BEST BOOST GAUGE
 

Hey guys!

What is your go too boost gauge? I’m torn between the one from P3 Gauges, which goes into the driver side air vent, or Aeroforce Technology which is less stealthy, but looks cool! Just curious as to which you like more and/or why? Or if you are using a different setup, let me know!
:headbang:

this is open for debate. Personally I have the P3 and does exactly what I need it to do. I don't buy for flashy, but this one just so happened to fit nicly into the vent area. I don't like clutter so others were out for me.

There is one other thread that is discussing a change to the stock dash to show the boost gauge like the zl1. If that doesn’t progress soon, I will order the P3.

I ended up going with the AEM wideband fail safe gauge which I like very much. I was between the nGauge and the P3 though as well, both very good choices.

http://www.camaro6.com/forums/showthread.php?t=473703

A similar topic was brought up. It’s like ten threads down. Just gotta look around and search the forum a little!

Oh I searched the forum a lot, actually! Haha too much! Just looking for some fresh thoughts!:thumb:

One that works :D

Duh...:emoticon1::bonk:

P3 gauge with analog boost sensor.

Dose a scan gauge read boost? i know it reads vacuum but was curious if your boosted will it read up above negative so you would not need a sensor. I just remember on my old turbo car it would not read Vacuum.

I use Torque app on my Android phone. Having many boost gauges over time, the novelty wears off and you may begin to wish it wasn't staring back at you all the time.

The Torque app lets me monitor what I want, when I want and put it away when I'm done.

I'm a fan of anolog gauges. Anybody know of one that fits the depth of the aero force dual pod? 2.5 inches deep isn't much when you factor in the plumbing fittings ect.

doesnt fit. i have a analog autometer gauge that sticks out about a 1/2 inch.

Does the AEM wideband fail safe gauge show boost?