Homepage Garage Wiki Register Members List Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 30 of 45
Search took 0.01 seconds.
Search: Posts Made By: Heater
Forum: ZL1 Discussions 02-01-2020, 12:09 PM
Replies: 27
Views: 1,616
Posted By Heater
A lot of gas stations have backup generators and...

A lot of gas stations have backup generators and are required to switch over during a blackout so people can fill their tanks. The generators run on natural gas, diesel, etc. This is required by...
Forum: Tuning / Diagnostics 01-30-2020, 06:29 PM
Replies: 3
Views: 746
Posted By Heater
Not a diss to any vendors on here, but there is a...

Not a diss to any vendors on here, but there is a lot of tuners with a lot of knowledge outside this website. It would be helpful to have that data.

One of the first times I browsed this site...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 01-30-2020, 03:46 AM
Replies: 19
Views: 967
Posted By Heater
If you are worried about it, ask them if it is an...

If you are worried about it, ask them if it is an issue. Then you will probably give off some good vibes by being the friendly new neighbor. Or could be a non issue.

Edit: oooooh actually just...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 01-30-2020, 03:19 AM
Replies: 8
Views: 640
Posted By Heater
i used 2 10 inch race ramps wheel cribs, which...

i used 2 10 inch race ramps wheel cribs, which gets the front end very high so i was fairly "comfortable". I would recommend using as much heat protection as possible and get a starter heat wrap...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-29-2020, 08:58 PM
Replies: 85
Views: 3,572
Posted By Heater
wait for chevy red tag sale in august, they will...

wait for chevy red tag sale in august, they will have some around 25% off but you will need to travel to find one and it might not be the exact spec wanted, but for the best deal it is hard to beat....
Forum: ZL1 Discussions 01-28-2020, 06:18 PM
Replies: 19
Views: 801
Posted By Heater
I carry around a small portable air compressor...

I carry around a small portable air compressor and patch kit, it is in a small bag along with some other tools.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 01-27-2020, 02:06 PM
Replies: 12
Views: 658
Posted By Heater
you should take it out of the car, can't you...

you should take it out of the car, can't you remove the drive side from the top? i think that was the easy part of the install compared to the passenger side.
Forum: Forced Induction Discussions 01-27-2020, 04:46 AM
Replies: 6
Views: 279
Posted By Heater
lol

lol
Forum: Forced Induction Discussions 01-26-2020, 11:23 PM
Replies: 5
Views: 370
Posted By Heater
run the stock lt1 valley cover or get a dod...

run the stock lt1 valley cover or get a dod delete cover from someone like cordes or katech. the lt4 vents upwards into the SC so it really isn't needed since you have it welded.

you can keep...
Forum: Forced Induction Discussions 01-26-2020, 11:19 PM
Replies: 5
Views: 370
Posted By Heater
oh its welded shut? that means you can run your...

oh its welded shut? that means you can run your lt1 vc i believe. the lt4 vc vents to the blower. i can double check in the morning with my old valley to confirm.

regardless, get a catch can. ...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-26-2020, 10:22 PM
Replies: 24
Views: 1,478
Posted By Heater
wow that is sad, maybe it would be good to...

wow that is sad, maybe it would be good to mention the picture in the title. not really sure why you posted it
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-26-2020, 03:08 PM
Replies: 41
Views: 2,446
Posted By Heater
Mighty Mouse! Great hardware and support!

Mighty Mouse! Great hardware and support!
Forum: ZL1 Discussions 01-26-2020, 02:55 PM
Replies: 47
Views: 2,168
Posted By Heater
looks killer!

looks killer!
Forum: Dragstrip and Launching Discussion 01-26-2020, 01:54 PM
Replies: 8
Views: 333
Posted By Heater
wow i wonder if that is new or if they are just...

wow i wonder if that is new or if they are just checking closely now. nonetheless get the suite the 3.2a/15 sounds helpful if the car is on fire.

SFI Rating TPP Value Time to 2nd Degree Burn...
Forum: Dragstrip and Launching Discussion 01-26-2020, 04:20 AM
Replies: 8
Views: 333
Posted By Heater
Wow interesting, your location is Mesa, was this...

Wow interesting, your location is Mesa, was this at wildhorse?
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-26-2020, 03:36 AM
Replies: 107
Views: 6,099
Posted By Heater
Wow that is awesome! On a more serious...

Wow that is awesome!

On a more serious note, if this was a ford I would be more likely to rep the tow hook... since i would probably need it more LOL
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 01-25-2020, 10:15 PM
Replies: 39
Views: 1,927
Posted By Heater
for da gram :coolpics:

for da gram :coolpics:
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-23-2020, 04:26 AM
Replies: 17
Views: 824
Posted By Heater
It sounds fine to me, I wouldn't worry about it.

It sounds fine to me, I wouldn't worry about it.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-22-2020, 07:26 PM
Replies: 23
Views: 1,446
Posted By Heater
LOL :)

LOL :)
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-22-2020, 04:37 PM
Replies: 23
Views: 1,446
Posted By Heater
The blades are vin encoded? LOL this gave me a...

The blades are vin encoded? LOL this gave me a good chuckle, i hear the wiper fluid is specifically formulated for our Camaro's too, but you need to get the correct formulation for your model or it...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 01-19-2020, 05:44 PM
Replies: 28
Views: 1,244
Posted By Heater
Milwaukee M18 Impact worked like a charm for me,...

Milwaukee M18 Impact worked like a charm for me, do you have the 3 settings and is it on full charge?

How did you heat the bolt up?
Forum: Forced Induction Discussions 01-19-2020, 01:57 PM
Replies: 39
Views: 1,422
Posted By Heater
WX installed the griptec hub and supplied the...

WX installed the griptec hub and supplied the griptec pulley which is super easy to put on as it is like small bolts to install. So if you ever change it you just need to buy a pulley and belt and...
Forum: Forced Induction Discussions 01-19-2020, 01:53 PM
Replies: 39
Views: 1,422
Posted By Heater
Not sure why i said "produce a little more power...

Not sure why i said "produce a little more power due to heat." but clearly that is false, i think i meant to put a comma and probably meant to write compression after! nice catch!
Forum: Forced Induction Discussions 01-15-2020, 09:03 PM
Replies: 39
Views: 1,422
Posted By Heater
It would make sense the same blower/psi would...

It would make sense the same blower/psi would make more power on the higher compression ratio, as long as you have the fuel and octane needed.

The lt4 supercharger is 1.7l so it is small and...
Forum: Forced Induction Discussions 01-15-2020, 12:14 PM
Replies: 39
Views: 1,422
Posted By Heater
They are both great, I recommend both as they...

They are both great, I recommend both as they have good customer service, are responsive and knowledgeable. This was a new kit from WX and I wanted something next day so it was easier to just...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-14-2020, 08:52 PM
Replies: 26
Views: 1,802
Posted By Heater
15+ years, that doesn't include 5th gens or 6th...

15+ years, that doesn't include 5th gens or 6th gens due to the age. A lot of the 4th gen has been kept and turned into race cars!

A lot of the older gens have been restored and once someone...
Forum: Forced Induction Discussions 01-14-2020, 08:34 PM
Replies: 39
Views: 1,422
Posted By Heater
Unfortunately not for a few states, but i will be...

Unfortunately not for a few states, but i will be running e85 soon and the lack of 93 availability just encouraged me to get a cam.

I got 1 of the first LT4 kits from weapon X, they were...
Forum: Forced Induction Discussions 01-14-2020, 12:35 AM
Replies: 39
Views: 1,422
Posted By Heater
Not exactly, well not at all actually, i have the...

Not exactly, well not at all actually, i have the bypass completely plugged off so it doesn't work like the zl1. However, I don't get 9psi the entire time my car is driving when the rpms are low the...
Forum: Forced Induction Discussions 01-13-2020, 07:27 PM
Replies: 39
Views: 1,422
Posted By Heater
I am running 91 for now and should be on e85 soon...

I am running 91 for now and should be on e85 soon after i get everything installed. For now my boost is a bit higher than i would like at 9psi since i have the limited octane and my timing is...
Forum: Forced Induction Discussions 01-12-2020, 11:27 PM
Replies: 39
Views: 1,422
Posted By Heater
there is more info on the c7 forums, i would dig...

there is more info on the c7 forums, i would dig around a bit if it concerns you.

It has worked fine for me, I get 20 mpg on trips from phx to vegas and phx to la driving aggressively but...
Showing results 1 to 30 of 45

 
Forum Jump

All times are GMT -5. The time now is 08:48 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2020, vBulletin Solutions, Inc.