Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Phastek Performance


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.07 seconds. Search: Posts Made By: ctrlz
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls Yesterday, 09:53 AM
Replies: 6
Views: 1,639
Posted By ctrlz
Sounds like too much play/wear in one of the...

Sounds like too much play/wear in one of the universals on the driveshaft.
not normal.
yes, it could be something internal to the transmission or differential, but that is much bigger headache....
Forum: ZL1 Discussions Yesterday, 09:36 AM
Replies: 21
Views: 348
Posted By ctrlz
This is what I do. Mine stuck once after a...

This is what I do.
Mine stuck once after a wash, because I pulled it straight into the garage and it sat for 2 days. Now it gets a 1/2 mile trip around the block and no issue.
Forum: 2016+ Camaro: 6th Gen Camaro general forum Yesterday, 09:33 AM
Replies: 25
Views: 762
Posted By ctrlz
If we're talking about 1-2 HP, that has gotta be...

If we're talking about 1-2 HP, that has gotta be within the margin of error for any device measuring HP.

Any filter which flows more freely will only do so until it is partially clogged. The...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-13-2024, 07:29 AM
Replies: 2
Views: 325
Posted By ctrlz
Info galore in this recent thread! ...

Info galore in this recent thread!
https://www.camaro6.com/forums/showthread.php?t=624838
Forum: Road Course/Track and Autocross 05-08-2024, 01:16 PM
Replies: 7
Views: 533
Posted By ctrlz
Those pads look pretty good, and based on the...

Those pads look pretty good, and based on the rusty surface I'd guess they were the stock semi-metallic and not the Z26 ceramic.
I would look over the brake booster pump (behind left headlight) and...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-08-2024, 06:30 AM
Replies: 2
Views: 244
Posted By ctrlz
I agree. I would seal it with something...

I agree.
I would seal it with something compatible with plastic. You really don't want to use thread tape with a male metal part going into female plastic as it might crack it.
Forum: Forced Induction Discussions 05-06-2024, 11:39 AM
Replies: 20
Views: 941
Posted By ctrlz
Rich and lean at the same time... this is an...

Rich and lean at the same time... this is an interesting problem.
From what I read this is usually an oscillation problem. Bad O2 sensor, but you already checked that.
Check the MAF.

When you...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-06-2024, 10:38 AM
Replies: 7
Views: 565
Posted By ctrlz
Check out post #3. $200 for a full flush on a...

Check out post #3. $200 for a full flush on a lift:
https://www.camaro6.com/forums/showthread.php?t=611952
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 05-06-2024, 09:35 AM
Replies: 6
Views: 581
Posted By ctrlz
Thanks for sharing those photos, which are quite...

Thanks for sharing those photos, which are quite disturbing.
Let's hope our OP got this all fixed up before that kind of trouble started brewing!
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-06-2024, 09:32 AM
Replies: 7
Views: 565
Posted By ctrlz
What is the mileage on the car? If you like...

What is the mileage on the car?
If you like doing things yourself, I would follow the above advice and check out youtube. I suspect most people are doing a partial fluid change (drain and refill)...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-03-2024, 01:01 PM
Replies: 1
Views: 502
Posted By ctrlz
Was this subject to the recall and was the work...

Was this subject to the recall and was the work done?
My 2017 is under recall for this, but I have not had the unit changed, as I don't want dealer service messing with my car if there is not a...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 05-02-2024, 08:44 AM
Replies: 19
Views: 830
Posted By ctrlz
I agree. Below is the description of PCV...

I agree.
Below is the description of PCV operation for the I4, taken from the repair manual. This system is more complex because of the turbo.

DESCRIPTION AND OPERATION > CRANKCASE VENTILATION...
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 05-01-2024, 06:38 AM
Replies: 7
Views: 654
Posted By ctrlz
Makes perfect sense to me to run your new...

Makes perfect sense to me to run your new negative cable for the amp through that field sensor. Otherwise the load is not "seen" by the power management.
You could interrupt existing ground cable...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-30-2024, 10:54 AM
Replies: 19
Views: 830
Posted By ctrlz
I did find a thread in the I4 section on catch...

I did find a thread in the I4 section on catch cans.
Again, these are not straightforward bolt-ons because of the varying pressures caused by turbocharging....
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-30-2024, 09:40 AM
Replies: 19
Views: 830
Posted By ctrlz
You also have to look at how your modified...

You also have to look at how your modified plumbing might affect wastegate management.
Modern turbo cars use a bypass valve which sends metered air back to the intake. It complicates the plumbing...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 04-30-2024, 06:37 AM
Replies: 6
Views: 581
Posted By ctrlz
I said the same is this duplicate thread: ...

I said the same is this duplicate thread:
https://www.camaro6.com/forums/showthread.php?t=625227
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-29-2024, 03:59 PM
Replies: 19
Views: 830
Posted By ctrlz
This sounds like a lot of oil. You should check...

This sounds like a lot of oil. You should check out some of the catch can threads here with photos. Filling up the can in 400 miles is not normal.
Did you install the intake first? That may have...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-29-2024, 03:23 PM
Replies: 19
Views: 830
Posted By ctrlz
I think you have a pre-cat leak from your new...

I think you have a pre-cat leak from your new downpipe installation. This is likely the cause of all your codes. Air is getting in and the O2 sensor is reading lean. Have you checked fuel trims to...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-29-2024, 09:09 AM
Replies: 9
Views: 985
Posted By ctrlz
Relay click but starter doesn't crank the engine....

Relay click but starter doesn't crank the engine.
Could be the starter or anything in the electrical path to the starter (through the relay contacts).
You will see a lot of threads on here about...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-28-2024, 04:17 PM
Replies: 3
Views: 523
Posted By ctrlz
https://www.youtube.com/watch?v=zLa8K0b71e8

https://www.youtube.com/watch?v=zLa8K0b71e8
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-25-2024, 01:37 PM
Replies: 2
Views: 318
Posted By ctrlz
Check this out. Might be the injectors: ...

Check this out. Might be the injectors:
https://www.camaro6.com/forums/showthread.php?t=550900
Forum: Cosmetic Maintenance - Wash, Wax, Detailing, Exterior Repairs 04-25-2024, 08:58 AM
Replies: 6
Views: 1,417
Posted By ctrlz
Bumper covers are typically EPDM, which is...

Bumper covers are typically EPDM, which is basically polypropylene (PP) with a stiffener. You can do minor filling with a hot glue gun, which is sticks of PP. Fixing a crack requires some bracing...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-25-2024, 08:53 AM
Replies: 19
Views: 1,624
Posted By ctrlz
Yeah, start here!

Yeah, start here!
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-24-2024, 11:01 AM
Replies: 14
Views: 1,210
Posted By ctrlz
That car caught my eye, and nice story to go with...

That car caught my eye, and nice story to go with it.

Do they still recommend changing to hardened valve seats on heads from the leaded fuel era (pre-1972)?
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 04-22-2024, 11:24 AM
Replies: 7
Views: 660
Posted By ctrlz
https://www.corvetteforum.com/forums/c6-tech-perfo...

https://www.corvetteforum.com/forums/c6-tech-performance/4211462-anybody-ever-have-any-metal-shavings-glitter-in-there-oil.html
I like the magnet idea.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-22-2024, 09:55 AM
Replies: 2
Views: 588
Posted By ctrlz
try a PM to katech. Check out the multiple oil...

try a PM to katech. Check out the multiple oil pump failure threads in the ZL1 sub-section.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-19-2024, 11:05 AM
Replies: 13
Views: 1,110
Posted By ctrlz
While I absolutely LOVE this answer, I think...

While I absolutely LOVE this answer, I think there is a possibility there may be some default functionality.
From what I have read some cars will default to 3rd gear and limp mode when the ECM loses...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-18-2024, 10:40 AM
Replies: 15
Views: 1,329
Posted By ctrlz
On a car, it can be a PITA. This is for his...

On a car, it can be a PITA.
This is for his home air handler. Usually easier to service the main bits compared to a car.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-18-2024, 07:09 AM
Replies: 15
Views: 1,329
Posted By ctrlz
Blower motors (both new and used) on ebay run a...

Blower motors (both new and used) on ebay run a couple hundred bucks.
Just in case you can DIY.
ECM might carry extended warranty.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-17-2024, 01:42 PM
Replies: 15
Views: 1,329
Posted By ctrlz
Sheesh! And I'm only a 30-year member of this...

Sheesh! And I'm only a 30-year member of this club.
There is NO hope:cry:
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 07:16 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.