CAMARO6

CAMARO6 (https://www.camaro6.com/forums/index.php)
-   ZL1 Discussions (https://www.camaro6.com/forums/forumdisplay.php?f=235)
-   -   AWE axleback and smoked reflector install (https://www.camaro6.com/forums/showthread.php?t=575827)

CW3SF 05-24-2020 11:00 PM

Quote:

Originally Posted by Terry the Tramp (Post 10796971)
CW3SF - The fuse you pulled, please advise which it is and where it's located.
Thanks.

The Exhaust valve fuse (#51 I believe) under the hood. Without the fuse pulled and the exhaust in track mode the valves still close down slightly. With the fuse pulled the valves are wide open all the time. Ran mine that way since the car was new and never had a single issue from it.

ScottMZ3 05-25-2020 01:29 PM

Quote:

Originally Posted by CW3SF (Post 10795044)
These reflector screws were insanely difficult to R&R, even with the suitcase out of the way. I can’t imagine doing that job with it in place.

https://www.camaro6.com/forums/pictu...ctureid=165424


Yeah, those reflectors were a HUGE PITA. I managed to replace both sides after my AWE was in place. Took me a good hour, several cuts on my hands, a sore back, neck, and head...but I did it. :mad0259::happyanim:

Hell Raiser 05-25-2020 11:16 PM

I give up on replacing them . Taken off the rear clip would be easier but not my cup of tea.
I will save them for another day in the future.


All times are GMT -5. The time now is 10:05 PM.

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.