Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


KPM Fuel Systems


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.07 seconds. Search: Posts Made By: 6spdhyperblue
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 12-10-2025, 12:03 PM
Replies: 69
Views: 3,004
Posted By 6spdhyperblue
It’s not as bad as it seems u can get the puller...

It’s not as bad as it seems u can get the puller and an impact on it without opening the coolant circuit or touching the fans.

Personally I would go ati 103 and jlt before touching the exhaust...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 12-10-2025, 07:04 AM
Replies: 69
Views: 3,004
Posted By 6spdhyperblue
Is cot turned on? And is it turning on during...

Is cot turned on? And is it turning on during your run?

I would do the ati first then the 103 and big jlt intake. The ati is underrated especially on a manual. These mods will get you to your...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 11-19-2025, 06:07 PM
Replies: 15
Views: 559
Posted By 6spdhyperblue
lol yeah. LT2 enters the chat

lol yeah. LT2 enters the chat
Forum: Dragstrip and Launching Discussion 11-03-2025, 05:54 PM
Replies: 15
Views: 3,412
Posted By 6spdhyperblue
I haven’t gone over 30* even on the most humid...

I haven’t gone over 30* even on the most humid days.

Second

Fueling depends whether you have cats and cot

If you have them it’s all about working the model for cat temp. Keep the cats cool...
Forum: Dragstrip and Launching Discussion 11-02-2025, 07:43 AM
Replies: 8
Views: 3,467
Posted By 6spdhyperblue
These N/A Manual cars need the gearing more than...

These N/A Manual cars need the gearing more than the sidewall. The rear is strong and you shouldn’t be popping the clutch so I never was concerned with the shock. I didn’t have traction problems...
Forum: Dragstrip and Launching Discussion 10-27-2025, 07:22 AM
Replies: 15
Views: 3,412
Posted By 6spdhyperblue
No. Double tap for competition mode. Happy...

No. Double tap for competition mode.

Happy to say I was fine with that nanny on. You never know if you hit coolant or oil and need that level of safety.

I had luck with et street Rs. My choice...
Forum: Tuning / Diagnostics 10-14-2025, 07:20 PM
Replies: 17
Views: 3,910
Posted By 6spdhyperblue
Was there issues with 2016s and this setting?

Was there issues with 2016s and this setting?
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 09-28-2025, 07:02 PM
Replies: 12
Views: 1,676
Posted By 6spdhyperblue
Uh yeah. Headers should have msd wires or similar...

Uh yeah. Headers should have msd wires or similar and booties.
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 09-26-2025, 11:10 AM
Replies: 3
Views: 1,121
Posted By 6spdhyperblue
Yes

Yes
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 09-20-2025, 10:55 AM
Replies: 19
Views: 2,540
Posted By 6spdhyperblue
Mid length fits under the hood?

Mid length fits under the hood?
Forum: Dragstrip and Launching Discussion 09-06-2025, 06:56 AM
Replies: 12
Views: 6,216
Posted By 6spdhyperblue
I can’t believe you guys aren’t running this...

I can’t believe you guys aren’t running this tire?
https://www.mickeythompsontires.com/drag-tires/et-street-r-bias

I ran the tall ones on my fbo car but they were too tall for my power level. I...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 09-02-2025, 07:01 PM
Replies: 7
Views: 1,188
Posted By 6spdhyperblue
Maybe the maf is reading differently with the way...

Maybe the maf is reading differently with the way it flows over the element between the two filters.
The MAP is see things equally.

Not really sure
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 08-31-2025, 01:26 PM
Replies: 3
Views: 1,121
Posted By 6spdhyperblue
delete thanks

delete
Forum: General Automotive + Other Cars Discussion 08-30-2025, 10:16 AM
Replies: 7
Views: 2,374
Posted By 6spdhyperblue
Idk if it’s just me the experience of that car is...

Idk if it’s just me the experience of that car is mainly the sound and feel of a Pontiac engine. 400 428 455 all have very different power bands. Pick your flavor. Just my $0.02
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 07-28-2025, 01:01 PM
Replies: 24
Views: 3,773
Posted By 6spdhyperblue
What does the k and n look like at the maf? Are...

What does the k and n look like at the maf? Are there airflow straighteners like the oem?
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-24-2025, 07:58 PM
Replies: 35
Views: 8,548
Posted By 6spdhyperblue
How did you do it? Did you put the clamp on...

How did you do it?

Did you put the clamp on the rubber then slipped it over the tube?

It’s absurd the amount of stress on the bellow I just put and I still couldn’t get it on. Did you wet it? ...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-24-2025, 02:13 PM
Replies: 35
Views: 8,548
Posted By 6spdhyperblue
I’ll do a chalk test

I’ll do a chalk test
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-24-2025, 02:12 PM
Replies: 35
Views: 8,548
Posted By 6spdhyperblue
I hear ya. In person, the jlt looks like it has...

I hear ya. In person, the jlt looks like it has less of a turn near the tb than the RF. I think the taper on the jlt may give the illusion of more radius from some angles.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-23-2025, 10:28 PM
Replies: 35
Views: 8,548
Posted By 6spdhyperblue
Fitment is good. Rescaled the maf had to do a...

Fitment is good.
Rescaled the maf had to do a multiplier around 1.34 below 5500 hz and roughly 1.31 above on the stock maf curve. running pretty good. I’ll zero it in on a colder night.

I emailed...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-20-2025, 01:31 PM
Replies: 14
Views: 2,221
Posted By 6spdhyperblue
Yeah thinking about it again i made a big...

Yeah thinking about it again i made a big assumption increase in oil pressure in the solenoid brings it makes it retard but it could easily be the opposite
Forum: 2016+ Camaro: 6th Gen Camaro general forum 06-19-2025, 02:39 PM
Replies: 14
Views: 1,359
Posted By 6spdhyperblue
GM accessories is running 25% off right now

GM accessories is running 25% off right now
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-18-2025, 03:21 PM
Replies: 35
Views: 8,548
Posted By 6spdhyperblue
That was the original JLT. This is a new one...

That was the original JLT. This is a new one with a box similar to the rotofab
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-18-2025, 03:10 PM
Replies: 35
Views: 8,548
Posted By 6spdhyperblue
Yes

Yes
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 06-18-2025, 03:07 PM
Replies: 1
Views: 339
Posted By 6spdhyperblue
Delete

delete
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 06-18-2025, 02:40 PM
Replies: 4
Views: 384
Posted By 6spdhyperblue
My caliper is showing a diameter of 152.5mm on...

My caliper is showing a diameter of 152.5mm on the inner part that would slide over the intake tube
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-18-2025, 02:27 PM
Replies: 35
Views: 8,548
Posted By 6spdhyperblue
I just ordered one for a little testing fun

I just ordered one for a little testing fun
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-18-2025, 02:17 PM
Replies: 14
Views: 2,221
Posted By 6spdhyperblue
This is my understanding as well. There is...

This is my understanding as well.

There is no advance the stock cam 0 to 30 or more retarded


The only way it was advanced is if it was ground in. Showing a “+8.5” after the lsa on the cam...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-18-2025, 02:15 PM
Replies: 14
Views: 2,221
Posted By 6spdhyperblue
Did you buy the revised phaser when you did the...

Did you buy the revised phaser when you did the install?

But I thought less oil pressure is retarded and more oil pressure is advanced, so any “weakness” would let it ride on the btr limiter at 4*...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 06-17-2025, 04:33 PM
Replies: 4
Views: 384
Posted By 6spdhyperblue
Bellmouth for rotofab sold

Sold
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 06-15-2025, 07:09 PM
Replies: 2
Views: 648
Posted By 6spdhyperblue
Also cai and tune. Prob a slightly happier dyno...

Also cai and tune. Prob a slightly happier dyno than usual.

I would expect 440rw
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 04:34 PM.

Contact Us - CAMARO6 - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.