try and belittle me. I am just seeing if a...
Forum: Cosmetics and Lighting Modification Discussions 03-09-2016, 08:22 PM
Replies: 8
Views: 1,577
Posted By Yimetime
Custom License Plate Brackets?

Hi Camaro5! I am getting a new custom plate for my car and need a new bracket. I am actually a law school student and would be interested in a frame that says the name of my school, do you guys know...
Forum: Cosmetics and Lighting Modification Discussions 01-13-2016, 10:06 AM
Replies: 9
Views: 2,348
Posted By Yimetime
White LED EBay Sidemarkers?

http://m.ebay.com/itm?itemId=181923124047


Anyone have these or have any thoughts on them?
Forum: USA - Texas 01-07-2016, 12:58 PM
Replies: 2
Views: 1,247
Posted By Yimetime
Anyone know a shop that can install the Gen5DIY/JDP RGB Halos in DFW?

As the title says, I have the kit from gen5diy coming in and am capable of doing it myself but am just wondering if there are any shops that would do it for a reasonable labor cost?
Forum: USA - Rockies / Midwest 08-21-2015, 10:14 AM
Replies: 2,327
Views: 267,353
Posted By Yimetime
Anyone here live in Lawrence? I am going to law...

Anyone here live in Lawrence? I am going to law school at KU
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-11-2015, 06:58 PM
Replies: 9
Views: 1,633
Posted By Yimetime
I bought the entire shifter assembly to replace...

I bought the entire shifter assembly to replace the part that broke just like yours, except I can't figure out how you remove the shifter assembly, anyone know?
Showing results 1 to 30 of 58
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 10:43 AM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.