Front bumper protection
 

Has anyone ever seen this product? https://store.proxel.com/en/products...nt-detail.html
Looks good to me!

I just ordered something similar after reading your post.
I need something to help my resident front splitter destroyer (AKA my wife) LOL!
https://www.ebay.com/itm/332318012698
I like that this appears to be a no drilling, splicing or cutting solution. This one has its own independent visual and audio sensor that I think I can integrate into the dash. If it doesn't work out it was only $17.

Thanks for the link Mcardenal! I am thinking the same way, but with this unit, https://www.ebay.com/itm/182974354816. If this unit will work with say 3 of the 4 sensors, 1 for the center and 1 for left and 1 for the right about 3 feet across mounted under the front spoiler to pick up curbs and cement blocks.

But I am not sure if this unit will work on just 3 or then 4 and space them closer in the 3 feet.

But maybe the 1 you ordered could be better as with the tape strip could it be attached below the Camaro spoiler and not in the bumper as I don't want to remove the front bumper, what do you think?

Thanks
Christopher

I think the sensors you are looking at are more accurate but I don’t want to cut holes on my bumper. I agree that I don’t want to take off the bumper for the tape sensor either. Once it arrives I will see if there is a way to get it done without removal.
I was thinking maybe below the front splitter as well.? I’ll let you know how it goes.

Regards,

Martin

Martin, did you get that unit or installed it? I ordered that 1 with the 4 sensors and I was told that it will work with 1 or 2 sensors so my plan is to connect 1 or 2 and place them under the front grill, and would like them to be out of site as well.

Thanks
Christopher