Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
Go Back   CAMARO6 > CamaroCracka

AWE Tuning

Conversation Between CamaroCracka and Thomas Godwin
Showing Visitor Messages 1 to 2 of 2
  1. CamaroCracka
    04-20-2023 06:47 AM
    just like you would put a cutout on the exhaust in the old days for when you went racing, I put an electric cutout on the downpipe to reduce backpressure. It's about halfway down the DP and exits right in front of the crossmember. It's only 2.5" which is a bit smaller than the downpipe, but it allows some of the flow out before it takes that harsh bend around the AC compressor. I also cleaned up the ends of ON3s piping because they left a lot of exposed pipe that could catch air and with the turbine being a restriction, I wanted to make everything else flow as smooth as possible.

    I run QTP cutouts. You can search that to see what the various electric cutouts look like.
  2. Thomas Godwin
    04-19-2023 04:29 PM
    Thomas Godwin
    Excuse me for being a little confused, when you say downpipe cutout, what exactly does that mean?

All times are GMT -5. The time now is 10:18 PM.

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.