I Need Help!!

[2010SSRSM6]

Hang a tennis ball from the roof and have it bounce off the windshield when it's time to stop.




Sent from my iPhone using Tapatalk

[Les7311]

..."so as to not hit the wall..."

How about get a tennis ball and a string
After car in garage properly, puncture ball and tie string through it
Suspend string from ceiling to float on windshield...
...cost? Free!!

[TripleB]

Originally Posted by Les7311

..."so as to not hit the wall..."

How about get a tennis ball and a string
After car in garage properly, puncture ball and tie string through it
Suspend string from ceiling to float on windshield...
...cost? Free!!

I was gonna do that or hang it from the shelf close to the wall. Was just searching cause I was curious to see if I could use those stops to give me clearance if I turned them sideways. Found that, essentially rubber speed bump, and thought it would work for clearance issues better.

[TripleB]

Ouch. Thought I got in the garage more last time. :( oh well. Tomorrow I shall fix the issue!

[Les7311]

Where is the DIY ramp?

I would back-in instead. ..

[Les7311]

Originally Posted by Les7311

Where is the DIY ramp?

I would back-in instead. ..

here's mine..About 10 ft long..

[TripleB]

Heading to Home Depot for some stuff tomorrow and gonna get some wood to build mine.

[2010SSRSM6]

It looks like it's your cross brace under the h-pipe that is dragging. You shoud be good with about a 1" lip. Just make sure you can get lift off the front end and still keep the boards inside the garage. It doesn't look like you are getting to far past the point where the door closes before you are dragging. If you can't get enough lift, you will need to adjust the point your door closes so you can put the boards farther forward (closer to the curb).

[TripleB]

yeah, i thought i was able to get inside the garage a bit more...i probably can, but i stopped short so i could see where to start the wood or whatever i use.

i didn't get anything yet. too much to do around the house still unpacking and what not before i can work on that. going back to work wednesday too. probably won't be able to do anything until this weekend about the garage. oh well.

[2010SSRSM6]

Originally Posted by TripleB

yeah, i thought i was able to get inside the garage a bit more...i probably can, but i stopped short so i could see where to start the wood or whatever i use.

i didn't get anything yet. too much to do around the house still unpacking and what not before i can work on that. going back to work wednesday too. probably won't be able to do anything until this weekend about the garage. oh well.

Keep us posted when you get it figured out.

[TripleB]

so i have like a billion boxes from moving sitting in the garage because i can't recycle them all in one week..lol. decided i'd play some trial and error and see if boxes would work. they semi-did, but i'm gonna get wood so it's a bit stronger. got the length and width and all that down now though.

[2010SSRSM6]

That's a sweet recycling program you worked out over there. lol. Glad it worked out.


Sent from my iPhone using Tapatalk

[Les7311]

Way to go....Now the plan is in motion...

[Speed2acer]

ever try coming at it at a slight angle? might work i used to have the same problem with my Vette when I lived in Lake Arrowhead