Homepage Garage Wiki Register Members List Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 30 of 500
Search took 0.07 seconds.
Search: Posts Made By: Joe M 2012 2SS
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 12-25-2020, 07:24 AM
Replies: 7
Views: 1,055
Posted By Joe M 2012 2SS
If you have faded places this is likely...

If you have faded places this is likely "bleaching", caused by UV rays from the sun.
There isn't any product that will remove this.
The VRP is fine on the interior.
You'll want to clean the areas...
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 12-15-2020, 04:58 PM
Replies: 11
Views: 1,234
Posted By Joe M 2012 2SS
Another good idea is to get containers to store...

Another good idea is to get containers to store your towels in while not in use.
This will keep them free of any dust or contaminates.

They hold a good amount of towels. These are Sterilite...
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 12-13-2020, 07:17 AM
Replies: 11
Views: 1,234
Posted By Joe M 2012 2SS
Do not use regular soap. Use free/clear. I've...

Do not use regular soap. Use free/clear. I've been using Purex for a few years and it works great, and it's inexpensive.

Don't mix microfiber with cotton towels, you will have lint all over your...
Forum: Dragstrip and Launch Techniques Discussion 12-06-2020, 06:07 PM
Replies: 5
Views: 904
Posted By Joe M 2012 2SS
Not too sure about this, my ET Street R's are at...

Not too sure about this, my ET Street R's are at the wear marks, and my last 3 trips to the strip, they don't hook. 60' times are off 2.5 tenths.
I have a brand new set and for comparison sake, the...
Forum: 5th Gen Camaro SS LS LT General Discussions 12-02-2020, 02:41 PM
Replies: 15
Views: 4,236
Posted By Joe M 2012 2SS
The difference vs. clay is it needs no kneading,...

The difference vs. clay is it needs no kneading, to clean it you rinse with warm water. Instead of being able to see contaminates on it, you will feel them, until it runs smooth.
Unlike clay, this...
Forum: 5th Gen Camaro SS LS LT General Discussions 12-01-2020, 04:50 PM
Replies: 20
Views: 3,816
Posted By Joe M 2012 2SS
I can't speak for any other brands but Circle D...

I can't speak for any other brands but Circle D makes a great product. As far as what stall, that depends on what cam you put in.
If you plan to drag race the car, you will need many upgrades to the...
Forum: Wheels / Tires 12-01-2020, 04:32 PM
Replies: 11
Views: 1,701
Posted By Joe M 2012 2SS
If you decide to ship, I'm interested.

If you decide to ship, I'm interested.
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 11-29-2020, 09:58 PM
Replies: 4
Views: 975
Posted By Joe M 2012 2SS
The blob eliminator will still level the blobs,...

The blob eliminator will still level the blobs, but it will just take much longer.

The faster way is to get the sanding pen, shown in the video, remove the old touch up paint, and re-do it again...
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 11-29-2020, 03:25 PM
Replies: 4
Views: 975
Posted By Joe M 2012 2SS
They can be done to the point where you won't...

They can be done to the point where you won't notice them unless your very close to the car, and you know their location.
I'm assuming you used standard touch up paint, and have a "blob" left that...
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 11-26-2020, 07:08 AM
Replies: 23
Views: 2,784
Posted By Joe M 2012 2SS
Glad you liked the DHydrate. As "towel junkie", I...

Glad you liked the DHydrate. As "towel junkie", I haven't tried one yet that beats it for drying.

I did try one of those Viking towels years ago, and for a towel you can buy locally, it is the...
Forum: Off-topic Discussions 11-12-2020, 08:11 PM
Replies: 714
Views: 105,843
Posted By Joe M 2012 2SS
The link is broken. I have fortunately been...

The link is broken.

I have fortunately been able to work the entire time, and I'm in the aerospace industry.

Two people where I work have contacted it.
One of them I actually expected to, as...
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 10-06-2020, 05:11 AM
Replies: 16
Views: 2,934
Posted By Joe M 2012 2SS
Rapid-Tac adhesive remover.

Rapid-Tac adhesive remover.
Forum: The Sports Lounge 09-13-2020, 06:06 PM
Replies: 118
Views: 36,421
Posted By Joe M 2012 2SS
What's up with the fake crowd noise in the...

What's up with the fake crowd noise in the football games today?
Hilarious, the seats are empty, everyone knows no fans are in attendance.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-19-2020, 04:14 PM
Replies: 24
Views: 3,816
Posted By Joe M 2012 2SS
The cooler lines route underneath as I have told...

The cooler lines route underneath as I have told you repeatedly, I have also told you repeatedly that I didn't install it.
I personally don't need to know if it bypasses or not, all I need to know...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-19-2020, 05:23 AM
Replies: 24
Views: 3,816
Posted By Joe M 2012 2SS
Of course I can, but the cooler is mounted level...

Of course I can, but the cooler is mounted level with the bottom of the radiator. The hoses that run in/out of it are on the bottom, and not visible with the hood open.

I'd suggest you contact B&M...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-18-2020, 04:04 PM
Replies: 24
Views: 3,816
Posted By Joe M 2012 2SS
I cannot get under the car to see. I'm 6' 2"...

I cannot get under the car to see. I'm 6' 2" 225.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-17-2020, 05:23 PM
Replies: 24
Views: 3,816
Posted By Joe M 2012 2SS
I didn't install it myself, was done at same time...

I didn't install it myself, was done at same time my torque converter was installed. It was a B&M with all hardware included.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-17-2020, 04:56 PM
Replies: 7
Views: 800
Posted By Joe M 2012 2SS
Be sure you have a transmission cooler put in as...

Be sure you have a transmission cooler put in as well. I've had my Circle D for 3 years now. I daily the car and run it at the strip. No problems with the transmission, cooler keeps it under 185* F...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-17-2020, 04:27 PM
Replies: 24
Views: 3,816
Posted By Joe M 2012 2SS
I daily my car with a 3200 stall converter and a...

I daily my car with a 3200 stall converter and a trans cooler. Cooler is ALWAYS better for transmissions. Heat is the enemy. 150-165 is terrific during the summer on the highway, it wont run much...
Forum: Cosmetic Maintenance - Wash, Wax, Detailing, Exterior Repairs 08-01-2020, 08:24 AM
Replies: 29
Views: 2,567
Posted By Joe M 2012 2SS
The first thing that needs to be determined is...

The first thing that needs to be determined is what type of water spots are on your car's paint. They are either mineral deposits left from water that has evaporated, or spots etched into the paint....
Forum: Dragstrip and Launch Techniques Discussion 07-28-2020, 02:57 PM
Replies: 13
Views: 1,226
Posted By Joe M 2012 2SS
The Hoosiers would be a good choice if your...

The Hoosiers would be a good choice if your towing your car to the strip. If your driving to and from, they aren't street legal.... the MT ET Street R's are street legal.

At your HP, if you hook,...
Forum: Dragstrip and Launch Techniques Discussion 07-27-2020, 03:50 PM
Replies: 13
Views: 1,226
Posted By Joe M 2012 2SS
With your mods 20" drag radials are a waste of...

With your mods 20" drag radials are a waste of time.
Some 17" ET Street R Bias Ply would cut your 60' and ET a lot.

I wish I could get to 100mph in the 8th on my current mods, I'd break 7...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-25-2020, 05:58 AM
Replies: 9
Views: 1,635
Posted By Joe M 2012 2SS
I'd stay away from Motive. The machining on their...

I'd stay away from Motive. The machining on their gears is not good quality. Even having backlash set perfect, your going to have excessive gear whine.

Go with AAM instead. Their kit is $90 less...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-10-2020, 05:18 AM
Replies: 12
Views: 1,468
Posted By Joe M 2012 2SS
I have DSS 1000hp 1/2 shafts and have had no...

I have DSS 1000hp 1/2 shafts and have had no issues with them. I also have a GForce driveshaft.
GForce has the worst customer service I have dealt with from any company I have bought a mod for my...
Forum: Off-topic Discussions 06-21-2020, 07:25 AM
Replies: 12
Views: 4,321
Posted By Joe M 2012 2SS
Adams Visco Clay is $20.....if you only flip it...

Adams Visco Clay is $20.....if you only flip it over once and never knead it properly, your spending $10 to clay your car. If you fold it and knead it properly, you should be able to use 1 bar 5...
Forum: Off-topic Discussions 06-21-2020, 07:16 AM
Replies: 12
Views: 4,321
Posted By Joe M 2012 2SS
After rinsing in warm water for about a minute,...

After rinsing in warm water for about a minute, it does release everything that is stuck on it.

The surface of the towel does wear down, albeit very slowly, and after 90-100 uses loses it's...
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 06-21-2020, 06:56 AM
Replies: 4
Views: 648
Posted By Joe M 2012 2SS
I wouldn't use car shampoo as a lubricant with...

I wouldn't use car shampoo as a lubricant with this, or any synthetic clay material. It doesn't provide enough lubrication, and you will cause scratching/swirling in your clear coat. Clay lube only....
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 06-16-2020, 03:57 PM
Replies: 6
Views: 960
Posted By Joe M 2012 2SS
I forgot to add...…..When you re-apply the...

I forgot to add...…..When you re-apply the Hydro2, the best soap you can use to wash with is the Carpro Reset. 1.5 oz in a 5 gallon bucket is all you need.

You actually may use this soap, and find...
Forum: Off-topic Discussions 06-16-2020, 03:27 PM
Replies: 12
Views: 4,321
Posted By Joe M 2012 2SS
You don't flip clay to the unused side after...

You don't flip clay to the unused side after using one side, you fold the clay to make two fresh sides, and make it into a patty again. Clay will last much longer this way.

I only use traditional...
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 06-13-2020, 05:05 PM
Replies: 6
Views: 960
Posted By Joe M 2012 2SS
This is one of the Carpro products I am not a fan...

This is one of the Carpro products I am not a fan of, only due to price.
At 50% off it's a better deal.
I really like their Hydrofoam, which is a soap infused with silica, and provides the same...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 04:16 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2021, vBulletin Solutions, Inc.