Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Phastek Performance


Page 1 of 15 1 234511 Last »
Showing results 1 to 30 of 423
Search took 0.03 seconds. Search: Posts Made By: turbojeep95
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 10-19-2025, 05:41 PM
Replies: 3
Views: 389
Posted By turbojeep95
No but I plan on it.

No but I plan on it.
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 10-19-2025, 03:07 PM
Replies: 3
Views: 389
Posted By turbojeep95
Replacing primary cats with electric cutouts

Been trying to find information regarding putting a set of cutouts in place of the primary cats while keeping the secondary cats with the rest of my factory npp exhaust. Haven't seen this done yet...
Forum: Suspension | Brakes | Chassis 01-11-2025, 10:06 AM
Replies: 19
Views: 9,128
Posted By turbojeep95
I have a 22 LT1 with the california compliant z51...

I have a 22 LT1 with the california compliant z51 calipers. Your right the lack of airflow makes these brakes totally lacking on track days so I did use the same ducting you purchased. Takes a...
Forum: Member Car Journals 11-16-2024, 09:28 AM
Replies: 72
Views: 33,292
Posted By turbojeep95
It was probably the hot tune I had in it which...

It was probably the hot tune I had in it which resulted in a cracked piston skirt. It was in the process of being tuned and it had a bad stumble during acceleration we were working on and I'm...
Forum: Member Car Journals 07-22-2024, 10:14 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Found a set of side skirts off amazon for $100 to...

Found a set of side skirts off amazon for $100 to try out. They look good out of the box but don't really sit flush with the rocker panel of the car. In their defense I used double sided 3m tape on...
Forum: Member Car Journals 07-22-2024, 10:09 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Installed some pinch weld lift pads off amazon...

Installed some pinch weld lift pads off amazon for about $25. Bolted on in about 15 min and now I don't know how I got by without em. Hopefully this will keep the inspection station from crushing...
Forum: 6th gen Camaro 1LE 07-08-2024, 12:14 AM
Replies: 23
Views: 11,914
Posted By turbojeep95
Sorry to resurrect an old thread but looking to...

Sorry to resurrect an old thread but looking to get a quick question answered. Just picked up a set of C7 Z06 front flares and wanted to know if the secondary lip and the extra plastic brackets gets...
Forum: Member Car Journals 06-20-2024, 10:40 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Here's a photo dump for some early summer events....

Here's a photo dump for some early summer events. PittRace SCCA TNIA, drag night at Quaker City Motorsports Park and an ice cream run to Jerry's with the doggo's.

https://i.imgur.com/iwDZLeD.jpg...
Forum: Member Car Journals 06-20-2024, 10:31 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Thanks RallyRunner! The LT1 is a great platform...

Thanks RallyRunner! The LT1 is a great platform and a great place to start with modding. The brakes are definitely the weak link with this trim level, mostly in regards to the rear calipers for...
Forum: Member Car Journals 05-26-2024, 01:56 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Still running the stock rears. I noticed there...

Still running the stock rears. I noticed there is a very slight change when on the track. The new front BMR springs help the car rotate a little better through the turns.
Forum: Member Car Journals 05-21-2024, 10:53 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Finally got to install the brake deflector kits...

Finally got to install the brake deflector kits on the car this spring. The back kit is off of a cadillac blackwing car and just bolted up to the rear control arms with 3 bolts and a spacer. Only...
Forum: Suspension | Brakes | Chassis 05-11-2024, 09:06 AM
Replies: 6
Views: 2,419
Posted By turbojeep95
Try this part number, 85529064. Looks like those...

Try this part number, 85529064. Looks like those are SS pads. You want the corvette z51 brake package pads.
Forum: Suspension | Brakes | Chassis 02-04-2024, 02:47 PM
Replies: 6
Views: 2,419
Posted By turbojeep95
You have the california compliant brake calipers....

You have the california compliant brake calipers. They are 4 piston brembos but get one's that fit a c8 corvette with the z51 package. I pulled these off rock auto so they should give you a good...
Forum: I4 Turbo LTG Engine, Exhaust, and Bolt-Ons 02-04-2024, 09:36 AM
Replies: 6
Views: 9,556
Posted By turbojeep95
I loved my 2.0t but your pretty much capped out...

I loved my 2.0t but your pretty much capped out at 300-350hp unless you wanna spend a bunch and build a motor. Its drives way lighter and is spunkier than my v8 and is a blast to drive tuned. Also,...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 02-04-2024, 09:27 AM
Replies: 20
Views: 3,451
Posted By turbojeep95
Had the same issue with my LT1 on the track. ...

Had the same issue with my LT1 on the track. Those stock California compliant low copper pads get chewed up pretty quick. When looking for front pads try searching for the Corvette C8 z51 pads. ...
Forum: USA - NY / NJ / PA 01-07-2024, 02:59 PM
Replies: 4
Views: 2,322
Posted By turbojeep95
I did my free oil change at Wright Chevrolet in...

I did my free oil change at Wright Chevrolet in Ambridge.
Forum: 6th gen Camaro vs... 07-16-2023, 10:31 PM
Replies: 12
Views: 2,722
Posted By turbojeep95
My buddy has the M4 CS and it's fast. My LT1 can...

My buddy has the M4 CS and it's fast. My LT1 can get close on the track but he has it tuned and slowly pulls on the straights.
Forum: Member Car Journals 07-16-2023, 10:25 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Just installed the BMR 3/4" front lowering...

Just installed the BMR 3/4" front lowering springs to try and narrow that front wheel gap. Was worried the front gap would be too small but mirrors the rear wheel well gap with the 315's. Took me...
Forum: Member Car Journals 07-01-2023, 12:04 AM
Replies: 89
Views: 35,499
Posted By turbojeep95
https://i.imgur.com/c8pCAYf.jpg ...

https://i.imgur.com/c8pCAYf.jpg

https://i.imgur.com/3H1iuIm.jpg

https://i.imgur.com/LnTmO9r.jpg
Forum: Member Car Journals 07-01-2023, 12:02 AM
Replies: 89
Views: 35,499
Posted By turbojeep95
So I think I found a brake pad combo that works...

So I think I found a brake pad combo that works well with the LT1 brake setup. The Hawk dtc60's up front with a set of Dynamic Friction rear pads have yet to give me any problems other than some...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 06-13-2023, 09:27 PM
Replies: 23
Views: 6,780
Posted By turbojeep95
Please take my money!!!:thumbup: Are you...

Please take my money!!!:thumbup:

Are you going to be making any of these for sale? I'm super interested.
Forum: Wheels | Tires -- Sponsored by The Tire Rack 05-30-2023, 08:58 PM
Replies: 4
Views: 6,733
Posted By turbojeep95
Federal Atturo AZ850 tire review

Picked up these Atturo AZ850's for a little over $600 a set. Rears are 315-30r20's and the fronts are 285-30r20's. (I tried to get as close to the 1le sizes since my khumo 295-35r20's rubbed too...
Forum: Member Car Journals 05-21-2023, 09:55 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Nice car! Did you end up doing any work to the...

Nice car! Did you end up doing any work to the brakes for track operations?
Forum: Member Car Journals 05-20-2023, 08:48 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Did some work to the front brakes last night to...

Did some work to the front brakes last night to try and ready the car for an SCCA event at PittRace this thursday. Been having a strong vibration under heavy braking at the track and thought a...
Forum: Photos | Videos | Renderings 05-20-2023, 08:30 PM
Replies: 372
Views: 156,378
Posted By turbojeep95
Those 1le's just look right straight from the...

Those 1le's just look right straight from the factory!
Forum: Member Car Journals 05-11-2023, 08:30 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
I might consider a 35 series tire up front next...

I might consider a 35 series tire up front next time to fill in that wheel gap.

https://i.imgur.com/1L9x59E.jpg
Forum: Member Car Journals 05-11-2023, 08:28 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Threw the summer tires on yesterday. Right now $...

Threw the summer tires on yesterday. Right now $ is a little tight and I wasn't too happy with the Khumo Ecsta tires I had so took a chance with the Atturo AZ850's. The dodge guys seem to like them...
Forum: Cosmetic modifications (exterior and interior) 05-03-2023, 08:44 PM
Replies: 8
Views: 1,991
Posted By turbojeep95
I got the same ebay splitter and I like it a lot....

I got the same ebay splitter and I like it a lot. Finally some bolt on parts are coming in that don't cost $400.

https://i.imgur.com/CpxKgHI.jpg

https://i.imgur.com/IzhVkv4.jpg
Forum: Member Car Journals 04-19-2023, 10:39 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
Threw the new couplings on today after work and...

Threw the new couplings on today after work and it made this kit fit sooo much better. Ended up just using the 45* coupling and had plenty left over for the second coupling for the air box...
Forum: Member Car Journals 04-19-2023, 10:34 PM
Replies: 89
Views: 35,499
Posted By turbojeep95
I'll get on it! I should have some and hope I...

I'll get on it! I should have some and hope I don't need to buy a new jug.
Showing results 1 to 30 of 423
Page 1 of 15 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 01:28 PM.

Contact Us - CAMARO6 - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.