Wiring question
1 Attachment(s)
I have a 2018 2SS redline and I was doing a cleaning of the engine bay and I noticed a wired had been chewed by a mouse.
Can anyone tell me what this wire is Photo attached Thank you in advance |
Can you do a closer photo?
Looks like 2 wires. I think maybe connection to evap canister purge solenoid valve. |
Hard to tell from that photo being so far away...get a pic closer in, might help others id that
|
Quote:
|
1 Attachment(s)
It’s two blue wires into a black plug but I couldn’t release it very hard to get at as it sits under intake manifold. I was able to wrap it with electrical tape just wondering what wires were for if I run into any issues
Photo attached pointing wire out |
Definitely the evap solenoid valve. If you wrapped it and you're not getting a CEL, I figure you're good to go...
|
Hit with a dap of solder if the wires are damaged then wrap it in shrink wrap tubing and heat seal to keep from corroding. Wish they would get rid of soy based sheathing. Permatex even makes a liquid electrical tape if hard to reach.
|
I don't know how he'd get heat shrink around that without disassembling the connector.
I would do electrical tape with a cable tie around it to keep the tape from unraveling. Kind of a warm area there. Since he took manifold off for "cleaning the engine bay," I would assume he will do the same every so often and can replace the zip tie if it cracks. |
Quote:
It's hard for me to see anything. Maybe that's just me. |
1 Attachment(s)
Quote:
|
Mine was the same way, I wrapped it in electrical tape. The foam padding near it also looked like a piece was ripped out.
|
Quote:
|
All times are GMT -5. The time now is 01:55 AM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.