CAMARO6

CAMARO6 (https://www.camaro6.com/forums/index.php)
-   V8 LT1 Engine, Exhaust, and Bolt-Ons (https://www.camaro6.com/forums/forumdisplay.php?f=231)
-   -   Made a new soundtube delete firewall plug. (https://www.camaro6.com/forums/showthread.php?t=554511)

bignaz 05-16-2019 10:56 AM

Made a new soundtube delete firewall plug.
 
2 Attachment(s)
Decided to remake the plug. Didn't spend any time cleaning it up. But o ring sealed. I'm going to remake one in black and actually spend more the. 5 minutes on it.


I scraped the plans to sell these. Please do not ask.

CamaroVille 05-16-2019 11:24 AM

Nice work! How did you make that? Looks great. You interested in making and selling a plug to fit the stock opening on the intake tube? I'd like to remove my soundtube and already have the firewall plug that is used on the 4 cylinder engines.

bignaz 05-16-2019 12:31 PM

Just 3D printed on a SLA printer. I could make a plug that would voce the stock intake hole just pm me. I gotta grab my stock intake and take some measurements and make a plug for that

biker2k 05-16-2019 01:08 PM

I’d buy one of those even if I had to paint it black

bignaz 05-16-2019 01:32 PM

I got a ton of colors of resin. Just trying to burn up the last of this gray that's been sitting out for months before I put some fresh resin in.


Going to do a few small tweaks in the design and make another one.

bignaz 05-16-2019 05:39 PM

1 Attachment(s)
New one. I'll do this tomorrow and this time i'll print it right. Back and front will be smooth. Kinda just threw the first one into it.

appleman22 05-16-2019 05:44 PM

I would be very interested in purchasing a set of the fire wall plug and the intake plug

bignaz 05-16-2019 06:57 PM

1 Attachment(s)
I'll see what I can do. Working up an intake plug right now. I got an idea for it. Instead of a cap it will be a plug. I'll work on it this weekend should have one done on Monday.


I'll let you guys know. Until then enjoy some tiny printing


Gotta test out some new black resin and new modded vats for it.

bignaz 05-17-2019 12:51 PM

4 Attachment(s)
Just broke the supports off. Didn't do any clean up. If enough people want a kit I'll consider doing a run of kits.

bignaz 05-17-2019 01:59 PM

2 Attachment(s)
Close up of the o ring seal. Didn't have the right diameter on hand. But going to change the angle of it when I print it to improve the surface finish so it's smooth like the gray one.

Mick0311 05-18-2019 11:29 AM

Depending on cost, I'm in for a black set.

biker2k 05-18-2019 09:27 PM

im in

BruceWayne1LE 05-18-2019 11:11 PM

I want

JCunningham 05-19-2019 02:05 AM

do the Camaro SS script in red.


All times are GMT -5. The time now is 04:30 PM.

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.