Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Griffin Motorsports


Page 1 of 2 1 2
Showing results 1 to 30 of 48
Search took 0.01 seconds. Search: Posts Made By: brosmar1
Forum: Exterior Parts & Accessories 06-29-2025, 12:35 AM
Replies: 1
Views: 983
Posted By brosmar1
SOLD

SOLD
Forum: Exterior Parts & Accessories 06-25-2025, 01:54 PM
Replies: 1
Views: 983
Posted By brosmar1
FS: Sto n Sto SNS89 Removeable Front License Plate Mount

Had on my car for about 3 months, bought a front splitter and now its hangs a bit too close to the ground for my liking. Will work on any non-ZL1 without factory front splitter. Slide mechanism still...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-21-2025, 12:33 AM
Replies: 10
Views: 6,191
Posted By brosmar1
Nice thread. Good idea, turn the bolts out far...

Nice thread. Good idea, turn the bolts out far enough so the pan is still hanging but have room to get a hose in and pump it out. I will definitely be doing it that way next time.

As for the...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-21-2025, 12:29 AM
Replies: 10
Views: 6,191
Posted By brosmar1
There are pressure relief valves for a reason, I...

There are pressure relief valves for a reason, I would much rather be over filled than under filled. You mentioned the Weber Auto video, did you catch the part where he said brake torquing will...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-09-2025, 08:02 PM
Replies: 10
Views: 6,191
Posted By brosmar1
Complete 10L80 Fluid and Filter Change Procedure for 2021 A10 2SS

I consider myself fairly mechanically competent, but this was my first time ever servicing a transmission and I was surprised at the lack of information out there on how to do this job, especially...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-01-2025, 04:58 PM
Replies: 1
Views: 1,551
Posted By brosmar1
Should 10L80 pan gasket be replaced?

Just hit 30k, figured it is about time to change the diff/tranny fluid especially with the A10 "recall". I ordered 8qts Dexron ULV, new filter, and new gasket. I know the service manual says you can...
Forum: Wheels | Tires -- Sponsored by The Tire Rack 03-14-2025, 03:59 PM
Replies: 2
Views: 4,548
Posted By brosmar1
Probably. I've read that the car wants to be no...

Probably. I've read that the car wants to be no more than 3% different front/back. That setup puts you at 3.4%.
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 11-12-2024, 05:43 PM
Replies: 4
Views: 970
Posted By brosmar1
I agree, but I had all the wiring in place...

I agree, but I had all the wiring in place already and wanted to do some experimenting. Layers of security to fall back on is always better!
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 11-10-2024, 03:22 AM
Replies: 4
Views: 970
Posted By brosmar1
This seemed like the most relevant sub to post...

This seemed like the most relevant sub to post this under, please move if it fits better elsewhere.
Forum: Audio, Video, Bluetooth, Nav, Radar, Electronics 11-10-2024, 03:20 AM
Replies: 4
Views: 970
Posted By brosmar1
My attempt at a non-invasive anti-theft system using the engine bay fuse box

So, with all the recent talk about theft, my goal was to create an anti-theft system that will retain my warranty, allow me to easily return the car to stock if needed, and deter theft in some way....
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 09-01-2024, 12:33 PM
Replies: 1
Views: 759
Posted By brosmar1
BUMP Reduced to $75 shipped

BUMP

Reduced to $75 shipped
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 09-01-2024, 12:06 PM
Replies: 6
Views: 2,223
Posted By brosmar1
There are two holes in the stock intake. One for...

There are two holes in the stock intake. One for the PCV vent and one for the sound tube. I believe the rotofabs that keep the sound tube have the sound hole on top, and the PCV hole on the bottom,...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 08-17-2024, 02:40 PM
Replies: 1
Views: 759
Posted By brosmar1
K&N Intake

Switched to a Rotofab. It is the oiled filter version but hasn’t been oiled in ~12k miles. Take note of rust on bottom corner of baffle. Has all required hardware. $100 shipped
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-16-2024, 10:31 PM
Replies: 6
Views: 2,223
Posted By brosmar1
Ok, just found out you can carefully cut the...

Ok, just found out you can carefully cut the nasty hard tubing off of the OEM connectors and plump your own 3/8” hose on it. Now I just need to find a 1/2 NPT 90deg 3/8” barb fitting to replace the...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-16-2024, 08:28 PM
Replies: 6
Views: 2,223
Posted By brosmar1
Here’s what I came up with. Got about 4 ft of...

Here’s what I came up with. Got about 4 ft of Duralast 5/8” heater hose, 5/8” heater hose elbow, and a couple of hose clamps. Plumbed one end directly to the intake nipple in the previous post....
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-16-2024, 07:51 PM
Replies: 6
Views: 2,223
Posted By brosmar1
Not the big gulp. Standard intake for the SS. Ran...

Not the big gulp. Standard intake for the SS. Ran to autozone and I think I’ve got something that’ll work. I’ll post an update in a bit.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 08-16-2024, 06:47 PM
Replies: 6
Views: 2,223
Posted By brosmar1
Help with rotofab install

21 2SS, previous owner installed a K&N intake. The bottom of the baffle was starting to rust and I always hated the way it looked so it was a good excuse to buy a rotofab. Get to installing and...
Forum: Wheels / Tires 09-12-2023, 02:46 PM
Replies: 0
Views: 494
Posted By brosmar1
WTB: ZL1 Tires

Recently picked up a set of OEM ZL1 wheels, looking for tires to mount. Stock ZL1 sizes, preferably in LI/NY area.
Forum: Wheels / Tires 09-10-2023, 12:20 PM
Replies: 3
Views: 898
Posted By brosmar1
Not my thread, but FYI:...

Not my thread, but FYI: https://www.camaro6.com/forums/showthread.php?t=618320
Forum: Wheels / Tires 09-03-2023, 04:07 PM
Replies: 1
Views: 1,281
Posted By brosmar1
SOLD for $400

SOLD for $400
Forum: Wheels / Tires 09-01-2023, 02:59 PM
Replies: 2
Views: 1,161
Posted By brosmar1
Wow! Just bought a set off a forum user with no...

Wow! Just bought a set off a forum user with no tires no TPMS for $2200 and I thought I was getting a deal! GLWS
Forum: Wheels / Tires 08-20-2023, 10:50 PM
Replies: 1
Views: 1,281
Posted By brosmar1
FS: 5th gen black 5 spoke wheels

Bought off a buddy and used as a winter set for a season. Fits fine on a 6th gen SS MRC. Finish is chipped and scuffed and will need at least one new tire. No TPMS.

Front: 245/45ZR20, 8Jx20 ET35...
Forum: Wheels / Tires 08-16-2023, 12:21 AM
Replies: 2
Views: 1,701
Posted By brosmar1
Still available?

Still available?
Forum: Wheels / Tires 08-15-2023, 11:51 PM
Replies: 16
Views: 2,488
Posted By brosmar1
If these fit on the SS I would buy in a heartbeat!

If these fit on the SS I would buy in a heartbeat!
Forum: 2016+ Camaro: 6th Gen Camaro general forum 02-08-2023, 01:53 AM
Replies: 10
Views: 2,845
Posted By brosmar1
Unfortunately the switch acts as a fuse pull, so...

Unfortunately the switch acts as a fuse pull, so when the switch is off the valves are always open. The vacuum actuators GM use open up when they lose power, so going between sport/stealth isn't...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 02-08-2023, 01:49 AM
Replies: 10
Views: 2,845
Posted By brosmar1
When the switch is off, it is the same as pulling...

When the switch is off, it is the same as pulling the fuse so the exhaust valves are always open. When on, it takes whatever mode is selected in the system, I keep it on stealth.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-25-2023, 08:27 PM
Replies: 20
Views: 4,390
Posted By brosmar1
I will admit this is the first time I changed the...

I will admit this is the first time I changed the oil and I dumped all 10 quarts in. Even worse, I jacked the car from the passenger side so there's a good chance there was a bit of old oil still...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-25-2023, 04:51 PM
Replies: 10
Views: 2,845
Posted By brosmar1
Most of the time I’m open valves too, the stock...

Most of the time I’m open valves too, the stock exhaust really isn’t loud enough to be a nuisance. Once there are headers and a cat back system on the car, well that’s a different story.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-25-2023, 02:32 PM
Replies: 20
Views: 4,390
Posted By brosmar1
Agreed, nonetheless thank you all!

Agreed, nonetheless thank you all!
Forum: 2016+ Camaro: 6th Gen Camaro general forum 01-25-2023, 02:30 PM
Replies: 10
Views: 2,845
Posted By brosmar1
DIY NPP Switch

I hated going through 4 different menu screens to change the exhaust level, wasn't ready to commit to pulling the fuse entirely, and didn't want to pay $100 for the Mild2Wild, so here is how I made a...
Showing results 1 to 30 of 48
Page 1 of 2 1 2

 
Forum Jump

All times are GMT -5. The time now is 05:14 AM.

Contact Us - CAMARO6 - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.