05-26-2013, 09:26 PM | #43 |
ITZ COOL
|
Has anyone run the crossover wires into the interior door pocket, next to the speaker. Looks like a better place, safe, dry and accessible. I am going to give it a go tomorrow.
|
05-26-2013, 09:43 PM | #44 |
Drives: 2014 Blue Ray Met. Camaro 1SS Vert Join Date: Feb 2012
Location: Indiana
Posts: 1,519
|
So what do you guys think of the Kicker DS mid & tweeter since the install? How do they sound?
|
05-31-2013, 01:39 PM | #45 |
Drives: 2ss/rs vr 6m Join Date: Mar 2009
Location: New Port Richey,fl
Posts: 2,831
|
Here is a pic of where I mounted my crossover.
On the bottom right. |
08-30-2013, 10:33 PM | #46 |
Drives: 2010 lt/rs Join Date: Sep 2011
Location: Pottstown, PA
Posts: 16
|
any pics of what this looks like with the panels on? and does crutchfield sell the adpaters for the speakers by them selfs?
Id like to make my own, but id need subtumps measurement or crutchfield to base off of |
08-31-2013, 08:45 AM | #47 |
Drives: 2010 Camaro 2SS/RS RJT, 6speed Join Date: May 2011
Location: South Florida
Posts: 887
|
If getting the metra adapters, they don't fit the JL c2 650 speakers. Just a heads up.
Gotta use the ******** ones.
__________________
2010 Camaro 2SS/RS, LS3 - 6 speed. Mods, Magnaflow exhaust with resonator delete. ******** 12" stealth box subwoofer kit, Kicker 400 mono amp, JL XD 400/4 amp.
|
09-01-2013, 06:20 PM | #48 |
Drives: 2010 Chevrolet Camaro SS/RS Join Date: Apr 2011
Location: Norton Shores
Posts: 209
|
Just used this to install my speakers. Thanks!
|
09-03-2013, 07:58 PM | #49 | |
Drives: 2016 Corvette Stingray Z51 Join Date: Feb 2013
Location: St. Louis, Missouri
Posts: 184
|
Quote:
__________________
2016 2LT Corvette Stingray Z51 7MT:
Torch Red, Adrenaline Red/Black interior, Nav, PDR, black wheels, Carbon Flash trim. Current mods: Permagrin! |
|
09-03-2013, 09:09 PM | #50 |
My Dream Car
Drives: 2011 SIM LS3 1SS Join Date: Jul 2009
Location: staten island
Posts: 1,534
|
.
|
09-03-2013, 09:50 PM | #51 |
Drives: 2ss/rs vr 6m Join Date: Mar 2009
Location: New Port Richey,fl
Posts: 2,831
|
I went underneath with it and its completely dry there.
I left the selector in the middle. Good luck! |
09-03-2013, 11:16 PM | #52 |
Got mine!
Drives: 2021 LT1 RS - Orange Crush Join Date: Mar 2011
Location: Fallbrook, CA
Posts: 1,300
|
no immediate plans to change out my BA speakers but will some day... Great write up. I wonder if those kicker speakers are better than the BA set up?
__________________
Camaro lover since 1984 when I got my first car a 1978 Camaro LT with a 2 barrel carb on 305 V8... yes I put in a 350 with a 4 barrel.
|
09-04-2013, 10:20 AM | #53 |
Drives: 2016 Corvette Stingray Z51 Join Date: Feb 2013
Location: St. Louis, Missouri
Posts: 184
|
Thanks Chris. I got the passenger side installed but ran out of time last night. Will finish up driver side tonight. I mounted the crossover in the same place you did. I did test the speaker connections and the JLs on the passenger side were quieter than the stock driver side - especially 6.5" speaker. I'm concerned that I may have not connected properly. I used the light green and dark green wires that the old speaker were connected to. Didn't sound like much bass was coming out of the new speaker. Did you notice that you had to turn up the front fade or overall volume after your install? Any thoughts? Thanks!
__________________
2016 2LT Corvette Stingray Z51 7MT:
Torch Red, Adrenaline Red/Black interior, Nav, PDR, black wheels, Carbon Flash trim. Current mods: Permagrin! |
09-04-2013, 01:03 PM | #54 |
Drives: 2ss/rs vr 6m Join Date: Mar 2009
Location: New Port Richey,fl
Posts: 2,831
|
Here's the skematic for the speakers. Check to make sure it wired right. Take the factory wires, L-Gr(+) & D-Gr(-) to the crossover, then from the crossover to the woofer and same with the tweeter, from the crossover to the tweet.
Hope that makes cense or helps |
09-04-2013, 01:12 PM | #55 |
Drives: 2ss/rs vr 6m Join Date: Mar 2009
Location: New Port Richey,fl
Posts: 2,831
|
The sound difference might also be that the JL speakers are 4ohm and I think the Boston speakers are 2ohm.
|
09-04-2013, 01:28 PM | #56 |
Drives: 2016 Corvette Stingray Z51 Join Date: Feb 2013
Location: St. Louis, Missouri
Posts: 184
|
I wired it correctly then. I'll do another comparison after I get the driver side in tonight hopefully. Impendence could be the difference. Thanks again!
__________________
2016 2LT Corvette Stingray Z51 7MT:
Torch Red, Adrenaline Red/Black interior, Nav, PDR, black wheels, Carbon Flash trim. Current mods: Permagrin! |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY: How to Change the Door Speakers | RandyB | Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum | 15 | 04-26-2014 10:53 PM |
Front door speakers with boston sound system need new amp and speakers per gm. | camaross14 | Camaro Issues / Problems | Warranty Discussions | TSB and Recalls | 66 | 06-30-2011 11:16 PM |
DIY Help Installing front GFX, Rocker panels, andsplash Guards | 5th_GEN_SS | Camaro DIY & HOW-TO instructions & discussions | 8 | 04-12-2010 10:03 AM |
Blown front speakers | Chevyg1rl | 4th Generation Camaros | 16 | 03-26-2010 03:56 PM |