PfadtRacing

hey guys thanks for all of the comments. Sorry I just started paying attention to this area!

Very high quality materials and workmanship as far as i can see.(rebuilt j79 &j52 jet engines in my time in usmc as a jet mech) And the quality is the same.

Just had the Pfadt coilovers installed 6-4-10 along with my Pfadt arsenal that i already have such as ,racing motor mounts, trust me guys once these motor mounts break in you will be soooo happy, front and rear sway bars( racing type) strut stiffers and more on the way. This coilover setup is awesome. I had dynotuned performance install and i am happy. Running 573 at the rw and all Pfadt stuff hangs in there

interested in F&R What about lowering how hard is it to lower the car and add the sway bars
How much for both as package Deal

Are there any instructions available for the engine mounts? How big of a project will that end up being? Also, how far out are we from the differential bushings and transmission mounts?
Thanks

HI Jordan.Am looking to fit a set of lowering springs to my 1ss,want to lower by 1.5" and mate them up to some 22" rims.Do you foresee any probs or are they a straightforward replacement and at what cost?Thanks in advance

Jordan is this a hollow tube bar, could you tell me the rate increase over stock, what% of f to r balance does this bar create