Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 30 of 362
Search took 0.03 seconds.
Search: Posts Made By: cjperformance
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-25-2022, 08:22 PM
Replies: 25
Views: 1,084
Posted By cjperformance
Didn't even know they made 89 in lb torque to...

Didn't even know they made 89 in lb torque to yield bolts.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-25-2022, 08:20 PM
Replies: 15
Views: 489
Posted By cjperformance
If it'd repeatable more than a few times. It's...

If it'd repeatable more than a few times. It's not the learning. Should resolve itself eventually. For example when I first installed the stall converter, it would slam into second, after a couple...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-25-2022, 05:25 PM
Replies: 10
Views: 535
Posted By cjperformance
What happened to the last 2? :D

What happened to the last 2? :D
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-25-2022, 04:57 PM
Replies: 15
Views: 489
Posted By cjperformance
Not so much learning your driving patterns, but...

Not so much learning your driving patterns, but rather it just adapting clutch apply speed and sync with engine torque management because it wasn't "trained" properly from the factory. An attempt to...
Forum: Forced Induction Discussions 05-25-2022, 04:12 PM
Replies: 4
Views: 226
Posted By cjperformance
Left it out on mine. The 2019+ kits dont include...

Left it out on mine. The 2019+ kits dont include a relocate kit... I haven't had any issues. I dont race it on a road course or anything, but I do have my foot in it a lot. And yeah, i put a 2019 kit...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-25-2022, 04:09 PM
Replies: 15
Views: 489
Posted By cjperformance
I believe they take some time to "learn" how to...

I believe they take some time to "learn" how to shift. The A8 does/did anyway. Not sure how many times it's done that particular shift, but it could take "a few times" to work itself out. When I...
Forum: Forced Induction Discussions 05-24-2022, 06:41 AM
Replies: 26
Views: 2,374
Posted By cjperformance
If i recall, the new injectors come with new...

If i recall, the new injectors come with new clips. I just carefully used a large flathead screwdriver and needlenose pliers to remove them. No issues. Putting them back on was pretty easy by hand. A...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-24-2022, 06:29 AM
Replies: 13
Views: 432
Posted By cjperformance
Do you need to get the tune adjusted for manifold...

Do you need to get the tune adjusted for manifold volume and MAF characteristics?
Forum: ZL1 Discussions 05-24-2022, 06:24 AM
Replies: 24
Views: 2,032
Posted By cjperformance
AWD or anything to improve traction. We've...

AWD or anything to improve traction. We've reached close to theoretical limits of traction already with RWD. On the other hand... maybe it'd be less fun that way :D
Forum: Transmissions 05-21-2022, 05:49 PM
Replies: 2
Views: 248
Posted By cjperformance
Consider replacing w a one piece ds.

Consider replacing w a one piece ds.
Forum: Forced Induction Discussions 05-20-2022, 01:03 PM
Replies: 367
Views: 34,333
Posted By cjperformance
Here's the screenshots you requested via PM....

Here's the screenshots you requested via PM. Can't say it will work for you, just what I have :)
Forum: Forced Induction Discussions 05-20-2022, 11:38 AM
Replies: 367
Views: 34,333
Posted By cjperformance
:mad2: :mad2::mad2::mad2::mad2: next wow or mm is...

:mad2: :mad2::mad2::mad2::mad2: next wow or mm is july. Need to get another run in to, hopefully, erase the 11.5 in my sig with something better.
Forum: Forced Induction Discussions 05-19-2022, 11:32 AM
Replies: 367
Views: 34,333
Posted By cjperformance
Hey, didn't see your post until today. Sometimes...

Hey, didn't see your post until today. Sometimes the boards are weird about sending me notifications. Yes, as far as I can tell, the tables should match and have the same axis. Mine do. In fact... I...
Forum: Dragstrip and Launching Discussion 05-16-2022, 06:10 PM
Replies: 53
Views: 1,506
Posted By cjperformance
Does that work the same on the A8? That table was...

Does that work the same on the A8? That table was increased on mine with the trans tune, but i havent been able to get to the track to see the difference. I had the converter put in too... so i guess...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-15-2022, 06:41 AM
Replies: 55
Views: 2,570
Posted By cjperformance
Not sure if recommend for this specific...

Not sure if recommend for this specific application, but i was trained to apply a good nondirectional resurfacing of the rotor with a wire wheel or light abrasive. This will prep a lightly used rotor...
Forum: Tuning / Diagnostics 05-14-2022, 07:14 AM
Replies: 13
Views: 423
Posted By cjperformance
In 90 degree weather i see a max of 76 to 78...

In 90 degree weather i see a max of 76 to 78 lbs/min, in 60 degrees, i see 78 to 81 lbs/min. Cooler air is more dense, and given the same displacement, pressure, rpm, etc a greater mass of air will...
Forum: Tuning / Diagnostics 05-13-2022, 05:58 PM
Replies: 13
Views: 423
Posted By cjperformance
441 wheel should be around 490 crank, so that...

441 wheel should be around 490 crank, so that correlates well with 48 lbs/min.
Forum: Tuning / Diagnostics 05-13-2022, 10:57 AM
Replies: 13
Views: 423
Posted By cjperformance
I have seen as high as 84 lbs/min at the very top...

I have seen as high as 84 lbs/min at the very top end of my charts, mostly an outlier thing... what is the approach when maf is expected to exceed that 86 lbs/min value? Is that just for the torque...
Forum: Tuning / Diagnostics 05-13-2022, 10:53 AM
Replies: 1
Views: 161
Posted By cjperformance
I heard this one time. Sounded like a solenoid...

I heard this one time. Sounded like a solenoid chattering or something. Somewhere between a beep and buzz. Haven't heard it since. Never found out what it was. Had to start the car and shut if off...
Forum: Tuning / Diagnostics 05-13-2022, 07:16 AM
Replies: 13
Views: 423
Posted By cjperformance
Airflow lbs/min on FI vs NA relationship to hp

Im just theoretically speaking here. I know its a just an approximation.

Reputable tuners have said 1 lb/min airflow = 10 hp. That is assuming your tune is perfect with spark, afr, etc... i...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-13-2022, 06:43 AM
Replies: 13
Views: 1,081
Posted By cjperformance
:twitch:

:twitch:
Forum: ZL1 Discussions 05-12-2022, 07:21 AM
Replies: 37
Views: 1,491
Posted By cjperformance
GM chose to put its R&D into the vette and none...

GM chose to put its R&D into the vette and none in the camaro. The two cars are mostly the same market/buyer. The rear seats in my camaro dont even fit my kids all that well, so its just extra...
Forum: General Automotive + Other Cars Discussion 05-12-2022, 07:05 AM
Replies: 46
Views: 2,559
Posted By cjperformance
Gonna need to start marketing headers and...

Gonna need to start marketing headers and aftermarket exhaust for those generators now.
Forum: General Automotive + Other Cars Discussion 05-12-2022, 06:58 AM
Replies: 46
Views: 2,559
Posted By cjperformance
They will almost certainly lose range and ability...

They will almost certainly lose range and ability to hold a charge over time. Just like a laptop or phone battery... when you first use it, you can run your phone for days w/o charging, but a couple...
Forum: Tuning / Diagnostics 05-11-2022, 01:44 PM
Replies: 43
Views: 2,573
Posted By cjperformance
No, but i also didn't have enough play to remove...

No, but i also didn't have enough play to remove it just by removing the converter and manifold outlet nuts. I had to remove the studs on the manifold outlet too. Luckily they were not rusted in.
...
Forum: General Automotive + Other Cars Discussion 05-11-2022, 01:37 PM
Replies: 46
Views: 2,559
Posted By cjperformance
companies are in it for profit. guarantee they...

companies are in it for profit. guarantee they aren't doing this for any other reason. companies feel like they can make more money off folks with EV. just wait till they start surcharging for...
Forum: ZL1 Discussions 05-11-2022, 06:53 AM
Replies: 22
Views: 1,016
Posted By cjperformance
Testing 60-130 you are much less traction limited...

Testing 60-130 you are much less traction limited too, so measurements can be more accurate on higher hp builds w/o factoring tire slip.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-09-2022, 10:42 AM
Replies: 21
Views: 1,083
Posted By cjperformance
Yeah, like driving over the rumble strips on the...

Yeah, like driving over the rumble strips on the side of the road. That bad... at least mine was.
Forum: Dragstrip and Launching Discussion 05-09-2022, 06:40 AM
Replies: 25
Views: 990
Posted By cjperformance
Getting the wheelspin sorted is first order of...

Getting the wheelspin sorted is first order of business. Sounds like you are already feeling out the limits. Nannies and everything else really wont help if your tires and track combo dont support a...
Forum: Wheels | Tires -- Sponsored by The Tire Rack 05-06-2022, 07:00 AM
Replies: 6
Views: 629
Posted By cjperformance
Depends on what you buy. Some yes, some no. Cheap...

Depends on what you buy. Some yes, some no. Cheap ones, prob no. Anything less than $400-$500 per wheel is prob sketchy. Even at that price you arent guaranteed a high quality wheel. My Racestar...
Showing results 1 to 30 of 362

 
Forum Jump

All times are GMT -5. The time now is 07:41 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2022, vBulletin Solutions, Inc.