Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


AWE Tuning


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.04 seconds. Search: Posts Made By: LiqTenExp
Forum: Wheels / Tires 12-12-2025, 10:44 AM
Replies: 2
Views: 394
Posted By LiqTenExp
Correct

Correct
Forum: Wheels / Tires 12-09-2025, 10:19 PM
Replies: 2
Views: 394
Posted By LiqTenExp
Apex ARC-8 frontd

I have two used Apex ARC-8 for sale. One got scratched and I replaced both. They are in good shape otherwise. Size is 19x11 ET11. Looking for $175 each, normally $484 each.

Pickup in northern NJ.
Forum: ZL1 Discussions 09-24-2025, 08:45 PM
Replies: 8
Views: 614
Posted By LiqTenExp
TPMS Relearn issues with new sensor

Replaced a sensor in drivers side rear tire and cannot get it to learn.

Using OEC-T5 tool, learns driver front, passenger front, passenger rear, and won't learn drivers rear.

Sensor is a HUF...
Forum: ZL1 Discussions 08-30-2025, 08:22 AM
Replies: 11
Views: 776
Posted By LiqTenExp
Have your reviewed your virtual torque tables and...

Have your reviewed your virtual torque tables and made sure they aren't demanding way more than they should be when you have this issue?

I recently had an issue with this where around 4k rpm...
Forum: ZL1 Discussions 06-23-2025, 06:42 PM
Replies: 15
Views: 738
Posted By LiqTenExp
MAT = TMAP temp or IAT relocation temp sensor. It...

MAT = TMAP temp or IAT relocation temp sensor. It disconnects the temp sensor pin on TMAP and relocates it to a remote temp only sensor. TMAP now = Cylinder 2 IAT = MAT

IAT2 = IAT1+ECT math, I...
Forum: ZL1 Discussions 05-12-2025, 06:10 PM
Replies: 30
Views: 1,936
Posted By LiqTenExp
I switched to them ~ 4-5 years ago and am happy...

I switched to them ~ 4-5 years ago and am happy with them.
Forum: ZL1 Discussions 05-05-2025, 06:13 PM
Replies: 28
Views: 1,957
Posted By LiqTenExp
Nothing is available that will hook in 1st or 2nd...

Nothing is available that will hook in 1st or 2nd and 3rd (cool) with that power on the street. Don't get your hopes up.

I ran 555RII for a little (345/30R19) and it was not as sticky at MT ET...
Forum: ZL1 Discussions 04-19-2025, 09:24 PM
Replies: 11
Views: 1,805
Posted By LiqTenExp
You can always hold down accelerator pedal (flood...

You can always hold down accelerator pedal (flood clear mode) and run the starter to build oil pressure after doing an oil change...
Forum: Tuning / Diagnostics 04-09-2025, 08:02 PM
Replies: 19
Views: 8,699
Posted By LiqTenExp
Sent you a PM on my process that solved everything

Sent you a PM on my process that solved everything
Forum: ZL1 Discussions 03-11-2025, 08:02 PM
Replies: 45
Views: 18,972
Posted By LiqTenExp
Didn't someone mention this around post 3.........

Didn't someone mention this around post 3.........
Forum: ZL1 Discussions 03-10-2025, 10:53 AM
Replies: 45
Views: 18,972
Posted By LiqTenExp
Did you fill the lower reservoir to the correct...

Did you fill the lower reservoir to the correct level? If I remember correctly the top is the overflow, not the main reservoir.
Forum: ZL1 Discussions 09-23-2024, 11:32 AM
Replies: 31
Views: 3,099
Posted By LiqTenExp
I would recommend the GM pedal activated voltage...

I would recommend the GM pedal activated voltage version of the JMS. Boost is like a flat curve on the PD blower cars and it allows it to ramp up only as much as needed instead of just going flat out...
Forum: ZL1 Discussions 09-12-2024, 01:08 PM
Replies: 38
Views: 4,555
Posted By LiqTenExp
I avoid the catch can and just use a gently spray...

I avoid the catch can and just use a gently spray of water/meth to keep the whole upper engine clean
Forum: ZL1 Discussions 09-12-2024, 10:22 AM
Replies: 38
Views: 4,555
Posted By LiqTenExp
That catch can breather depends on the lines...

That catch can breather depends on the lines going to it to be able to manage the volume of air in the crank case. Catch cans and their long small diameter hoses likely offer much more restriction...
Forum: ZL1 Discussions 09-12-2024, 09:47 AM
Replies: 38
Views: 4,555
Posted By LiqTenExp
I don't bother with catch cans. I blew out my...

I don't bother with catch cans. I blew out my rear and front seals over a couple events. Both returned to normal and continue to not leak after the event luckily. The vent line on the air intake...
Forum: ZL1 Discussions 07-26-2024, 05:47 PM
Replies: 18
Views: 2,431
Posted By LiqTenExp
When i see something like negative timing at idle...

When i see something like negative timing at idle I would probably get fueling ok and then go look at zero pedal torque as compared to delivered engine torque. If you see negative timing your engine...
Forum: ZL1 Discussions 07-26-2024, 10:41 AM
Replies: 18
Views: 2,431
Posted By LiqTenExp
zero pedal torque at idle needs to be positive,...

zero pedal torque at idle needs to be positive, recommend 0 to 10°, i usually run it around 5°
Forum: USA - NY / NJ / PA 07-20-2024, 06:26 AM
Replies: 2
Views: 2,314
Posted By LiqTenExp
Tune Time in Lakewood, NJ

Tune Time in Lakewood, NJ
Forum: ZL1 Discussions 07-13-2024, 07:51 PM
Replies: 10
Views: 1,220
Posted By LiqTenExp
What were you engine oil temps at the time?

What were you engine oil temps at the time?
Forum: ZL1 Discussions 07-10-2024, 12:12 PM
Replies: 1
Views: 1,151
Posted By LiqTenExp
Maybe this?: ...

Maybe this?:
https://www.camaro6.com/forums/showthread.php?t=597239
Forum: ZL1 Discussions 06-03-2024, 06:59 AM
Replies: 59
Views: 7,151
Posted By LiqTenExp
Depends on how you are using it. If you are using...

Depends on how you are using it. If you are using it as a fuel system then I agree.

If you are using it to cool the intake charge, get a little more octane, and run a few more degrees of timing...
Forum: USA - NY / NJ / PA 03-31-2024, 11:12 AM
Replies: 2
Views: 3,154
Posted By LiqTenExp
Where in NJ are you. Tune Time Performance is in...

Where in NJ are you. Tune Time Performance is in Lakewood, you could check them out.
Forum: ZL1 Discussions 12-05-2023, 07:16 PM
Replies: 59
Views: 14,825
Posted By LiqTenExp
I'm running the 2 gallon fender tank with...

I'm running the 2 gallon fender tank with magnuson capped tank. Just consider suction/pressure side of the pump and how it will fill the system.
...
Forum: ZL1 Discussions 12-02-2023, 11:01 AM
Replies: 1
Views: 1,100
Posted By LiqTenExp
M6x0.8mm

M6x0.8mm
Forum: ZL1 Discussions 11-20-2023, 07:36 PM
Replies: 1
Views: 1,100
Posted By LiqTenExp
Missing bolt, lol

Looking for the bolt that holds the ZL1 manual transmission cooling lines up the right hand side of the engine. There are two line coupled together at this point and my bolt has gone missing... I...
Forum: ZL1 Discussions 11-12-2023, 05:47 PM
Replies: 8
Views: 976
Posted By LiqTenExp
I've got 345/30R19 Nitto 555RII on there now with...

I've got 345/30R19 Nitto 555RII on there now with 305/30R19 PS4S on the front. PS4S don't come in 345 but 355/30R19, OMG are they expensive! ($719 each)
Forum: ZL1 Discussions 11-11-2023, 05:12 PM
Replies: 8
Views: 976
Posted By LiqTenExp
Yes, we obviously didn't test it on anything with...

Yes, we obviously didn't test it on anything with a crown.
Forum: ZL1 Discussions 11-11-2023, 11:46 AM
Replies: 8
Views: 976
Posted By LiqTenExp
Yeah, that was my plan next. I actually need new...

Yeah, that was my plan next. I actually need new rears so it might be the plan for next year.
Forum: ZL1 Discussions 11-11-2023, 09:53 AM
Replies: 8
Views: 976
Posted By LiqTenExp
Pulling to the right

Have an issues with the car pulling to the right. Spent hours working with a great shop in Clifton and we ran out of time. Front suspension is completely stock. Rear is all BMR non-adjustable except...
Forum: ZL1 Discussions 10-31-2023, 06:49 AM
Replies: 97
Views: 27,871
Posted By LiqTenExp
Glad it worked out. Mine is still humming away 3+...

Glad it worked out. Mine is still humming away 3+ years later.
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 07:43 PM.

Contact Us - CAMARO6 - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.