04-13-2014, 04:28 AM | #1 |
Drives: 2012 45th 2LT RS Join Date: May 2011
Location: Chico, California
Posts: 1,002
|
Door projector lights from AAC issue
So i noticed that the projection on the ground is changing in it's look and i'm guessing it has to do something with the bulb burning out. I have the wires connected where they are supposed to be, but the light is still on when i am driving my car, causing the bulb to burn much faster... How can i change this?
I can see the light shining down by my seat when i shut the doors and start driving.
__________________
|
04-13-2014, 07:42 AM | #2 |
Drives: 2010 IOM Camaro Join Date: Aug 2012
Location: DFW
Posts: 3,112
|
Put it on a toggle switch.
|
04-15-2014, 03:02 AM | #3 |
Drives: 2012 45th 2LT RS Join Date: May 2011
Location: Chico, California
Posts: 1,002
|
i guess it's a little late now, the projection is hardly readable. Damn AAC
__________________
|
04-15-2014, 04:42 PM | #4 |
Drives: 2011 2SS/RS (M6) 427 Twin Turbo Join Date: May 2008
Location: NJ
Posts: 1,090
|
You should hook it up too the dome light next time so its only on when the dome lights are on
__________________
2011 Camaro 2SS/RS ERL 427 M6 TT -AGP Twin Turbo 55/57 .83ar | ERL 427ci | Squash Fuel System | Stainless Works Chambered 3" | Mcleod RXT | Factory Hurst Short Throw | Black Forgestar F14s | CTS V 6 Piston Brembo | VIS AMS Carbon Fiber Hood | Anvil Carbon Fiber Spoiler |
04-15-2014, 07:14 PM | #5 |
Drives: '14 SIM 2LT/RS Vert Join Date: Aug 2010
Location: Concord, NC
Posts: 1,412
|
That's how I have mine wired.
__________________
|
04-19-2014, 12:16 PM | #6 |
I have mine connected to the door pin switch. It's a Red/White strip pos, Gray/Blk Neg.. I tested it with the door panel off and open and close of the door and it does turn off with the door closed.
|
|
|
|
|
|