Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Phastek Performance


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.09 seconds. Search: Posts Made By: CW3SF
Forum: ZL1 Discussions 03-19-2024, 02:06 PM
Replies: 68
Views: 2,158
Posted By CW3SF
Flex fuel is the easiest mod to install that I’ve...

Flex fuel is the easiest mod to install that I’ve done on my car. KingLT1 tuned it and took car of the tune part. It literally could not be any easier. I spent just a few minutes installing a...
Forum: ZL1 Discussions 01-06-2024, 04:10 PM
Replies: 28
Views: 1,790
Posted By CW3SF
I have headers and would never go back to stock...

I have headers and would never go back to stock suitcase. AWE with resonators is just right.
Forum: ZL1 Discussions 01-04-2024, 10:07 AM
Replies: 1
Views: 435
Posted By CW3SF
Stock ZL1 pump or upgraded?

Stock ZL1 pump or upgraded?
Forum: ZL1 Discussions 12-26-2023, 06:00 PM
Replies: 22
Views: 1,999
Posted By CW3SF
Lots of variables in that…..if it’s a course with...

Lots of variables in that…..if it’s a course with plenty of straightaways where you can utilize the additional power it’s beneficial. On a slower and shorter course it may not help you. It’s going to...
Forum: ZL1 Discussions 12-25-2023, 06:34 PM
Replies: 22
Views: 1,999
Posted By CW3SF
I’ll second this (or third). The X port really...

I’ll second this (or third). The X port really shines with bolt ons and flex fuel, especially if you do fueling upgrades as part of your bolt ons.
Forum: ZL1 Discussions 12-20-2023, 11:37 AM
Replies: 12
Views: 986
Posted By CW3SF
That depends where your x-pipe is installed. On...

That depends where your x-pipe is installed. On my car I was able to install the resonators in the tunnel in between my two xpipes.
Forum: ZL1 Discussions 12-20-2023, 11:20 AM
Replies: 12
Views: 986
Posted By CW3SF
Mine was too loud after replacing the entire...

Mine was too loud after replacing the entire exhaust to get a better tone. The fix was installing two MBRP resonators between the high flow cats and the axleback. It toned it right down without...
Forum: ZL1 Discussions 12-08-2023, 09:21 AM
Replies: 8
Views: 1,184
Posted By CW3SF
Welcome to the club. ...

Welcome to the club.

https://www.camaro6.com/forums/picture.php?albumid=21491&pictureid=170391
Forum: ZL1 Discussions 11-08-2023, 03:49 PM
Replies: 19
Views: 3,093
Posted By CW3SF
SS front end instead of ZL1? Sorry but no thanks

SS front end instead of ZL1? Sorry but no thanks
Forum: ZL1 Discussions 11-04-2023, 03:18 PM
Replies: 9
Views: 1,222
Posted By CW3SF
I’m in Virginia and I have 2 full sets of oem...

I’m in Virginia and I have 2 full sets of oem wheels. One set has OEM tires with about 5000 miles (half tread) and the other set has brand new tires (never been on the car). I’d sell one set at a...
Forum: ZL1 Discussions 10-31-2023, 03:53 PM
Replies: 100
Views: 8,499
Posted By CW3SF
Thanks! They are Apex VS5RS

Thanks! They are Apex VS5RS
Forum: ZL1 Discussions 10-27-2023, 07:30 PM
Replies: 100
Views: 8,499
Posted By CW3SF
2019 ZL1 and 10,000 miles including initial drive...

2019 ZL1 and 10,000 miles including initial drive from purchasing in Chattanooga, TN to home in Denver and then driving it from Denver to No. Virginia when we moved there. Car is a beast and don’t...
Forum: ZL1 Discussions 10-11-2023, 06:52 AM
Replies: 8
Views: 658
Posted By CW3SF
I removed the suitcase from my 2019 ZL1. I sold...

I removed the suitcase from my 2019 ZL1. I sold the NPP valves but the suitcase would still work for you and the NPP valves would be cheaper than the whole kit. If you can drive up to Northern...
Forum: ZL1 Discussions 10-11-2023, 03:27 AM
Replies: 7
Views: 1,938
Posted By CW3SF
I didn’t replace anything. I just tapped in to...

I didn’t replace anything. I just tapped in to keyed power for the radar detector.
Forum: ZL1 Discussions 10-09-2023, 09:16 PM
Replies: 7
Views: 1,938
Posted By CW3SF
Nope. Ended up removing the whole console to tap...

Nope. Ended up removing the whole console to tap in the backside of the socket for power.
Forum: ZL1 Discussions 10-07-2023, 08:10 AM
Replies: 25
Views: 2,308
Posted By CW3SF
I’ve been running the X Port for about a year and...

I’ve been running the X Port for about a year and half with no issues.
Forum: ZL1 Discussions 09-28-2023, 08:57 AM
Replies: 17
Views: 1,595
Posted By CW3SF
Sounds like a good plan. The big advantage to...

Sounds like a good plan. The big advantage to doing the injectors and HPFP now is that the blower has to to come off to replace them, then it’s only about an hour job to replace both items. I did...
Forum: ZL1 Discussions 09-27-2023, 12:34 PM
Replies: 17
Views: 1,595
Posted By CW3SF
If you are feeling anything resembling “sluggish”...

If you are feeling anything resembling “sluggish” with the X Porting and e50 then your butt dyno is far more tuned than mine LOL. This car is beast at all RPMs. Boost hitting any harder down low...
Forum: ZL1 Discussions 09-25-2023, 09:45 AM
Replies: 17
Views: 1,595
Posted By CW3SF
I’m one of the cars King has tuned. Add the HPFP,...

I’m one of the cars King has tuned. Add the HPFP, +30 injectors and JMS booster and you can make 740whp on e50 using the stock pullies. It is not true that you need to spin the Stage X port faster to...
Forum: ZL1 Discussions 08-22-2023, 07:20 AM
Replies: 50
Views: 4,602
Posted By CW3SF
This is probably the most important bit of...

This is probably the most important bit of information in this thread. More often than not the limiting factor isn’t the height of the ceiling. It’s the height of the garage door when it’s in the...
Forum: ZL1 Discussions 08-18-2023, 01:58 PM
Replies: 24
Views: 4,010
Posted By CW3SF
I have that set up with the JMS booster and stock...

I have that set up with the JMS booster and stock pulleys on my ZL1. E50 in winter and E60 in summer @ sea level and making 740whp uncorrected. Cam, +60 injectors and DSX on my list for next round of...
Forum: ZL1 Discussions 08-16-2023, 11:30 AM
Replies: 28
Views: 2,606
Posted By CW3SF
It’s not just 1LEs. It’s all ZL1s. Anyone whose...

It’s not just 1LEs. It’s all ZL1s. Anyone whose road course raced their car should already know this menu well. I can’t imagine road coursing the car without using them.
Forum: ZL1 Discussions 08-09-2023, 10:11 AM
Replies: 14
Views: 1,474
Posted By CW3SF
Aaron, I’ve been running that RPM belt on stock...

Aaron, I’ve been running that RPM belt on stock pulleys (740 whp) for going on a year and I’ve had NO issues. Even drove it from Denver to Virginia with no problems, and a crap ton of WOT pulls...
Forum: ZL1 Discussions 08-03-2023, 10:14 AM
Replies: 50
Views: 4,602
Posted By CW3SF
My ceilings are 13 ft now. But if the 5 homes...

My ceilings are 13 ft now. But if the 5 homes I’ve lived in with my lift I have used it in one garage that was as low as 8ft 7 in. In that house I fit a Viper and a C5 Corvette. It totally depends on...
Forum: ZL1 Discussions 07-31-2023, 10:27 PM
Replies: 50
Views: 4,602
Posted By CW3SF
I’ve had an Atlas 8000 for about 15 years. I’ve...

I’ve had an Atlas 8000 for about 15 years. I’ve moved it 4 times to different states. Wouldn’t be without it.


https://www.camaro6.com/forums/picture.php?albumid=21491&pictureid=170350
Forum: ZL1 Discussions 07-21-2023, 07:40 AM
Replies: 10
Views: 1,208
Posted By CW3SF
You don’t have to pulley to make power. But to do...

You don’t have to pulley to make power. But to do it without the pulley you need flex fuel, porting, injectors, HPFP and low side help. That isn’t the cheapest way to go but it gets you there without...
Forum: ZL1 Discussions 07-14-2023, 01:44 PM
Replies: 15
Views: 1,279
Posted By CW3SF
Correct

Correct
Forum: ZL1 Discussions 07-14-2023, 10:49 AM
Replies: 15
Views: 1,279
Posted By CW3SF
Yeah it sounds like you have something going on...

Yeah it sounds like you have something going on there. The first things I would check are to make sure you have all the air out of the coolant loop and then make sure you have the supercharger bypass...
Forum: ZL1 Discussions 07-14-2023, 09:32 AM
Replies: 15
Views: 1,279
Posted By CW3SF
I just went back and looked at my threads that I...

I just went back and looked at my threads that I posted at the time to get you the most accurate numbers. And in Denver was 616whp/578wtrq on e84 and making 10 lbs of boost. At sea level now is...
Forum: ZL1 Discussions 07-13-2023, 12:04 PM
Replies: 15
Views: 1,279
Posted By CW3SF
I don’t have Dragy. The car is completely...

I don’t have Dragy. The car is completely different animal than it was in Denver. Night and day difference.
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 01:14 AM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.