Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Phastek Performance


Page 1 of 4 1 234
Showing results 1 to 30 of 93
Search took 0.01 seconds. Search: Posts Made By: jorgesvlog
Forum: ZL1 Discussions 05-24-2022, 02:07 PM
Replies: 7
Views: 2,405
Posted By jorgesvlog
Have your tuner turn every engine code to do not...

Have your tuner turn every engine code to do not report and uncheck evertyhing in the ecm. Its al little time consuming, but when done and ecm tune loaded up it will set everything to ready...
Forum: ZL1 Discussions 01-05-2022, 08:54 AM
Replies: 171
Views: 22,953
Posted By jorgesvlog
Thanks King, Yeah the car as it sits will run a 9...

Thanks King, Yeah the car as it sits will run a 9 in this cooler weather. I should be back at the track this month in some 60 degree 0 DA weather to go run the 9 as it sits!
Forum: ZL1 Discussions 08-12-2021, 06:40 AM
Replies: 72
Views: 11,367
Posted By jorgesvlog
Pray Performance tuned the TCM so im not sure...

Pray Performance tuned the TCM so im not sure what else he has modified besides a couple shift points to get 1-2 to shift at 6500 not 6200, and like stated above, I run a full drag pack at the track...
Forum: ZL1 Discussions 08-11-2021, 12:37 PM
Replies: 72
Views: 11,367
Posted By jorgesvlog
I dont have any but there is a table in the...

I dont have any but there is a table in the transmission tcm you can see when you download the 10 speed tcm tune from your unlocked trans thats basically showing a torque limit and the first gear...
Forum: ZL1 Discussions 08-11-2021, 10:19 AM
Replies: 72
Views: 11,367
Posted By jorgesvlog
That is true, but the traction control will take...

That is true, but the traction control will take care of street driving, just dont turn off the traction control completely and you should be ok.
Forum: ZL1 Discussions 08-11-2021, 09:50 AM
Replies: 72
Views: 11,367
Posted By jorgesvlog
All, The ZL1s TCM needs to be unlocked to remove...

All, The ZL1s TCM needs to be unlocked to remove the torque management limiter for 1st gear..... ON the ZL1 the 1st gear has a very low torque limit and if you log your car using hptuners you will...
Forum: ZL1 Discussions 07-23-2021, 10:57 AM
Replies: 5
Views: 990
Posted By jorgesvlog
Yes you can, I run it off an add a fuse off of...

Yes you can, I run it off an add a fuse off of the f42 HVAC fuse in the fuse box in the engine bay with a 5 amp fuse. the gauges dont draw much current at all.
Forum: ZL1 Discussions 06-09-2021, 09:03 AM
Replies: 21
Views: 3,091
Posted By jorgesvlog
Once you have a ported blower and snout, with a...

Once you have a ported blower and snout, with a big gulp the tb becomes the restriction. I have the ported blower and snout on the shelf and a big gulp right now on the car. I plan on running the 103...
Forum: ZL1 Discussions 05-13-2021, 04:30 PM
Replies: 17
Views: 2,466
Posted By jorgesvlog
The car will shift earlier in tour mode but as i...

The car will shift earlier in tour mode but as i showed in my last track video it doesnt matter and shifting yourself just makes you slower lol
Forum: ZL1 Discussions 05-12-2021, 02:17 PM
Replies: 17
Views: 2,466
Posted By jorgesvlog
Great times! The MPH is really good! I would try...

Great times! The MPH is really good! I would try running it with traction completely off. I was able to run a 11.4 on street tires with traction control completely off. I then put rear drag pack and...
Forum: Forced Induction Discussions 03-19-2021, 10:06 AM
Replies: 85
Views: 14,365
Posted By jorgesvlog
Thanks!!!!

Thanks!!!!
Forum: Forced Induction Discussions 03-18-2021, 11:02 AM
Replies: 85
Views: 14,365
Posted By jorgesvlog
Thats awesome, I will be looking to get a similar...

Thats awesome, I will be looking to get a similar set up with dsx low side, lpe big bore, and the fic 30s. That should be able to run full e85 with most bolt ons before needing to do cam and heads!
Forum: Forced Induction Discussions 03-16-2021, 11:35 AM
Replies: 85
Views: 14,365
Posted By jorgesvlog
great information! I was under the impression...

great information! I was under the impression that the LPE big bore was based off the LT1 pump so it should run well at around 2100 psi similar to the stock LT1. you might have a little more room to...
Forum: Dragstrip and Launching Discussion 10-20-2020, 03:37 PM
Replies: 11
Views: 3,540
Posted By jorgesvlog
Nice 60'! I was able to pull off a 1.42 which was...

Nice 60'! I was able to pull off a 1.42 which was my best, and not sure if ill be able to do much better unless i spray a little more than the 40% i have it set at right now. Im on a 17 in et street...
Forum: Forced Induction Discussions 10-20-2020, 03:33 PM
Replies: 13
Views: 2,613
Posted By jorgesvlog
From what i have seen online and around me, if...

From what i have seen online and around me, if you are running nitrous and have just a bolt on set up the most you should rely on to be safe is a 150, If you have heads and cam you might be able to...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-12-2020, 10:58 AM
Replies: 11
Views: 3,942
Posted By jorgesvlog
So for the 2019 10 speed trans my tuner has said...

So for the 2019 10 speed trans my tuner has said that tour is the mode to run in.

As for the c16 i would personally say i recommend it at any level, but it should be fine to run 100 shot on e85...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-04-2020, 09:42 PM
Replies: 11
Views: 3,942
Posted By jorgesvlog
I have a video series for installing the whole...

I have a video series for installing the whole nitrous system complete with standalone and i used a NOS mini 2 controller. I walk through the settings and where to get tach signal from

Look up...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 07-29-2020, 01:44 PM
Replies: 235
Views: 107,232
Posted By jorgesvlog
Do you have a link to the map extension harness?...

Do you have a link to the map extension harness? is it the 3 pin or 4 pin?
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 07-17-2020, 11:15 AM
Replies: 17
Views: 11,292
Posted By jorgesvlog
great comparison! for those with a 10 speed 2019...

great comparison! for those with a 10 speed 2019 or 2020 I would say this is definitely worth it! the 30 or so hp difference in hp you get from shifting the car at closer to 6800 rpm and only...
Forum: Forced Induction Discussions 06-05-2020, 03:26 PM
Replies: 8
Views: 2,666
Posted By jorgesvlog
Yes you are definitely correct. A proper nitrous...

Yes you are definitely correct. A proper nitrous kit ran me 3500 but that included a stand alone fuel system to run c16, the timing controller box, the nitrous progressive controller, and a few other...
Forum: Forced Induction Discussions 06-04-2020, 01:55 PM
Replies: 8
Views: 2,666
Posted By jorgesvlog
I made a post on it but Im running it on my heads...

I made a post on it but Im running it on my heads and cam camaro.

im doing a 100 shot but system is set up tp go up to a 200 if needed with the standalone fuel system and c16 for fuel and e85 in...
Forum: Forced Induction Discussions 04-17-2020, 12:29 PM
Replies: 24
Views: 10,233
Posted By jorgesvlog
No I dont have good drag radials to test that on...

No I dont have good drag radials to test that on the street. Need to get new et street r's. These runs were to data log and check the jet sizing and AFR during the pulls to dial each shot in. 4th...
Forum: Forced Induction Discussions 04-17-2020, 11:06 AM
Replies: 24
Views: 10,233
Posted By jorgesvlog
Finally got to test the nitrous kit out and man...

Finally got to test the nitrous kit out and man did it not disappoint!!! Check out original post for the update and time comparisons between N/A, 50, 100, and a 150(rich afr)
Forum: Forced Induction Discussions 04-15-2020, 01:58 PM
Replies: 78
Views: 23,796
Posted By jorgesvlog
havent read through all those comments but with...

havent read through all those comments but with boost i would recommend the mighty mouse wild catch can with the pcv valve to help with venting crank case without having issues with boost going...
Forum: Forced Induction Discussions 04-15-2020, 10:47 AM
Replies: 2
Views: 762
Posted By jorgesvlog
A progressive controller will allow you to slowly...

A progressive controller will allow you to slowly ramp up the full shot of nitrous so it doesnt shock the engine and drivetrain. My tuner recommended i use a progressive controller if i was going to...
Forum: Forced Induction Discussions 04-15-2020, 09:36 AM
Replies: 24
Views: 10,233
Posted By jorgesvlog
That is interesting! Could you slide out one of...

That is interesting! Could you slide out one of the fittings from the other end?

Nitrous kits are pretty much custom and it took me around 2 weeks of working on the car in the afternoons here and...
Forum: Forced Induction Discussions 04-15-2020, 08:06 AM
Replies: 24
Views: 10,233
Posted By jorgesvlog
Finally got the nitrous kit installed and ready...

Finally got the nitrous kit installed and ready to go! Updated the original post with links to the install series for those looking for help installing their own nitrous kit and dedicated fuel...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 03-27-2020, 09:19 AM
Replies: 15
Views: 2,296
Posted By jorgesvlog
Get a tailpipe exhaust cutter from amazon its...

Get a tailpipe exhaust cutter from amazon its only like 10-20 bucks. Makes it very very easy to cut the exhaust pipes.
Forum: Forced Induction Discussions 03-25-2020, 04:40 PM
Replies: 136
Views: 37,617
Posted By jorgesvlog
What are your thoughts on the air cooled turbos?...

What are your thoughts on the air cooled turbos? do they seem to hold well compared to the oil-less/coolant cooled ones? Air Cooled Turbos sound like the best solution for low mount turbos that...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 03-13-2020, 07:53 AM
Replies: 18
Views: 12,080
Posted By jorgesvlog
I have the lingenfelter rpm limiter/ timing box...

I have the lingenfelter rpm limiter/ timing box and plan to use it more for timing retarding for the nitrous kit, but going to set the rpm limiter just for fun to make noise on a rocker switch that i...
Showing results 1 to 30 of 93
Page 1 of 4 1 234

 
Forum Jump

All times are GMT -5. The time now is 09:45 AM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.